High-Intensity Sweeteners in Alternative Tobacco Products.

Introduction: Sweeteners in tobacco products may influence use initiation and reinforcement, with special appeal to adolescents. Recent analytical studies of smokeless tobacco products (snuff, snus, dissolvables) detected flavorants identical to those added to confectionary products such as hard candy and chewing gum. However, these studies did not determine the levels of sweeteners.

Depolymerization of organosolv lignin using doped porous metal oxides in supercritical methanol.

An isolated, solvent-extracted lignin from candlenut (Aleurites moluccana) biomass was subjected to catalytic depolymerization in the presence of supercritical methanol, using a range of porous metal oxides derived from hydrotalcite-like precursors. The most effective catalysts in terms of lignin conversion to methanol-soluble products, without char formation, were based on copper in combination with other dopants based on relatively earth-abundant metals. Nearly complete conversion of lignin to bio-oil composed of monomers and low-mass oligomers with high aromatic content was obtained in 6h at 310°C using a catalyst based on a Cu- and La-doped hydrotalcite-like precursor.

Preferential technological and life cycle environmental performance of chitosan flocculation for harvesting of the green algae Neochloris oleoabundans.

Dewatering of the green algae Neochloris oleoabundans by flocculation was investigated for chitosan biopolymer, ferric sulfate, and alum. Chitosan was found to be most effective flocculant, with an optimum dose of 100mg/L algae broth. Zeta potential measurements suggest the mechanism involves both adsorption and charge neutralization processes.

Magnetic Field Alignment of a Diblock Copolymer Using a Supramolecular Route.

Large-area uniform magnetic alignment of a self-assembled diblock copolymer has been achieved by the selective sequestration of rigid moieties with anisotropic diamagnetic susceptibility within one block of the system. The species is based on a biphenyl core and is confined in the acrylic acid domains of a poly(styrene--acrylic acid) block copolymer by hydrogen bonding between an imidazole headgroup and the acrylic acid units. Microphase separation produces hierarchically ordered systems of smectic layers within lamellae and smectic layers in the matrix surrounding hexagonally packed poly(styrene) cylinders, as a function of imidazole/acrylic acid stoichiometry.

Derivation and synthesis of renewable surfactants.

This critical review focuses on the origins and preparation of bio-based surfactants, defined here as non-soap, amphiphilic molecules in which the carbon atoms are derived from annually renewable feedstocks. Environmental concerns and market pressures have led to greater relevance of these chemicals in commercial applications in recent years and extensive research has gone into exploring new classes of surfactants. Highlighted here are examples of bio-based surfactants that are produced on an industrial scale and/or are based on abundant starting materials.

Rapid, biomimetic degradation in water of the persistent drug sertraline by TAML catalysts and hydrogen peroxide.

Iron TAML activators (oxidation catalysts based upon tetraamido macrocyclic ligands) at nanomolar concentrations in water activate hydrogen peroxide to rapidly degrade sertraline, the persistent, active pharmaceutical ingredient (API) in the widely used drug Zoloft. Although all the API is readily consumed, degradation slows significantly at one intermediate, sertraline ketone. The process occurs from neutral to basic pH.

Accelerated solvent extraction of lignin from Aleurites moluccana (Candlenut) nutshells.

Lignin from candlenut shells was isolated using an ethanol-water accelerated solvent extraction method. Yields (based on Klason lignin) increased from about 14 to 33% as temperature increased from 100 to 195 °C and were also influenced by the amount of aqueous acid used to precipitate lignin from the extraction liquor. These yields were higher than could be obtained using a conventional dioxane-water acidolysis method.

Destruction of estrogens using Fe-TAML/peroxide catalysis.

Endocrine disrupting chemicals (EDCs) impair living organisms by interfering with hormonal processes controlling cellular development Reduction of EDCs in water by an environmentally benign method is an important green chemistry goal. One EDC, 17alpha-ethinylestradiol (EE2), the active ingredient in the birth control pill, is excreted by humans to produce a major source of artificial environmental estrogenicity, which is incompletely removed by currenttechnologies used by municipal wastewater treatment plants (MWTPs). Natural estrogens found in animal waste from concentrated animal feeding operations (CAFOs) can also increase estrogenic activity of surface waters.

Attaining control by design over the hydrolytic stability of Fe-TAML oxidation catalysts.

The iron(III) complexes of tetra amidato macrocyclic ligands (TAMLs) ([Fe{1-X1-2-X2C6H2-4,5-(NCOCMe2NCO)2CR2}(OH2)]- , 1: X1 = X2 = H, R2 = Me2 (a), R2 = (CH2)2 (b); X1 = X2 = Cl, R2 = F2 (c), etc.), which the proton is known to demetalate at pH < 3, are also subject to catalyzed demetalation by Brønsted acid buffer components at pH 4-9 such as H2PO4-, HSO3-, and CH3CO2H, HO2CCH2CO2-. Buffers based on pyridine (py) and tris(hydroxymethyl)aminomethane (TRIS) are catalytically inactive.

Catalytically active mu-Oxodiiron(IV) oxidants from Iron(III) and dioxygen.

The reaction between an Fe(III) complex and O(2) to afford a stable catalytically active diiron(IV)-mu-oxo compound is described. Phosphonium salts of orange five-coordinated Fe(III)-TAML complexes with an axial aqua ligand ([PPh(4)]1-H(2)O, tetraamidato macrocyclic Fe(III) species derived from 3,3,6,6,9,9-hexamethyl-3,4,8,9-tetrahydro-1H-1,4,8,11-benzotetraazacyclotridecine-2,5,7,10(6H,11H)-tetraone) react rapidly with O(2) in CH(2)Cl(2) or other weakly coordinating solvents to produce black mu-oxo-bridged diiron(IV) complexes, 2, in high yields. Complexes 2 have been characterized by X-ray crystallography (2 cases), microanalytical data, mass spectrometry, UV/Vis, Mossbauer, and (1)H NMR spectroscopies.