Environmental monitoring of hydrophobic organic contaminants: the case of mussels versus semipermeable membrane devices.

Concentrations of hydrophobic chemicals in mussels and semipermeable membrane devices (SPMDs) from nine studies published over the past decade, amended with new data obtained in the Scheldt-North Sea area, were assessed to understand the similarities and differences between these sampling matrixes. A model was developed to describe the concentration ratios, using literature values of elimination rate constants and steady-state accumulation factors of both samplers as key parameters. The model could successfully describe the results of seven studies.

Temperature-dependent uptake rates of nonpolar organic compounds by semipermeable membrane devices and low-density polyethylene membranes.

The effect of temperature on sampling rates and sampler-water partition coefficients of semipermeable membrane devices (SPMDs) and low-density polyethylene (LDPE) strips was studied in an experimental setup under controlled flow conditions. Aqueous concentrations of chlorobenzenes, polychlorinated biphenyls (PCBs), and polyaromatic hydrocarbons (PAHs) were maintained by continuous circulation of the water over a generator column. Sampling rates for standard design SPMDs (460 cm2) were in the range of 20-200 L d(-1).

Spiking of performance reference compounds in low density polyethylene and silicone passive water samplers.

A method for spiking performance reference compounds (PRCs) into low density polyethylene (LDPE) and silicone polymers is described. This method is based on equilibration of the polymers in aqueous/methanolic solutions of PRCs. Equilibration times range from minutes to hours for perdeuterated polyaromatic hydrocarbons (PAHs) and polychlorinated biphenyls (PCBs) with a hydrophobicity in the range 3.