Formation of UHMWPE Nanofibers during Solid-State Deformation.

A network of nanofibers is formed in situ through solid-state deformation of disentangled ultra-high molecular weight polyethylene (dis-UHMWPE) during compounding with a polyolefin elastomer below the melting temperature of dis-UHMWPE crystals. Dis-UHMWPE was prepared in the form of powder particles larger than 50 μm by polymerization at low temperatures, which favored the crystallization and prevention of macromolecules from entangling. Shearing the blend for different durations and at different temperatures affects the extent to which the grains of dis-UHMWPE powder deform into nanofibers.

Fiber Orientation and Concentration in an Injection-Molded Ethylene-Propylene Copolymer Reinforced by Hemp.

This paper characterizes and analyzes the microstructures of injection-molded polypropylene parts reinforced with 20 wt% of hemp fibers in order to understand the process induced variations in thermomechanical properties. In-thickness fiber orientation and fiber content were determined by X-ray tomography along the flow. The fiber content along the flow path was also determined by direct fiber content measurements after matrix dissolution, showing an increase of 2%/100 mm for a 2.

Determining the correct stoichiometry of Kv2.1/Kv6.4 heterotetramers, functional in multiple stoichiometrical configurations.

The electrically silent (KvS) members of the voltage-gated potassium (Kv) subfamilies Kv5, Kv6, Kv8, and Kv9 selectively modulate Kv2 subunits by forming heterotetrameric Kv2/KvS channels. Based on the reported 3:1 stoichiometry of Kv2.1/Kv9.

Impact of Nanoconfinement on Polylactide Crystallization and Gas Barrier Properties.

The barrier properties of poly(l-lactide) (PLLA) were investigated in multinanolayer systems, probing the effect of confinement, the compatibility between the confining and the confined polymer, crystal orientation, and amorphous phase properties. The multilayer coextrusion process was used to confine PLLA between two amorphous polymers (polystyrene, PS; and polycarbonate, PC), which have different chemical affinities with PLLA. Confined PLLA layers of approximately 20 nm thickness were obtained.