Nanostructured severe plastic deformation processed titanium for orthodontic mini-implants.

Titanium mini-implants have been successfully used as anchorage devices in Orthodontics. Commercially pure titanium (cpTi) was recently replaced by Ti-6Al-4V alloy as the mini-implant material base due to the higher strength properties of the alloy. However, the lower corrosion resistance and the lower biocompatibility have been lowering the success rate of Ti-6Al-4V mini-implants.

In vitro and in vivo studies on nanocrystalline Ti fabricated by equal channel angular pressing with microcrystalline CP Ti as control.

Bulk nanocrystalline Ti bars (Grade 4, Φ4 × 3000 mm(3)) were massively fabricated by equal channel angular pressing (ECAP) via follow-up conform scheme with the microcrystalline CP Ti as raw material. Homogeneous nanostructured crystals with the average grain size of 250 nm were identified for the ECAPed Ti, with extremely high tensile/fatigue strength (around 1240/620 MPa) and adorable elongation (more than 5%). Pronounced formation of bonelike apatite for the nanocrystalline Ti group after 14 days static immersion in simulated body fluids (SBF) reveals the prospective in vitro bioactive capability of fast calcification, whereas an estimated 17% increment in protein adsorption represents good bioaffinity of nanocrystalline Ti.

Strength and fatigue properties enhancement in ultrafine-grained Ti produced by severe plastic deformation.

Severe plastic deformation (SPD) of titanium creates an ultrafine-grained (UFG) microstructure which results in significantly enhanced mechanical properties, including increasing the high cycle fatigue strength. This work addresses the challenge of maintaining the high level of properties as SPD processing techniques are evolved from methods suitable for producing laboratory scale samples to methods suitable for commercial scale production of titanium semi-products. Various ways to optimize the strength and fatigue endurance limit in long-length Grade 4 titanium rod processed by equal channel angular pressing (ECAP) with subsequent thermal mechanical treatments are considered in this paper.