Reproducible 3D culture of multicellular tumor spheroids in supramolecular hydrogel from cancer stem cells sorted by sedimentation field-flow fractionation.

Three-dimensional (3D) cancer models, such as multicellular tumor spheroids (MCTS), are biological supports used for research in oncology, drug development and nanotoxicity assays. However, due to various analytical and biological challenges, the main recurring problem faced when developing this type of 3D model is the lack of reproducibility. When using a 3D support to assess the effect of biologics, small molecules or nanoparticles, it is essential that the support remains constant over time and multiples productions.

Novel zone elution mode in coiled tube field-flow fractionation for online separation and characterization of environmental submicron particles.

Coiled tube field-flow fractionation (CTFFF) is currently applied to environmental and material studies. In the present work, a novel zone elution mode in CTFFF has been proposed and developed. Zone elution mode is based on the separation of particles by stepwise decreasing the flow rate of the carrier fluid and their subsequent elution at a constant flow rate.

Nucleoside-Derived Low-Molecular-Weight Gelators as a Synthetic Microenvironment for 3D Cell Culture.

For the last few decades, many efforts have been made in developing cell culture methods in order to overcome the biological limitations of the conventional two-dimensional culture. This paradigm shift is driven by a large amount of new hydrogel-based systems for three-dimensional culture, among other systems, since they are known to mimic some living tissue properties. One class of hydrogel precursors has received interest in the field of biomaterials, low-molecular-weight gelators (LMWGs).

Field-flow fractionation for nanoparticle characterization.

This review presents field-flow fractionation: The elements of theory enable the link between the retention and the characteristics of the nanometer-sized analytes to be highlighted. In particular, the nature of force and its way of being applied are discussed. Four types of forces which determine four types of techniques were considered: hydrodynamic, sedimentation, thermal, and electrical; this is to show the importance of the choice of technique in relation to the characterization objectives.

Characterization of Glioblastoma Cancer Stem Cells Sorted by Sedimentation Field-Flow Fractionation Using an Ultrahigh-Frequency Range Dielectrophoresis Biosensor.

Cancer stem cells (CSCs) appear to be an essential target for cancer therapies, in particular, in brain tumors such as Glioblastoma. Nevertheless, their isolation is made difficult by their low content in culture or tumors (<5% of the tumor mass) and is essentially based on the use of fluorescent or magnetic labeling techniques, increasing the risk of differentiation induction. The use of label-free separation methods such as sedimentation field-flow fractionation (SdFFF) is promising, but it becomes necessary to consider a coupling with a detection and characterization method for future identification and purification of CSCs from patient-derived tumors.

Biomaterials for Three-Dimensional Cell Culture: From Applications in Oncology to Nanotechnology.

Three-dimensional cell culture has revolutionized cellular biology research and opened the door to novel discoveries in terms of cellular behavior and response to microenvironment stimuli. Different types of 3D culture exist today, including hydrogel scaffold-based models, which possess a complex structure mimicking the extracellular matrix. These hydrogels can be made of polymers (natural or synthetic) or low-molecular weight gelators that, via the supramolecular assembly of molecules, allow the production of a reproducible hydrogel with tunable mechanical properties.

Characterization of volcanic ash nanoparticles and study of their fate in aqueous medium by asymmetric flow field-flow fractionation-multi-detection.

Dimensional and elemental characterization of environmental nanoparticles is a challenging task that requires the use of a set of complementary analytical methods. Asymmetric flow field-flow fractionation coupled with UV-Vis, multi-angle laser light scattering and ICP-MS detection was applied to study the nanoparticle fraction of a volcanic ash sample, in a Milli-Q water suspension at pH 6.8.

Centrifugal ultrafiltration preconcentration for studying the colloidal phase of a uranium-containing soil suspension.

The objective of this work was to explore centrifugal ultrafiltration (UF) to separate and / or preconcentrate natural colloidal particles for their characterization. A soil suspension obtained by batch leaching was used as a laboratory reference sample. It was preconcentrated with concentration factors (CF) varying from 10 to 450.

