Comparative analysis of metal oxide nanoparticle accumulation in landfill gas engine combustion chambers: Insights from three sites.

Combustion chamber deposits adversely affect the operating performance of gas engines. In this study, the elemental composition of deposit samples collected from the inner surface of combustion chambers in gas engines across three different facilities was examined using various methods. The proportional changes in metal oxides along the internal cross-sectional surfaces of the deposits were examined to depict the deposit formation process from beginning to end.

Fabrication and Packaging of CMUT Using Low Temperature Co-Fired Ceramic.

This paper presents fabrication and packaging of a capacitive micromachined ultrasonic transducer (CMUT) using anodically bondable low temperature co-fired ceramic (LTCC). Anodic bonding of LTCC with Au vias-silicon on insulator (SOI) has been used to fabricate CMUTs with different membrane radii, 24 µm, 25 µm, 36 µm, 40 µm and 60 µm. Bottom electrodes were directly patterned on remained vias after wet etching of LTCC vias.

Highly efficient inverted organic light emitting diodes by inserting a zinc oxide/polyethyleneimine (ZnO:PEI) nano-composite interfacial layer.

The electrode/organic interface is one of the key factors in attaining superior device performance in organic electronics, and inserting a tailor-made layer can dramatically modify its properties. The use of nano-composite (NC) materials leads to many advantages by combining materials with the objective of obtaining a desirable combination of properties. In this context, zinc oxide/polyethyleneimine (ZnO:PEI) NC film was incorporated as an interfacial layer into inverted bottom-emission organic light emitting diodes (IBOLEDs) and fully optimized.