Synthesis of aviation biofuel precursors from biomass-derived ketones: Substrate adsorption configuration-catalytic activity.

The production of aviation biofuel precursors from biomass-derived ketones by heterogeneous catalysis has been hindered by the low catalytic activity. Herein, a series of Cu-doped metal oxide catalysts were prepared for the conversion of biomass-derived ketones to aviation biofuel precursors. Solvent-free cyclopentanone conversion via aldol condensation reached 91.

Evaluation of South Korean marine waste resources for hydrochar production: Effect of process variables.

This study assessed the hydrochar production potential of fish and crustacean waste from 8 marine species (Scomber japonicus, Trichiurus lepturus, Larimichthys polyactis, Trachurus trachurus, Paralichthys olivaceus Litopenaeus vannamei, Portunus trituberculatus, and Penaeus monodon) through hydrothermal carbonization (HTC) of their waste fractions. The impact of reaction temperature (200 - 240°C), fixed residence time (5 h), and water-to-biomass ratio (7) on HTC was analyzed. The results showed that hydrochar yields varied between fish (15.

Dynamic performance of combined biochar from co-pyrolysis of pig manure with invasive weed: Effect of natural aging on Pb and As mobilization in polluted mining soil.

Due to the natural biochar aging, the improvement of soil quality and immobilization of soil pollutants achieved by biochar may change; understanding the dynamic evolution of the in situ performance of biochar in these roles is essential to discuss the long-term sustainability of biochar remediation. Therefore, in this study, combined biochar from co-pyrolysis of pig manure and invasive Japanese knotweed - P1J1, as well as pure pig manure - PM - and pure Japanese knotweed - JK - derived biochar were applied to investigate their remediation performance in a high As- and Pb-polluted soil with prolonged incubation periods (up to 360 days). Biochar application, especially P1J1 and PM, initially promoted soil pH, dissolved organic carbon, and EC, but the improvements were not constant through time.

Metal behavior and soil quality changes induced by the application of tailor-made combined biochar: An investigation at pore water scale.

The remediation performance of biochar varies based on the biomass used for its production. Further innovation involves developing tailor-made biochar by combining different raw materials to compensate for the limitations of pure biochar. Therefore, tailor-made combined biochar produced from the co-pyrolysis of pig manure and invasive Japanese knotweed (P1J1), as well as biochars produced from these feedstocks separately, i.

Assessment of the properties of aging biochar used as a substrate in constructed wetlands.

Biochar has gained global recognition as an effective tool for environmental remediation, and is increasingly being used as an alternative substrate in constructed wetlands (CWs). While, most studies have focused on the positive effects of biochar for the pollutant removal in CWs, less is known about aging and longevity of the embedded biochar. This study investigated the aging and stability of biochar embedded in CWs post-treating the effluent of a municipal and an industrial wastewater treatment plant.

Microwave assisted and conventional hydrothermal treatment of waste seaweed: Comparison of hydrochar properties and energy efficiency.

Waste seaweed is a valuable source for converting into value-added carbon materials. In this study, the production of hydrochar from waste seaweed was optimized for hydrothermal carbonization in a microwave process. The produced hydrochar was compared with hydrochar synthesized by the regular process using a conventional heating oven.

Combined Heat and Mass Transfer Associated with Kinetics Models for Analyzing Convective Stepwise Drying of Carrot Cubes.

Stepwise drying is an effective technique that promotes energy saving without additional capital cost. The stepwise drying mode was investigated for energy consumption and dried product qualities using a coupled heat and mass transfer model associated with kinetics equations of volume shrinkage and degradation of β-carotene in carrot cubes. Simulations were performed using a finite element method with extension of a chemical species transport.

Cell Behavior Changes and Enzymatic Biodegradation of Hybrid Electrospun Poly(3-hydroxybutyrate)-Based Scaffolds with an Enhanced Piezoresponse after the Addition of Reduced Graphene Oxide.

This is the first comprehensive study of the impact of biodegradation on the structure, surface potential, mechanical and piezoelectric properties of poly(3-hydroxybutyrate) (PHB) scaffolds supplemented with reduced graphene oxide (rGO) as well as cell behavior under static and dynamic mechanical conditions. There is no effect of the rGO addition up to 1.0 wt% on the rate of enzymatic biodegradation of PHB scaffolds for 30 d.

