Photocatalytic degradation of organophosphorus flame retardants in aqueous solutions: a review and future prospects.

The widespread use of organophosphorus flame retardants (OPFRs) in industrial and household products increases the risk of their environmental exposure, posing a serious threat to ecosystems and human health. Photocatalytic technology has been widely used in wastewater treatment due to its high efficiency, mild reaction conditions, and robustness. This review summarizes the current status of research on photocatalytic degradation of OPFRs, focusing on the effect of different types of catalysts on the degradation efficiency, the effects of pH, and co-existing inorganic and organic ions.

An open-ended waveguide system for SAR system validation or probe calibration for frequencies above 3 GHz.

Compliance with safety guidelines prescribed in terms of maximum electromagnetic power absorption (specific absorption rate or SAR) for any 1- or 10-g of tissue is required for all newly introduced personal wireless devices such as wireless PCs. The prescribed SAR measuring system is a planar phantom with a relatively thin base of thickness 2.0 mm filled with a lossy fluid to simulate dielectric properties of the tissues.

Comparison of various safety guidelines for electronic article surveillance devices with pulsed magnetic fields.

The paper uses the two methods suggested in both the ICNIRP and proposed IEEE safety guidelines for compliance testing of security systems based on time-varying magnetic fields being introduced for electronic article surveillance (EAS), radiofrequency identification, and other applications. For nonsinusoidal pulses that are often used, the two procedures are to treat the exposure as a multifrequency exposure with various frequency components or to calculate the peak induced current densities or electric fields treating the highest of the pulses of duration t(p) as a single frequency, half sinusoid of the same duration and frequency 1/(2t(p)). Using either of the procedures, the induced current densities (J) or electric fields (E) are compared to the basic restrictions on J or E for compliance testing.

SARs for pocket-mounted mobile telephones at 835 and 1900 MHz.

Increasingly, mobile telephones are becoming pocket-sized and are being left in the shirt pocket with a connection to the ear for hands-free operation. We have considered an anatomic model of the chest and a planar phantom recommended by US FCC to compare the peak 1 and 10 g SARs for four typical cellular telephones, two each at 835 and 1900 MHz. An agreement within +/- 10% is obtained between calculated and experimental 1 and 10 g SARs for various separations (2-8 mm) from the planar phantom used to represent different thicknesses of the clothing both for the antenna away from or turned back towards the body.

Some present problems and a proposed experimental phantom for SAR compliance testing of cellular telephones at 835 and 1900 MHz.

This paper compares the maximum allowable powers of some typical cellular telephones at 835 and 1900 MHz for compliance with the limits of specific absorption rates (SAR) given in ANSI/IEEE, ICNIRP and the proposed modification of ANSI/IEEE safety guidelines. It is shown that the present ANSI/IEEE guideline is the most conservative with the ICNIRP guidelines allowing a maximum radiated powerthat is 2.5-3 times higher, and the proposed IEEE modification of treating pinna as an extremity tissue the least conservative allowing even higher radiated powers by up to 50%.