Formulation and investigation of hydrogels containing an increased level of diclofenac sodium using risk assessment tools.

Transdermal delivery of active ingredients is a challenge for pharmaceutical technology due to their inadequate penetration properties and the barrier function of the skin. The necessity of painless, effective, topical therapy for the aging population is growing, and a variety of diclofenac sodium-containing semi-solid preparations are available to alleviate the symptoms of these ailments. Our purpose was to formulate a novel composition with higher drug content to enhance drug release and permeation, thereby providing more effective therapy.

In situ gelation of thiolated poly(aspartic acid) derivatives through oxidant-free disulfide formation for ophthalmic drug delivery.

Efficient topical treatment of ocular diseases requires a prolonged residence time of drug formulations. An in situ gelling, mucoadhesive system can provide improved residence time while keeps the installation of the formulation easy and accurate due to its low initial viscosity. We synthesized a two-component, biocompatible water-based liquid formulation showing in situ gelation upon mixing.

Development of Capsaicin-Containing Analgesic Silicone-Based Transdermal Patches.

Transdermal therapeutic systems (TTSs) enable convenient dosing in drug therapy. Modified silicone-polymer-based patches are well-controlled and cost-effective matrix diffusion systems. In the present study, we investigated the substance release properties, skin penetration, and analgesic effect of this type of TTS loaded with low-dose capsaicin.

Analytical Quality by Design (AQbD) Approach to the Development of In Vitro Release Test for Topical Hydrogel.

The aim of our study was to adapt the analytical quality by design (AQbD) approach to design an effective in vitro release test method using USP apparatus IV with a semi-solid adapter (SSA) for diclofenac sodium hydrogel. The analytical target profile (ATP) of the in vitro release test and ultra-high-performance liquid chromatography were defined; the critical method attributes (CMAs) (min. 70% of the drug should be released during the test, six time points should be obtained in the linear portion of the drug release profile, and the relative standard deviation of the released drug should not be over 10%) were selected.

Investigation of the effect of polymers on dermal foam properties using the QbD approach.

Dermal foams are promising drug delivery systems due to their many advantages and ease of application. Foams are also considered a novelty in the field of dermatology. In particular, they are beneficial for the treatment of skin conditions where patients have highly inflamed, swollen, infected and sensitive skin, as the application of the foam to the skin surface to be treated minimizes the need for skin contact.

Comparison of Synthetic Membranes to Heat-Separated Human Epidermis in Skin Permeation Studies In Vitro.

In recent years, the study of dermal preparations has received increased attention. There are more and more modern approaches to evaluate transdermal formulations, which are crucial in proving the efficacy of a formulation. The aim of this study was to compare permeation across innovative synthetic membranes (Strat-M and Skin PAMPA membranes) and heat-separated human epidermis (HSE, gold standard membrane) using four different dermal formulations.

Rheological effects of hypertonic saline and sodium bicarbonate solutions on cystic fibrosis sputum in vitro.

Background: Cystic fibrosis (CF) is a life-threatening multiorgan genetic disease, particularly affecting the lungs, where recurrent infections are the main cause of reduced life expectancy. In CF, mutations in the gene encoding the cystic fibrosis transmembrane conductance regulator (CFTR) protein impair transepithelial electrolyte and water transport, resulting in airway dehydration, and a thickening of the mucus associated with abnormal viscoelastic properties. Our aim was to develop a rheological method to assess the effects of hypertonic saline (NaCl) and NaHCO on CF sputum viscoelasticity in vitro, and to identify the critical steps in sample preparation and in the rheological measurements.

Electrospun Scaffolds in Periodontal Wound Healing.

Periodontitis is a set of inflammatory conditions affecting the tissues surrounding the teeth predominantly sustained by bacterial infections. The aim of the work was the design and the development of scaffolds based on biopolymers to be inserted in the periodontal pocket to restore tissue integrity and to treat bacterial infections. Nanofibrous scaffolds were prepared by means of electrospinning.

QbD-Based Investigation of Dermal Semisolid in situ Film-Forming Systems for Local Anaesthesia.

Purpose: The aim of our research work was to develop dermally applicable, lidocaine hydrochloride (LID-HCl)-containing semisolid in situ film-forming systems (FFSs) using the Quality by Design (QbD) approach to increase drug permeation into the skin.

