Chemical Insights into the Formation of Colloidal Iridium Nanoparticles from In Situ X-ray Total Scattering: Influence of Precursors and Cations on the Reaction Pathway.

Iridium nanoparticles are important catalysts for several chemical and energy conversion reactions. Studies of iridium nanoparticles have also been a key for the development of kinetic models of nanomaterial formation. However, compared to other metals such as gold or platinum, knowledge on the nature of prenucleation species and structural insights into the resultant nanoparticles are missing, especially for nanoparticles obtained from IrCl precursors investigated here.

The Gas Diffusion Electrode Setup as Straightforward Testing Device for Proton Exchange Membrane Water Electrolyzer Catalysts.

Hydrogen production from renewable resources and its reconversion into electricity are two important pillars toward a more sustainable energy use. The efficiency and viability of these technologies heavily rely on active and stable electrocatalysts. Basic research to develop superior electrocatalysts is commonly performed in conventional electrochemical setups such as a rotating disk electrode (RDE) configuration or H-type electrochemical cells.

Self-supported Pt-CoO networks combining high specific activity with high surface area for oxygen reduction.

Several concepts for platinum-based catalysts for the oxygen reduction reaction (ORR) are presented that exceed the US Department of Energy targets for Pt-related ORR mass activity. Most concepts achieve their high ORR activity by increasing the Pt specific activity at the expense of a lower electrochemically active surface area (ECSA). In the potential region controlled by kinetics, such a lower ECSA is counterbalanced by the high specific activity.

Catalyst Development for Water/CO₂ Co-electrolysis.

Herein, we discuss recent research activities on the electrochemical water/CO₂ co-electrolysis at the Department of Chemistry and Biochemistry of the University of Bern (Arenz and Broekmann research groups). For the electrochemical conversion of the greenhouse gas CO₂ into products of higher value catalysts for two half-cell reactions need to be developed, catalysts for the reductive conversion of CO₂ (CO₂RR) as well as catalysts for the oxidative splitting of water (OER: Oxygen Evolution Reaction). In research, the catalysts are often investigated independently of each other as they can later easily be combined in a technical electrolysis cell.

Accelerated Durability Test for High-Surface-Area Oxyhydroxide Nickel Supported on Raney Nickel as Catalyst for the Alkaline Oxygen Evolution Reaction.

We demonstrate a fit-for-purpose accelerated durability test (ADT) of a high-surface-area catalyst for the alkaline oxygen evolution reaction (OER). Using an automatized electrochemical setup enabled us to run a complex ADT protocol including online detection of the effective solution resistance as well as linear voltammetry, cyclic voltammetry, cyclic galvanograms, and electrochemical impedance spectroscopy (EIS) for 55 h in total. Using this protocol, we tested the service life stability of a nickel oxyhydroxide (NiOx) catalyst based on Raney Ni.

Examining the Structure Sensitivity of the Oxygen Evolution Reaction on Pt Single-Crystal Electrodes: A Combined Experimental and Theoretical Study.

In the present work we investigate the structure sensitivity of the oxygen evolution reaction (OER) combining electrochemistry, in situ spectroscopy and density functional theory calculations. The intrinsic difficulty of such studies is the fact that at electrode potentials where the OER is observed, the electrode material is highly oxidized. As a consequence, the surface structure during the reaction is in general ill-defined and only scarce knowledge exists concerning the structure-activity relationship of this important reaction.

Colloids for Catalysts: A Concept for the Preparation of Superior Catalysts of Industrial Relevance.

Compared to conventional preparation methods for supported heterogeneous catalysts, the use of colloidal nanoparticles (NPs) allows for a precise control over size, size distribution, and distribution/location of the NPs on the support. However, common colloidal syntheses have restrictions that limit their applicability for industrial catalyst preparation. We present a simple, surfactant-free, and scalable preparation method for colloidal NPs to overcome these restrictions.