Improving biochar properties by co-pyrolysis of pig manure with bio-invasive weed for use as the soil amendment.

Over recent years, pyrolysis has grown into a mature technology with added value for producing soil improvers. Further innovations of this technology lie in developing tailor-made products from specific feedstocks (or mixtures thereof) in combination with adjusted mixing ratio-temperature regimes. In this context, co-pyrolysis of pig manure (PM) and the invasive plant Japanese knotweed (JK) at different mixture ratios (w/w) of 3:1 (P3J1), 1:1 (P1J1), and 1:3 (P1J3) and varying temperatures (400-700 °C) was studied to address the low carbon properties and heavy metals (HMs) risks of manure-derive biochars and beneficially ameliorate the bio-invasion situation by creating value from the plant biomass.

Superheated steam as carrier gas and the sole heat source to enhance biomass torrefaction.

Superheated steam (SHS) has been used as a carrier gas for pressurized steam torrefaction, steam explosion or pyrolysis, but is barely used as a heat source. However, SHS is superior in thermal capacity and heat transfer coefficient resulting in even heating and fast heating rates. Therefore, this work applied SHS as the sole heat source for torrefaction at ambient pressure.

Biochar and activated carbon enhance ethanol conversion and selectivity to caproic acid by Clostridium kluyveri.

Syngas from biomass or steel mills can be fermented into a dilute stream of ethanol and acetic acid, which requires energy intensive distillation for product recovery. This can be circumvented by selective secondary fermentation of the syngas fermentation effluent to caproic acid as easier recoverable platform chemical with Clostridium kluyveri. Here, we explore the impact of biochar and activated carbon on this process.

Chemical stabilization of Cd-contaminated soil using fresh and aged wheat straw biochar.

Metal mining and smelting activities can introduce a substantial amount of potentially toxic elements (PTE) into the environment that can persist for an extended period. That can limit the productivity of the land and creates dangerous effects on ecosystem services. The effectiveness of wheat straw biochar to immobilize Cd in contaminated soil due to metal smelting activities was investigated in this study.

Complete oxidation of organic waste under mild supercritical water oxidation by combining effluent recirculation and membrane filtration.

Supercritical water oxidation (SCWO) is a technology that can oxidize various organic (wet) wastes into CO. Complete oxidation of specific organics with SCWO goes in tandem with tailored conditions, typically involving elevated operating temperatures, long residence times, high oxidizer-to-waste ratios, or a combination of those, which promote difficulties, e.g.

Assessment of biomass demineralization on gasification: From experimental investigation, mechanism to potential application.

Considering the advantages (e.g. agglomeration mitigation) and disadvantages (e.

Effluent recirculation enables near-complete oxidation of organics during supercritical water oxidation at mild conditions: A proof of principle.

This work presents a continuous set-up for SCWO, which was operated at mild conditions (380 °C, 25 MPa, oxidant equivalence ratio of 2.0 and residence time of 26 s) to oxidize cellulose, lignin, and acetic acid as model compounds. The aim was to oxidize different organics consecutively to near completion in the same mild reaction conditions and set-up.

Assessment of carbon recovery from solid organic wastes by supercritical water oxidation for a regenerative life support system.

The carbon recovery from organic space waste by supercritical water oxidation (SCWO) was studied to support resource recovery in a regenerative life support system. Resource recovery is of utmost importance in such systems which only have a limited total amount of mass. However, the practical waste treatment strategies for solid space wastes employed today are only storing and disposal without further recovery.

Application of biochars and solid fraction of digestate to decrease soil solution Cd, Pb and Zn concentrations in contaminated sandy soils.

Biochar prepared from waste biomass was evaluated as a soil amendment to immobilize metals in two contaminated soils. A 60-day incubation experiment was set up on a French technosol which was heavily contaminated with Pb due to former mining activities. Grass biochar, cow manure biochar (CMB) and two lightwood biochars differing in particle size distribution (LWB1 and LWB2) were amended to the soil at a rate of 2% (by mass).

Analytical Py-GC/MS of Genetically Modified Poplar for the Increased Production of Bio-aromatics.

