One-step fiber post cementation and core build-up in endodontically treated tooth: A clinical case report.

Objective: This clinical case report addresses the step-by-step of the application of a core-and-post system that uses a single resin composite material to fiber post cementation and core build-up in a maxillary left central incisor.

Clinical Considerations: The literature reports several materials and methods for the restoration of endodontically treated teeth with coronal destruction that require an intra-radicular fiber post for the core build-up. The present case report describes a core-and-post or "monoblock" technique.

Fatigue behavior and surface characterization of a Y-TZP after laboratory grinding and regeneration firing.

This study evaluated the effect of grinding and regeneration firing on the flexural fatigue limit and surface characterization of Lava™ Y-TZP ceramic. Forty bar-shaped specimens with 20 × 4.0 × 1.

Marginal Fit of Metal-Ceramic Copings: Effect of Luting Cements and Tooth Preparation Design.

Purpose: To evaluate the effect of the triad finish line design, axial wall convergence angle, and luting cement on the marginal fit of metal copings used in metal-ceramic crowns.

Materials And Methods: Schematic dies and their respective copings were cast in NiCr alloy. The dies exhibited the following finish line/convergence angle combinations: sloping shoulder/6°, sloping shoulder/20°, shoulder/6°, shoulder/20°.

Influence of Particle and Air-Abrasion Moment on Y-TZP Surface Characterization and Bond Strength.

Purpose: To evaluate the influence of particle and air-abrasion on the surface characterization and shear bond strength (SBS) of a Y-TZP ceramic with a resin cement.

Materials And Methods: Y-TZP specimens were air-abraded with 50 μm alumina particles; 120 μm alumina particles; 30 μm silica-coated alumina particles (Rocatec Soft); 110 μm silica-coated alumina particles (Rocatec Plus). Air-abrasion was performed before (BS); after (AS); before and after (BAS) zirconia sintering.

Accuracy of Gypsum Casts after Different Impression Techniques and Double Pouring.

This study evaluated the accuracy of gypsum casts after different impression techniques and double pouring. Ten patients were selected and for each one it was obtained 5 partial putty/wash impressions with vinyl polysiloxane (VPS) material from teeth #13 to #16 with partial metal stock trays. The following techniques were performed: (1) one-step; two-step relief with: (2) PVC film; (3) slow-speed tungsten carbide bur and scalpel blade, (4) small movements of the tray and (5) without relief-negative control.