Methods: Silicones were used to improve the properties of formulations and to increase the permeation through the skin. The QbD approach was applied to ensure quality-based development.

Novel In Vitro Investigational Methods for Modeling Skin Permeation: Skin PAMPA, Raman Mapping.

The human skin is marked as a standard by the regulatory agencies in the permeation study of dermal formulations. Artificial membranes can substitute human skin to some extent. Academicians and pharmaceutical corporations are focusing their efforts on developing standardized protocols and safe, reliable options to substitute human skin for carrying out permeability studies.

Effects of Formulation Excipients on Skin Barrier Function in Creams Used in Pediatric Care.

Semisolid dosage forms are recommended for the dermal care of babies and children. If we look at the ingredients of these preparations, there are still many cases in which there are substances (occlusive agents, preservatives) that no longer meet certain requirements of the modern age, so it is timely to replace them with other substances. The aim of this work was to formulate a science-based formulation with new components that keep or improve its moisturizing properties, rheological parameters, and microbiological stability.

Development and Characterization of Potential Ocular Mucoadhesive Nano Lipid Carriers Using Full Factorial Design.

Generally, topically applied eye drops have low bioavailability due to short residence time and low penetration of the drug. The aim of the present study was to incorporate dexamethasone (DXM) into nano lipid carriers (NLC), which contain mucoadhesive polymer, in order to increase the bioavailability of the drug. A 2 factorial experimental design was applied, in which the three factors were the polymer, the DXM, and the emulsifier concentrations.

Comparison of hydrophilic ophthalmic media on silicone oil emulsification.

The aim of this study was to investigate whether and how the biological media which are in contact with silicone oil play a role in the silicone emulsification process. Commercially available Oxane 1300 silicone oil and potential hydrophilic phases of the emulsions in the eye (porcine aqueous humor, porcine vitreous and balanced salt solution) were investigated separately and in a mixture or emulsions by means of surface tension, rheological, zeta potential measurements and microscopic investigation. The surface tension of biological media (vitreous and aqueous humor) was significantly lower than that of non-biological media, especially in the case of aqueous humor, which indicates a remarkable emulsification tendency with these phases.

Electrospun PLA Fibers Containing Metronidazole for Periodontal Disease.

Purpose: Electrospun PLA fiber devices were investigated in the form of fiber mats and disks. Metronidazole was used as an active agent; its concentration was 12.2 and 25.

Design and Optimization of Nanostructured Lipid Carrier Containing Dexamethasone for Ophthalmic Use.

The aim of this study was to perform a preformulation study of dexamethasone (DXM)-loaded nanostructured lipid carriers (NLCs) for ocular use. Lipid screening was applied to find the most suitable solid and liquid lipids and surfactant for the NLC formulation. The visual observation was proved with XRD measurements for the establishment of the soluble state of DXM.

Investigation of Silicone-Containing Semisolid in Situ Film-Forming Systems Using QbD Tools.

The aim of our research work was to develop dermally applicable, semisolid film-forming systems (FFSs) containing silicones, which form a film on the skin in situ, with suitable mechanical properties for skin application. FFSs were developed and investigated by means of the Quality by Design (QbD) methodology. With this QbD approach, the initial risk assessment defines the critical quality attributes (CQAs), the critical material attributes (CMAs) and the critical process parameters (CPPs) to ensure the required quality.

Nanostructured Lipid Carrier Gel for the Dermal Application of Lidocaine: Comparison of Skin Penetration Testing Methods.

The aim of this research was to investigate the stability of a lidocaine-loaded nanostructured lipid carrier dispersion at different temperatures, formulate a nanostructured lipid carrier gel, and test the penetration profile of lidocaine from the nanostructured lipid carrier gel using different skin penetration modeling methods. The formulations were characterized by laser diffraction, rheological measurements and microscopic examinations. Various in vitro methods were used to study drug release, diffusion and penetration.

Combination of Zinc Hyaluronate and Metronidazole in a Lipid-Based Drug Delivery System for the Treatment of Periodontitis.

Background: Despite being a highly prevalent disease and a possible contributor to adult tooth loss, periodontitis possesses no well-established therapy. The aim of the recent study was the development and evaluation of a mucoadhesive monophase lipid formulation for the sustained local delivery of amoxicillin, metronidazole, and/or zinc hyaluronate or gluconate.