Platinum group elements contamination in soils: Review of the current state.

Platinum group elements (PGE: Ru, Rh, Pd, Os Ir, Pt) are rare metals with low abundance in the continental crust. The elements of the palladium subgroup of PGE (PPGE: Pt, Pd, Rh) have been exploited more and more over the last thirty years for their physicochemical properties such as high melting point, high resistance to corrosion, mechanical strength and ductility. This led to emerging environmental contamination in different media such as air, road dust, soil, sediment, vegetation, and snow.

Self-Assembly of Nucleoside-Derived Low-Molecular-Weight Gelators: A Thermodynamics and Kinetics Study on Different Length Scales.

Biocompatible materials are of paramount importance in numerous fields. Unlike chemically bridge polymer-based hydrogels, low-molecular-weight gelators can form a reversible hydrogel as their structures rely on noncovalent interaction. Although many applications with this type of hydrogel can be envisioned, we still lack their understanding due to the complexity of their self-assembly process and the difficulty in predicting their behaviors (transition temperature, gelation kinetics, the impact of solvent, etc.

Mobility and transformation of CdSe/ZnS quantum dots in soil: Role of the capping ligands and ageing effect.

The increasing application of Quantum Dots (QDs) is cause of concern for the potential negative effects for the ecosystem, especially in soils that may act as a sink. In this study, soil leaching experiments were performed in quartz sand packed columns to investigate the behavior of core-shell CdSe/ZnS QDs coated with either small ligands (TGA-QDs) or more complex polymers (POAMA-QDs). Fluorescence emission was compared to mass spectrometric measurements to assess the nanoparticles (NPs) state in both the leachate (transported species) and porous media (deposited amounts).

Comparison of preconcentration methods of the colloidal phase of a uranium-containing soil suspension.

Three methods of membrane separation by dead-end, tangential, and centrifugal ultrafiltration (UF) were considered in order to understand the physicochemical phenomena occurring during the preconcentration of the colloidal phase of soil water. The analytical approach used involved dynamic light scattering (DLS), transmission electron microscopy (TEM), determination of total organic carbon (TOC-metry) and mass spectrometry (ICP-MS). The mass amounts of the major components of the colloidal phase, i.

Separation of nanoparticles from polydisperse environmental samples: comparative study of filtration, sedimentation, and coiled tube field-flow fractionation.

Nanoparticles (NPs) in the environment have a potential risk for human health and the ecosystem due to their ubiquity, specific characteristics, and properties (extreme mobility in the environment, abilities to accumulate of toxic elements and penetrate into living organisms). There is still a gap in studies on the chemical composition of natural NPs. The main reason is the difficulty to recover NPs, which may represent only one-thousandth or less of the bulk environmental sample, for further dimensional and quantitative characterization.

Colloidal mobilization from soil and transport of uranium in (sub)-surface waters.

An analytical methodology was developed to characterize the colloidal distribution of trace elements of interest in environmental waters sampled in a same site and enables the different colloidal distributions from waters to be compared. The purpose was to provide consistent information related to the origin and nature of colloids responsible for the transport of trace element(s). The work was motivated by the observed enhanced mobility of uranium in soil.

Characterization of polymer-coated CdSe/ZnS quantum dots and investigation of their behaviour in soil solution at relevant concentration by asymmetric flow field-flow fractionation - multi angle light scattering - inductively coupled plasma - mass spectrometry.

A careful separation, identification and characterization of polymer-coated quantum dots (P-QDs) in complex media such as soil solution is the key point to understand their behaviour and to accurately predict their fate in the environment. In the present study, a synthesized CdSe/ZnS core/shell P-QDs suspension, proved to be stable for at least six months, was investigated with respect to P-QDs dimension, structure and elemental composition. Separation of P-QDs and size distribution determination were carried out by Asymmetric Flow Field-Flow Fractionation (AF4) - Multi Angle Light Scattering (MALS).

