New Opportunities in the Valorization of Technical Lignins.

Sugar-based biorefineries have faced significant economic challenges. Biorefinery lignins are often classified as low-value products (fuel or low-cost chemical feedstock) mainly due to low lignin purities in the crude material. However, recent research has shown that biorefinery lignins have a great chance of being successfully used as high-value products, which in turn should result in an economy renaissance of the whole biorefinery idea.

Lignin structural variation in hardwood species.

A comprehensive lignin structure analysis of ten industrially relevant hardwood species is presented. Milled wood lignin (MWL) was isolated from each species using a modified protocol and all milled wood lignin preparations were analyzed through quantitative (13)C NMR spectroscopy, elemental analysis, methoxyl analysis, sugar analysis, and nitrobenzene oxidation. Nitrobenzene oxidation and ozonation were carried out on extractive-free wood, alkali-extracted wood, milled wood lignin, and alkali-extracted lignin.

Lignin changes after steam explosion and laccase-mediator treatment of eucalyptus wood chips.

Eucalyptus globulus chips were steam exploded followed by treatment with a laccase-mediator system (LMS) under different experimental conditions. Removal of hemicelluloses and, to a lesser extent, lignin was observed. Thermogravimetic analyses of whole meal obtained from chips before and after steam explosion indicated an increase in lignin degradation temperature due to lignin condensation.

Quantitative characterization of a hardwood milled wood lignin by nuclear magnetic resonance spectroscopy.

The structure of Eucalyptus grandis milled wood lignin (MWL) was investigated by 2D 1H-13C HSQC, HMQC, and 1H-1H TOCSY correlation NMR techniques and by quantitative 13C NMR as well as by the permanganate oxidation degradation technique. The combination of 2D NMR and quantitative 13C NMR spectroscopy of nonacetylated and acetylated lignin preparations allowed reliable identification and calculation of the amount of different lignin structures. About 85% of side-chain moieties were estimated on the structural level.

A comprehensive approach for quantitative lignin characterization by NMR spectroscopy.

A detailed approach for the quantification of different lignin structures in milled wood lignin (MWL) has been suggested using a combination of NMR techniques. 1H-13C heteronuclear multiple quantum coherence and quantitative 13C NMR of nonacetylated and acetylated spruce MWL have been found to have a synergetic effect, resulting in significant progress in the characterization of lignin moieties by NMR. About 80% of side chain moieties, such as different beta-O-4, dibenzodioxocin, phenylcoumaran, pinoresinol, and others, have been identified on the structural level.

Comparative studies on the delignification of pine kraft-anthraquinone pulp with hydrogen peroxide by binucleus Mn(IV) complex catalysis.

Pine kraft-anthraquinone (kraft-AQ) pulp was bleached in alkaline solution with hydrogen peroxide catalyzed by either [L(1)Mn(IV)(micro-O)(3)Mn(IV)L(1)](PF(6))(2)] (C1) or [LMn(IV)(2)(micro-O)(3)] (ClO(4))(2) (C2) at 60 and 80 degrees C for 120 min with a catalyst charge of 10 ppm on pulp. The resulting bleached pulp was hydrolyzed with cellulase to obtain insoluble and soluble residual lignins. The alkaline bleaching effluents were acidified to precipitate alkaline-soluble lignins.

Elucidation of the structures of residual and dissolved pine kraft lignins using an HMQC NMR technique.

Comparative studies on the structures of residual and dissolved lignins isolated from pine kraft pulp and pulping liquor have been undertaken using the (1)H-(13)C HMQC NMR technique, GPC, and sugar analysis to elucidate the reaction mechanisms in kraft pulping and the lignin reactivity. A modified procedure for the isolation of enzymatic residual lignins has resulted in an appreciable decrease in protein contaminants in the residual lignin preparations (N content < 0.2%).

Reaction mechanisms in delignification of pine Kraft-AQ pulp with hydrogen peroxide using Mn(IV)-Me4DTNE as catalyst.

Pine Kraft-AQ pulp was bleached with hydrogen peroxide catalyzed by [LMn(IV)(2) (mu-O)(3)](ClO(4))(2) at 80 degrees C for 120 min under optimum reaction conditions. The resulting bleached pulp was hydrolyzed with cellulase to obtain insoluble and soluble residual lignins. The alkaline effluent from the bleaching was acidified to precipitate alkaline soluble lignin.