Alkali, thermal, or thermo-alkali pre-treatment to improve the anaerobic digestion of poly(lactic acid)?

Replacing petroleum-based plastics with biodegradable polymers is a major challenge for modern society especially for food packaging applications. To date, poly(lactic acid) represents 25 % of the total biodegradable plastics and it is estimated that, in the future, it could become the main contributor to the biodegradable plastics industry. Anaerobic digestion is an interesting way for the poly(lactic acid) end of life, even if its biodegradability is limited in mesophilic conditions.

Simulation of biowastes and biodegradable plastics co-digestion in semi-continuous reactors: Performances and agronomic evaluation.

The development of selective biowaste collection in most European countries provides new opportunities for the anaerobic digestion sector. In parallel, extensive development of biodegradable plastics like polylactic-acid (PLA) and polyhydroxybutyrate (PHB), which facilitates the replacement of conventional plastics, has taken place in the past decade. This study investigated anaerobic co-digestion in semi-continuous reactors of biowastes (75 % Volatil Solids) and biodegradable plastics (25 % Volatil Solids, PLA and PHB).

Active microbial communities during biodegradation of biodegradable plastics by mesophilic and thermophilic anaerobic digestion.

Biodegradable plastics, if they are not properly managed at their end-of-life, can have the same hazardous environmental consequences as conventional plastics. This study investigates the treatment of the main biodegradable plastics under mesophilic and thermophilic anaerobic digestion using biochemical methane potential test and the microorganisms involved in the process using amplicon sequencing of the 16 S rRNA. Here we showed that, only PHB and TPS undergone important and rapid biodegradation under mesophilic condition (38 °C).

Biochemical methane potential and active microbial communities during anaerobic digestion of biodegradable plastics at different inoculum-substrate ratios.

The influence of the inoculum-substrate ratio (ISR) on the mesophilic and thermophilic biochemical methane potential test of two biodegradable plastics was evaluated. Poly(lactic acid) (PLA) and polyhydroxybutyrate (PHB) were selected for this study, the first for being recalcitrant to mesophilic anaerobic digestion (AD) and the second, by contrast, for being readily biodegradable. Several ISRs, calculated on the basis of volatile solids (VS), were tested: 1, 2, 2.

Impact of mechanical and thermo-chemical pretreatments to enhance anaerobic digestion of poly(lactic acid).

To date, the introduction of biodegradable plastics such as PLA in anaerobic digestion systems has been limited by a very low rate of biodegradation. To overcome these limitations, pretreatment technologies can be applied. In this study, the impact of pretreatments (mechanical, thermal, thermo-acid, and thermo-alkaline) was investigated.