Observation of intensity, phase, or polarization properties of light propagating through telecom submarine cables can enable widespread monitoring of geological and undersea events, such as earthquakes, tsunamis, and shipping lane traffic. We conducted a comparative analysis of external physical perturbations acting on submarine optical cables and unprotected optical fibers; introduced both intensity and phase demodulation-based sensing systems for long-distance vibration sensing; presented an extension to the phase-spectrum time delay method for forward-transmission distributed sensing (same as optical communications) to distinguish and quantify multiple simultaneous vibration events; and overcame the previous spatial resolution fundamental lower limit set by the time-domain sampling rate. We experimentally demonstrated multi-vibration positioning over 202.
View Article and Find Full Text PDFA multimode fiber-based sensor is proposed and demonstrated for the detection of lead traces in contaminated water. The sensing mechanism involves using a light sheet to excite a specific group of skew rays that optimizes light absorption. The sensing region features an inline microbubble structure that funnels the skew rays into a tight ring, thereby intensifying the evanescent field.
View Article and Find Full Text PDFThe structural health of fiber-optic communication networks has become increasingly important due to their widespread deployment and reliance in interconnected cities. We demonstrate a smart upgrade of a communication system employing a dual-polarization-state polarization shift keying (2-PolSK) modulation format to enable distributed vibration monitoring. Sensing can be conducted without hardware changes or occupying additional communication bandwidth.
View Article and Find Full Text PDFThe deep integration of communication and sensing technology in fiber-optic systems has been highly sought after in recent years, with the aim of rapid and cost-effective large-scale upgrading of existing communication cables in order to monitor ocean activities. As a proof-of-concept demonstration, a high-degree of compatibility was shown between forward-transmission distributed fiber-optic vibration sensing and an on-off keying (OOK)-based communication system. This type of deep integration allows distributed sensing to utilize the optical fiber communication cable, wavelength channel, optical signal and demodulation receiver.
View Article and Find Full Text PDFFor distributed fiber-optic sensors, slowly varying vibration signals down to 5 mHz are difficult to measure due to low signal-to-noise ratios. We propose and demonstrate a forward transmission-based distributed sensing system, combined with a polarization-generated carrier for detection bandwidth reduction, and cross-correlation for vibration positioning. By applying a higher-frequency carrier signal using a fast polarization controller, the initial phase of the known carrier frequency is monitored and analyzed to demodulate the vibration signal.
View Article and Find Full Text PDFSilica fiber under high pressure increases the risk of fiber breakage or permanent deformation, which may cause sensor failure due to mechanical strength limitations. High pressure can also induce birefringence in optical fiber. In this study, we present a simple design and low-cost high pressure sensor using polymer optical fiber (POF) based on the intensity-variation technique.
View Article and Find Full Text PDFFiber-optic biosensors have garnered significant attention and witnessed rapid development in recent years owing to their remarkable attributes such as high sensitivity, immunity to electromagnetic interference, and real-time monitoring. They have emerged as a potential tool in the realm of biomarker detection for low-concentration and small molecules. In this paper, a portable and cost-effective optical fiber biosensor based on surface plasmon resonance for the early detection of breast cancer is demonstrated.
View Article and Find Full Text PDFThis publisher's note contains corrections to Opt. Lett.48, 4825 (2023)10.
View Article and Find Full Text PDFUndersea earthquake-triggered giant tsunamis pose significant threats to coastal areas, spanning thousands of kilometers and affecting populations, ecosystems, and infrastructure. To mitigate their impact, monitoring seismic activity in underwater environments is crucial. In this study, we propose a new, to the best of our knowledge, approach for monitoring vibrations in submarine optical cables.
View Article and Find Full Text PDFLong-range vibration sensing is an important tool for real-time structural health monitoring. A new, to the best of our knowledge, design of a distributed fiber-optic vibration sensor is introduced and experimentally demonstrated in this study. The proposed system utilizes the transmission of light in the forward direction for sensing, and a self-interference method for laser source simplification.
View Article and Find Full Text PDFOvercoming the limitations of traditional analytical methods and developing technologies to continuously monitor environments and produce a comprehensive picture of potential endocrine-disrupting chemicals (EDCs) has been an ongoing challenge. Herein, we developed a portable nuclear receptor (NR)-based biosensor within 90 min to perform highly sensitive analyses of a broad range of EDCs in environmental water samples. Based on the specific binding of the fluorescence-labeled NRs with their ligands, the receptors were attached to the EDC-functionalized fiber surface by competing with EDCs in the samples.
