Implementation of Sweden's first digi-physical hospital-at-home care model for high-acuity patients.

Aim: To evaluate Sweden's first implementation of a 24/7 high-acuity virtual in-patient ward through a digi-physical in-patient care (DPIPC) program, a hospital-at-home care model combining a virtual hospital-based medical command centre and in-person ambulating medical services functioning as an extension of the Department of Medicine at a secondary-level hospital in Stockholm.

Methods: A single-centre descriptive study where adult patients with acute medical illness requiring inpatient-level care were assessed for voluntary treatment in the DPIPC program as a substitute for traditional in-patient care. The primary outcome was patient satisfaction with care.

Anatomical Modeling and Optimization of Speckle Contrast Optical Tomography.

Traditional methods for mapping cerebral blood flow (CBF), such as positron emission tomography and magnetic resonance imaging, offer only isolated snapshots of CBF due to scanner logistics. Speckle contrast optical tomography (SCOT) is a promising optical technique for mapping CBF. However, while SCOT has been established in mice, the method has not yet been demonstrated in humans - partly due to a lack of anatomical reconstruction methods and uncertainty over the optimal design parameters.

A comprehensive workflow and its validation for simulating diffuse speckle statistics for optical blood flow measurements.

Diffuse optical methods including speckle contrast optical spectroscopy and tomography (SCOS and SCOT), use speckle contrast () to measure deep blood flow. In order to design practical systems, parameters such as signal-to-noise ratio (SNR) and the effects of limited sampling of statistical quantities, should be considered. To that end, we have developed a method for simulating speckle contrast signals including effects of detector noise.

Multi-mode fiber-based speckle contrast optical spectroscopy: analysis of speckle statistics.

Speckle contrast optical spectroscopy/tomography (SCOS/T) provides a real-time, non-invasive, and cost-efficient optical imaging approach to mapping of cerebral blood flow. By measuring many speckles (n>>10), SCOS/T has an increased signal-to-noise ratio relative to diffuse correlation spectroscopy, which measures one or a few speckles. However, the current free-space SCOS/T designs are not ideal for large field-of-view imaging in humans because the curved head contour cannot be readily imaged with a single flat sensor and hair obstructs optical access.

Influence of study design on effects of mask wearing on fMRI BOLD contrast and systemic physiology - A comment on Law et al. (2021).

In a study by Law and colleagues recently published in Neuroimage, the authors reported that wearing a surgical mask during an fMRI scan leads to a statistically significant subject-specific change (30%) in the baseline BOLD level in gray matter, although the response to a sensory-motor task was unaffected. An average increase in end-tidal CO of 7.4% was found when wearing a mask, despite little support in the literature for major effects of mask wearing on blood gas levels.

Blood flow response to orthostatic challenge identifies signatures of the failure of static cerebral autoregulation in patients with cerebrovascular disease.

Background: The cortical microvascular cerebral blood flow response (CBF) to different changes in head-of-bed (HOB) position has been shown to be altered in acute ischemic stroke (AIS) by diffuse correlation spectroscopy (DCS) technique. However, the relationship between these relative ΔCBF changes and associated systemic blood pressure changes has not been studied, even though blood pressure is a major driver of cerebral blood flow.

Methods: Transcranial DCS data from four studies measuring bilateral frontal microvascular cerebral blood flow in healthy controls (n = 15), patients with asymptomatic severe internal carotid artery stenosis (ICA, n = 27), and patients with acute ischemic stroke (AIS, n = 72) were aggregated.

Looking back at fNIRS 2018.

We offer a retrospective report on fNIRS 2018, along with news of the next meeting.

High-Temperature Storage Testing of ACF Attached Sensor Structures.

Several electronic applications must withstand elevated temperatures during their lifetime. Materials and packages for use in high temperatures have been designed, but they are often very expensive, have limited compatibility with materials, structures, and processing techniques, and are less readily available than traditional materials. Thus, there is an increasing interest in using low-cost polymer materials in high temperature applications.

Creating a process to standardize regimen order sets within an electronic health record.

Purpose: US Oncology uses regimen order sets in clinical practice to treat patients. However, the process to assure accuracy and upkeep of these order sets has not been described. The purpose of this project was to evaluate the regimens housed in the electronic health record, iKnowMed, to determine their appropriateness and accuracy.