Genetic engineering is a powerful tool to steer bio-oil composition towards the production of speciality chemicals such as guaiacols, syringols, phenols, and vanillin through well-defined biomass feedstocks. Our previous work demonstrated the effects of lignin biosynthesis gene modification on the pyrolysis vapour compositions obtained from wood derived from greenhouse-grown poplars. In this study, field-grown poplars downregulated in the genes encoding CINNAMYL ALCOHOL DEHYDROGENASE (), CAFFEIC ACID O-METHYLTRANSFERASE () and CAFFEOYL-CoA O-METHYLTRANSFERASE (), and their corresponding wild type were pyrolysed in a Py-GC/MS.

Sub- and supercritical water oxidation of anaerobic fermentation sludge for carbon and nitrogen recovery in a regenerative life support system.

Sub- and supercritical water oxidation was applied to recover carbon as CO, while maintaining nitrogen as NH or NO, from sludge obtained from an anaerobic fermenter running on a model waste composed of plant residues and human fecal matter. The objective was to fully convert carbon in the organic waste to CO while maintaining nutrients (specifically N) in the liquid effluent. In regenerative life support systems, CO and nutrients could then be further used in plant production; thus creating a closed carbon and nutrient cycle.

The electron donating capacity of biochar is dramatically underestimated.

Biochars have gathered considerable interest for agronomic and engineering applications. In addition to their high sorption ability, biochars have been shown to accept or donate considerable amounts of electrons to/from their environment via abiotic or microbial processes. Here, we measured the electron accepting (EAC) and electron donating (EDC) capacities of wood-based biochars pyrolyzed at three different highest treatment temperatures (HTTs: 400, 500, 600 °C) via hydrodynamic electrochemical techniques using a rotating disc electrode.

Quantitative analysis of nitrogen containing compounds in microalgae based bio-oils using comprehensive two-dimensional gas-chromatography coupled to nitrogen chemiluminescence detector and time of flight mass spectrometer.

Insight in the composition of the algae derived bio-oils is crucial for the development of efficient conversion processes and better upgrading strategies for microalgae. Comprehensive two-dimensional gas chromatography (GC×GC) coupled to nitrogen chemiluminescence detector (NCD) and time-of-flight mass spectrometer (TOF-MS) allows to obtain the detailed quantitative composition of the nitrogen containing compounds in the aqueous and the organic fraction of fast pyrolysis bio-oils from microalgae. Normal phase (apolar×mid-polar) and reverse phase column (polar×apolar) combination are investigated to optimize the separation of the detected nitrogen containing compounds.

Potential of genetically engineered hybrid poplar for pyrolytic production of bio-based phenolic compounds.

Wild-type and two genetically engineered hybrid poplar lines were pyrolyzed in a micro-pyrolysis (Py-GC/MS) and a bench scale setup for fast and intermediate pyrolysis studies. Principal component analysis showed that the pyrolysis vapors obtained by micro-pyrolysis from wood of caffeic acid O-methyltransferase (COMT) and caffeoyl-CoA O-methyltransferase (CCoAOMT) down-regulated poplar trees differed significantly from the pyrolysis vapors obtained from non-transgenic control trees. Both fast micro-pyrolysis and intermediate pyrolysis of transgenic hybrid poplars showed that down-regulation of COMT can enhance the relative yield of guaiacyl lignin-derived products, while the relative yield of syringyl lignin-derived products was up to a factor 3 lower.

Digestion of high rate activated sludge coupled to biochar formation for soil improvement in the tropics.

High rate activated sludge (HRAS) is well-biodegradable sludge enabling energy neutrality of wastewater treatment plants via anaerobic digestion. However, even through successful digestion a notable residue still remains. Here we investigated whether this residue can be converted to biochar, for its use as a fertilizer or as a solid fuel, and assessed its characteristics and overall process efficiency.

Influence of strain-specific parameters on hydrothermal liquefaction of microalgae.

Algae are an interesting feedstock for producing biofuel via hydrothermal liquefaction (HTL), due to their high water content. In this study, algae slurries (5-7 wt% daf) from different species were liquefied at 250 and 375 °C in batch autoclaves during 5 min. The aim was to analyze the influence of strain-specific parameters (cell structure, biochemical composition and growth environment) on the HTL process.