View Article and Find Full Text PDFThere has been a rise in pesticide use as a result of the growing industrialization of agriculture. Organophosphorus pesticides have been widely applied as agricultural and domestic pest control agents for nearly five decades, and they remain as health and environmental hazards in water supplies, vegetables, fruits, and processed foods causing serious foodborne illness. Thus, the rapid and reliable detection of these harmful organophosphorus toxins with excellent sensitivity and selectivity is of utmost importance.
View Article and Find Full Text PDFOptical humidity sensors have evolved through decades of research and development, constantly adapting to new demands and challenges. The continuous growth is supported by the emergence of a variety of optical fibers and functional materials, in addition to the adaptation of different sensing mechanisms and optical techniques. This review attempts to cover the majority of optical humidity sensors reported to date, highlight trends in design and performance, and discuss the challenges of different applications.
View Article and Find Full Text PDFA novel U-shaped fiber-optic evanescent-wave fluorescent immunosensor was designed that exploits light-sheet excitation of skew rays in a passive fiber for sensitive microcystin-LR (MC-LR) detection in real-time. In particular, a light sheet comprising a thin plane of light can be concentrated into exciting the optimum ray group, resulting in enhanced interaction between light and fluorophores. Meanwhile, skew rays excited by transmitting light into an optical fiber with an angle offset allow a much higher number of total-internal-reflections with increased interaction length along the fiber interface, which strengthens the light-matter interactions.
View Article and Find Full Text PDFThe evanescent fields along multimode fibers are usually relatively weak. To enhance the sensitivity of the resulting sensors, skew rays have been exploited for their larger number of total internal reflections and their more comprehensive spread over the fiber surface. The uniform distribution of light-matter interactions across the fiber surface facilitates high sensitivity through an increased interaction area, while mitigating the risk of laser-induced coating-material damage and photobleaching.
View Article and Find Full Text PDFA stronger absorption of pump/probe light is desirable for maximizing the sensitivity to enable accurate measurements of trace chemical elements. We introduce a new sensing technique built on light-sheet excitation of skew rays in a multimode fiber with an additional enhancement of localized surface plasmon resonance (LSPR) and its evanescent-field hotspots between gold nanospheres on the coated fiber. A skewed light-sheet (i.
View Article and Find Full Text PDFThere is a deficiency of low-loss microstructured waveguides that can be fabricated with a single laser-pass to minimize stress build-up, which can enable enhanced functionality and higher compactness for integrated optical devices. We demonstrate, for the first time, a series of multi-ring claddings each with a pair of cores in BK7 glass. Each waveguide was fabricated using only a single laser-pass at 1 MHz pulse repetition rate, 5 mm/s translation speed, 250 fs pulse width, over a set of pulse energies.
View Article and Find Full Text PDFUltrafast laser inscribed waveguide lasers can lead to highly efficient and compact optical devices. This Letter reports an average lasing efficiency of 65%±2.5% from a multi-waveguide 2.
View Article and Find Full Text PDFWe characterize the frequency noise performance of a free-running dual-comb source based on an erbium-doped glass chip running two adjacent mode-locked waveguide lasers. This compact laser platform, contained only in a 1.2 L volume, rejects common-mode environmental noise by 20 dB thanks to the proximity of the two laser cavities.
View Article and Find Full Text PDFA correction to this article has been published and is linked from the HTML and PDF versions of this paper. The error has been fixed in the paper.
View Article and Find Full Text PDFOptical microfibers possess excellent optical and mechanical properties that have been exploited for sensing. We highlight the authors' recent work in the areas of current, temperature, acceleration, acoustic, humidity and ultraviolet-light sensing based on this exquisite technology, and the advantages and challenges of using optical microfibers are discussed.
View Article and Find Full Text PDFReal-time measurement of the relative humidity of air has applications ranging from process control to safety. By using a microfiber form-factor, we demonstrate a miniature and fast-response hygrometer with the shortest-ever response time (3 ms). The sensor head consists of an optical microfiber of 10 µm diameter and 2 mm length configured to form a compact U-shaped probe, and functionalized with a polyelectrolyte multilayer coating of 1.
View Article and Find Full Text PDF