GO@β-AgMoO Composite: One-Step Synthesis, Characterization, and Photocatalytic Performance against RhB Dye.

The combination of materials to improve properties of interest has become one of the strategies widely used for numerous applications, including new catalysts, over the last few decades. In this study, silver molybdate (β-AgMoO) microcrystals were efficiently obtained by the hydrothermal method, obtaining composites with different amounts of graphene oxide (GO) (1, 2.5, 5, 7.

The Synergic Effect of -MoO, α-MoO, and β-MoO Phase Mixture as a Solid Catalyst to Obtain Methyl Oleate.

Extensive research in the last few decades has conclusively demonstrated the significant influence of experimental conditions, surfactants, and synthesis methods on semiconductors' properties in technological applications. Therefore, in this study, the synthesis of molybdenum oxide (MoO) was reported by the addition of 2.5 (MoO_2.

Solvent Effect on the Structural, Optical, Morphology, and Antimicrobial Activity of Silver Phosphate Microcrystals by Conventional Hydrothermal Method.

The design of particle size and morphology are a promising approach to investigating the properties exhibited by different types of materials. In the present study, the silver phosphate microcrystals (AgPO) were first time synthesized using the hydrothermal and solvothermal method by combination of the solvents water/isopropyl alcohol (SP-IA), water/acetone (SP-AC), water/ammonium hydroxide (AP-AH), all in a ratio of 1:1 (v/v). The synthesized materials were structurally characterized by X-ray diffraction (XRD), Rietveld refinement, and Raman vibrational spectroscopy, where it was confirmed that the pure phase was achieved for all prepared samples.

Synthesis of CaNbO with a Rynersonite-like Structure: Morphology, Rietveld Refinement, Optical, and Vibrational Properties.

In this study, we report the easy and low-cost synthesis of calcium niobate (CaNbO) with the isomorphic structure of the Rynersonite mineral for CaTaO. The samples were prepared by the ball milling method at room temperature at a synthesis time of 0.5, 1, 2, 3, and 4 h.

Study of Metakaolinite Geopolymeric Mortar with Plastic Waste Replacing the Sand: Effects on the Mechanical Properties, Microstructure, and Efflorescence.

In this study, the production of a mortar was proposed in which plastic waste replaced sand by 0%, 50%, and 100% in order to create a sustainable alternative for construction. The performance of the mortars was tested with two types of activators, one with NaOH, as a simple activator, and the other with NaOH and NaSiO, as a compound activator. The effects of the LDPE plastic bag waste and the activators on compressive strength, porosity, microstructure analysis, and efflorescence formation were correlated and discussed.

Effect of the Deposition Time on the Structural, 3D Vertical Growth, and Electrical Conductivity Properties of Electrodeposited Anatase-Rutile Nanostructured Thin Films.

TiO time-dependent electrodeposited thin films were synthesized using an electrophoretic apparatus. The XRD analysis revealed that the films could exhibit a crystalline structure composed of ~81% anatase and ~6% rutile after 10 s of deposition, with crystallite size of 15 nm. AFM 3D maps showed that the surfaces obtained between 2 and 10 s of deposition exhibit strong topographical irregularities with long-range and short-range correlations being observed in different surface regions, a trend also observed by the Minkowski functionals.

Nanoscale morphology and fractal analysis of TiO coatings on ITO substrate by electrodeposition.

In this paper, we introduced an advanced discussion of the 3D morphology of TiO coatings deposited on ITO substrate by electrodeposition under different deposition times. Atomic force microscopy was applied for obtaining topographic images of the samples. The images were processed using the MountainsMap 8.

Pineapple (Ananás comosus) leaves ash as a solid base catalyst for biodiesel synthesis.

Homogeneous catalysts used for biodiesel synthesis have several limitations, including non-recoverability/reusability, saponification, emulsification, equipment corrosion, and environmental pollution. To overcome these limitations, we synthesized a novel catalyst via calcination of pineapple leaves waste. This catalyst was characterized by X-ray powder diffraction, X-ray fluorescence, Fourier transform infrared spectroscopy, thermogravimetric analysis, scanning electron microscopy, and soluble alkalinity measurements.

Structural and Optical Properties of CaCuWO Solid Solution Synthesized by Sonochemistry Method at Room Temperature.

In this work, we report the room-temperature synthesis of pure calcium tungstate (CaWO) and copper-doped calcium tungstate solid solution (CaCuWO) by using a sonochemistry method. These materials were structurally characterized by X-ray diffraction (XRD) and Raman spectroscopy. The obtained XRD patterns were submitted to a Rietveld refinement showing, in both materials, a tetragonal phase with space group and point group of 4 and , respectively.

Antimicrobial properties of α-AgWO rod-like microcrystals synthesized by sonochemistry and sonochemistry followed by hydrothermal conventional method.

In this study we report the synthesis of silver tungstate microcrystals (α-AgWO) by sonochemistry method (SC) at 65 °C and sonochemistry followed by conventional hydrothermal (SC + HC) for 1, 6 and 12 h, at 140 °C. The structural characterization by XRD confirms the alpha phase of the orthorhombic structure and the space group Pn2n, for all synthesized microcrystals. All the actives modes identified at the Raman spectroscopy were characteristic of alpha phase.