Assessment of the Effect of Multiple Processing of PHBV-Ground Buckwheat Hull Biocomposite on Its Functional and Mechanical Properties.

The influence of the addition of ground buckwheat hulls on the properties of biocomposite on the basis of 3-hydroxybutyrate-co-3-hydroxyvalerate (PHBV) is presented here. The changes in the material after repeated reprocessing-up to five recycling cycles-are written in the paper. Analysis of the shrinkage, water adsorption, selected mechanical properties, tensile impact strength, hardness and the microstructure of the surface layer was performed.

Modification of Poly(3-Hydroxybutyrate) with a Linear Polyurethane Modifier and Organic Nanofiller-Preparation and Structure-Property Relationship.

The growing demand for products made of polymeric materials, including the commonly used polypropylene (PP), is accompanied by the problem of storing and disposing of non-biodegradable waste, increasing greenhouse gas emissions, climate change and the creation of toxic products that constitute a health hazard of all living organisms. Moreover, most of the synthetic polymers used are made from petrochemical feedstocks from non-renewable resources. The use of petrochemical raw materials also causes degradation of the natural environment.

Processing of Layered Composite Products Manufactured on the Basis of Bioresin Reinforced with Flax Fabric Using Milling Technology.

In this work, a laminate based on bioresin and natural fibers was produced. Flax fabric was selected as the natural fiber. The biocomposite was subjected to strength tests.

Wood Polymer Composite Based on Poly-3-hydroxybutyrate-3-hydroxyvalerate (PHBV) and Wood Flour-The Process Optimization of the Products.

This study involved the optimization of the molded pieces manufacturing process from a poly-3-hydroxybutyrate-co-3-hydroxyvalerate biocomposite containing 30% wood flour by mass. The amount of wood flour and preliminary processing parameters were determined on the basis of preliminary tests. The aim of the optimization was to find the configuration of important parameters of the injection process to obtain molded pieces of good quality, in terms of aesthetics, dimensions, and mechanical properties.