Nanoanalytics: history, concepts, and specificities.

This article deals with analytical chemistry devoted to nano-objects. A short review presents nano-objects, their singularity in relation to their dimensions, genesis, and possible transformations. The term nano-object is then explained.

Gold and silver quantification from gold-silver nanoshells in HaCaT cells.

A method to determine total gold (Au) and/or silver (Ag) elemental concentrations from gold nanoparticles, Au-Ag nanoshells (NS) and silica coated Au-Ag nanoshells was developed, evaluated and validated. Samples were mineralized in a mixture of concentrated aqua regia and hydrofluoric acid at 65 °C for 4 h. Mineralized solutions were diluted and standard solutions were prepared in aqua regia 5%.

A Unique (3+2) Annulation Reaction between Meldrum's Acid and Nitrones: Mechanistic Insight by ESI-IMS-MS and DFT Studies.

The fragile intermediates of the domino process leading to an isoxazolidin-5-one, triggered by unique reactivity between Meldrum's acid and an N-benzyl nitrone in the presence of a Brønsted base, were determined thanks to the softness and accuracy of electrospray ionization mass spectrometry coupled to ion mobility spectrometry (ESI-IMS-MS). The combined DFT study shed light on the overall organocatalytic sequence that starts with a stepwise (3+2) annulation reaction that is followed by a decarboxylative protonation sequence encompassing a stereoselective pathway issue.

Design and Cellular Fate of Bioinspired Au-Ag Nanoshells@Hybrid Silica Nanoparticles.

Silica-coated gold-silver alloy nanoshells were obtained via a bioinspired approach using gelatin and poly-l-lysine (PLL) as biotemplates for the interfacial condensation of sodium silicate solutions. X-ray photoelectron spectroscopy was used as an efficient tool for the in-depth and complete characterization of the chemical features of nanoparticles during the whole synthetic process. Cytotoxicity assays using HaCaT cells evidenced the detrimental effect of the gelatin nanocoating and significant induction of late apoptosis after silicification.

Diffusive Milli-Gels (DMG) for in situ assessment of metal bioavailability: A comparison with labile metal measurement using Chelex columns and acute toxicity to Ceriodaphnia dubia for copper in freshwaters.

Fluctuations in concentrations of bioavailable metals occur in most natural waters. In situ measurements are desirable to predict risks of adverse effects to aquatic organisms. We evaluated Diffusive Milli-Gels (DMG), a new in situ passive sampler, for assessing the bioavailability and toxicity of copper in waters exhibiting a wide range of characteristics.

Need for revisiting the terminology about speciation.

ᅟThe term speciation is used for over 30 years, with different meanings. In the early 2000s, a reference definition was proposed. The elemental distribution is discussed only with respect to molecular structures.

The fate of iron nanoparticles in environmental waters treated with nanoscale zero-valent iron, FeONPs and Fe3O4NPs.

Among the different nanoparticles (NPs) that are used in the remediation of contaminated environmental waters, iron nanoparticles (FeNPs) are the most frequently applied. However, if these FeNPs remain in the waters after the treatment, they can cause a hazard to the environment. In this work the time dependent size distribution of iron particles was investigated in Milli-Q water, forest spring water and landfill leachate after a variety of FeNP treatments.

Using Implicit Solvent in Ab Initio Electrochemical Modeling: Investigating Li⁺/Li Electrochemistry at a Li/Solvent Interface.

This paper focuses on the use of implicit solvent in electrochemical density functional theory (DFT) calculations. We investigate both the necessity and limits of an implicit solvent polarizable continuum model (PCM). In order to recover the proper electrochemical behavior of the surface and, in particular, a proper potential scale, the solvent model is determined to be mandatory: in the limit of a high dielectric constant, the surface capacitance becomes independent of the interslab space used in the model and, therefore, the electrochemical properties become intrinsic of the interface structure.