Methods: To investigate our formulations, differential scanning calorimetry, X-ray diffraction, swelling, erosion, mucoadhesivity, drug release, and antimicrobial measurements were performed.

Development of Topical Nanocarriers for Skin Cancer Treatment Using Quality by Design Approach.

Background: One of the most compelling medical challenges of this century is the treatment of cancer and among them, skin cancer is the most common type. Thus, current treatments need to be renewed continuously to handle this challenge.

Objective: This review presents considerations which can be employed during the development of nanosized formulations dedicated to the topical treatment of skin cancer.

Papaverine hydrochloride containing nanostructured lyotropic liquid crystal formulation as a potential drug delivery system for the treatment of erectile dysfunction.

Purpose: Papaverine hydrochloride (PaHCl) is an old, well-known drug with spasmolytic activity but it has therapeutic effect in erectile dysfunction, too. As an intracavernous injection, it is not used in urologic clinics today because the side effects of the injection are pain, scarring or priapism. Our aim was to develop and test a topical semi-solid preparation containing PaHCl that would provide an alternative administration option by eliminating the undesirable side effects of the injection.

Development of prednisolone-containing eye drop formulations by cyclodextrin complexation and antimicrobial, mucoadhesive biopolymer.

Purpose: The formulation of topical ophthalmic products with appropriate therapeutic effect and patient compliance is a major challenge. To increase the efficiency of the ocular delivery of the drug, the enhancement of water solubility and the contact time of the drug on the surface of the cornea are necessary. In this work, prednisolone (PR)-containing eye drops were formulated with antimicrobial, mucoadhesive biopolymer and PR-cyclodextrin inclusion complex.

Stratum corneum lipid liposomes for investigating skin penetration enhancer effects.

Knowledge of the mechanism of action of skin penetration enhancers is essential to formulators for optimizing formulations and to maximize the efficacy of enhancers. To obtain information about the effects of penetration enhancers as a fast initial screening, investigations have been performed to identify possible correlations of the biological effectiveness of penetration enhancers with their interaction with a well-defined model system consisting of skin mimic lipid bilayers, as determined by calcein release experiments using stratum corneum lipid liposomes (SCLLs). We aimed to investigate the enhancing effects of different concentrations of two chemical penetration enhancers, Kolliphor RH40 and Transcutol on SCLLs.

Electroporation-enhanced transdermal diclofenac sodium delivery into the knee joint in a rat model of acute arthritis.

Purpose: Since electroporation (EP) can increase the permeability of biological membranes, we hypothesized that it offers an opportunity to enhance the transdermal delivery of drugs for intra-articular indications. Our aim was to compare the anti-inflammatory and analgesic efficacy of EP-combined topical administration of diclofenac sodium hydrogel (50 mg mL in 230 µL volume) with that of an equivalent dose of oral (75 mg kg) and simple topical administration.

Methods: Arthritis was induced with the injection of 2% λ-carrageenan and 4% kaolin into the right knee joints of male Sprague Dawley rats.

Following-up skin penetration of lidocaine from different vehicles by Raman spectroscopic mapping.

The application of local anesthetics, usually administered by subcutaneous injection, is common in the course of diagnostic, therapeutic, and cosmetic dermatology procedures. The effective dermal delivery of lidocaine could offer a solution to many adverse effects caused by needle insertion, such as pain, local reactions or toxicity, and additionally, it avoids the disruption of anatomical landmarks. Therefore, novel dermal formulations of local anesthetics are needed to overcome the barrier function of the skin and provide sufficient and prolonged anesthesia.

Mucoadhesive Cyclodextrin-Modified Thiolated Poly(aspartic acid) as a Potential Ophthalmic Drug Delivery System.

Thiolated poly(aspartic acid) is known as a good mucoadhesive polymer in aqueous ophthalmic formulations. In this paper, cyclodextrin-modified thiolated poly(aspartic acid) was synthesized for the incorporation of prednisolone, a lipophilic ophthalmic drug, in an aqueous in situ gellable mucoadhesive solution. This polymer combines the advantages of cyclodextrins and thiolated polymers.