Dibenzodioxin-Based Polymers of Intrinsic Microporosity with Enhanced Transport Properties for Lithium Ions in Aqueous Media.

Boosting the transport and selectivity properties of membranes based on polymers of intrinsic microporosity (PIMs) toward one specific working analyte of interest is challenging. In this work, a novel family of PIM membranes, prepared by casting and exhibiting optima mechanical properties and high thermal stability, was synthesized from 4,4'-(2,2,2-trifluoro-1-phenylethane-1,1-diyl) bis(benzene-1,2-diol) and two tetrafluoro-nitrile derivatives. Gas permeability measurements evidenced a CO/CH selectivity up to 170% relative to the reference polymer, PIM-1, in agreement with their calculated fractional free volume and the analysis of the textural properties by N and CO gas adsorption.

Effect of Preparation Methods on the Interface of LiBH/SiO Nanocomposite Solid Electrolytes.

Nanocomposites of complex metal hydrides and oxides are promising solid state electrolytes. The interaction of the metal hydride with the oxide results in a highly conducting interface layer. Up until now it has been assumed that the interface chemistry is independent of the nanoconfinement method.

Tunneling Interpenetrative Lithium Ion Conduction Channels in Polymer-in-Ceramic Composite Solid Electrolytes.

Polymer-in-ceramic composite solid electrolytes (PIC-CSEs) provide important advantages over individual organic or inorganic solid electrolytes. In conventional PIC-CSEs, the ion conduction pathway is primarily confined to the ceramics, while the faster routes associated with the ceramic-polymer interface remain blocked. This challenge is associated with two key factors: (i) the difficulty in establishing extensive and uninterrupted ceramic-polymer interfaces due to ceramic aggregation; (ii) the ceramic-polymer interfaces are unresponsive to conducting ions because of their inherent incompatibility.

Re-investigating the structure-property relationship of the solid electrolytes Li In Zr Cl and the impact of In-Zr(iv) substitution.

Chloride-based solid electrolytes are considered interesting candidates for catholytes in all-solid-state batteries due to their high electrochemical stability, which allows the use of high-voltage cathodes without protective coatings. Aliovalent Zr(iv) substitution is a widely applicable strategy to increase the ionic conductivity of LiM(iii)Cl solid electrolytes. In this study, we investigate how Zr(iv) substitution affects the structure and ion conduction in Li In Zr Cl (0 ≤ ≤ 0.

Self-organized hetero-nanodomains actuating super Li conduction in glass ceramics.

Easy-to-manufacture LiS-PS glass ceramics are the key to large-scale all-solid-state lithium batteries from an industrial point of view, while their commercialization is greatly hampered by the low room temperature Li conductivity, especially due to the lack of solutions. Herein, we propose a nanocrystallization strategy to fabricate super Li-conductive glass ceramics. Through regulating the nucleation energy, the crystallites within glass ceramics can self-organize into hetero-nanodomains during the solid-state reaction.

Aluminium ion doping mechanism of lithium thiophosphate based solid electrolytes revealed with solid-state NMR.

We investigate the impact of Al incorporation on the structure and dynamics of Al-doped lithium thiophosphates (LiAlPS) based on β-LiPS. Al and Li magic-angle spinning NMR spectra confirm that Al ions occupy octahedral sites in the structure. Quantitative analyses of Al NMR spectra show that the maximum Al incorporation is = 0.

A Water-Free In Situ HF Treatment for Ultrabright InP Quantum Dots.

Indium phosphide quantum dots are the main alternative for toxic and restricted Cd-based quantum dots for lighting and display applications, but in the absence of protecting ZnSe and/or ZnS shells, InP quantum dots suffer from low photoluminescence quantum yields. Traditionally, HF treatments have been used to improve the quantum yield of InP to ∼50%, but these treatments are dangerous and not well understood. Here, we develop a postsynthetic treatment that forms HF in situ from benzoyl fluoride, which can be used to strongly increase the quantum yield of InP core-only quantum dots.

Improving Li-ion interfacial transport in hybrid solid electrolytes.

The development of commercial solid-state batteries has to date been hindered by the individual limitations of inorganic and organic solid electrolytes, motivating hybrid concepts. However, the room-temperature conductivity of hybrid solid electrolytes is still insufficient to support the required battery performance. A key challenge is to assess the Li-ion transport over the inorganic and organic interfaces and relate this to surface chemistry.

Multicore Liquid Perfluorocarbon-Loaded Multimodal Nanoparticles for Stable Ultrasound and F MRI Applied to In Vivo Cell Tracking.

Ultrasound is the most commonly used clinical imaging modality. However, in applications requiring cell-labeling, the large size and short active lifetime of ultrasound contrast agents limit their longitudinal use. Here, 100 nm radius, clinically applicable, polymeric nanoparticles containing a liquid perfluorocarbon, which enhance ultrasound contrast during repeated ultrasound imaging over the course of at least 48 h, are described.

Manipulating the Optical Properties of Carbon Dots by Fine-Tuning their Structural Features.

As a new class of sustainable carbon material, "carbon dots" is an umbrella term covering many types of materials. Herein, a broad range of techniques was used to develop the understanding of hydrothermally synthesized carbon dots, and it is shown how fine-tuning the structural features by simple reduction/oxidation reactions can drastically affect their excited-state properties. Structural and spectroscopic studies found that photoluminescence originates from direct excitation of localized fluorophores involving oxygen functional groups, whereas excitation at graphene-like features leads to ultrafast phonon-assisted relaxation and largely quenches the fluorescent quantum yields.

The Rich Solid-State Phase Behavior of l-Phenylalanine: Disappearing Polymorphs and High Temperature Forms.

After years of controversy over the solid state structure of the essential amino acid l-phenylalanine, four different polymorphic forms were published recently. The common form I has symmetry 2 with four molecules in the asymmetric unit (' = 4), similar to form III, but with a different arrangement of molecular bilayers. Form II, obtained from the hydrate at very low humidity, is unrelated to forms I and III, as is the high-density form IV.

The Rich Solid-State Phase Behavior of dl-Aminoheptanoic Acid: Five Polymorphic Forms and Their Phase Transitions.

The rich landscape of enantiotropically related polymorphic forms and their solid-state phase transitions of dl-2-aminoheptanoic acid (dl-AHE) has been explored using a range of complementary characterization techniques, and is largely exemplary of the polymorphic behavior of linear aliphatic amino acids. As many as five new polymorphic forms were found, connected by four fully reversible solid-state phase transitions. Two low temperature forms were refined in a high ' crystal structure, which is a new phenomenon for linear aliphatic amino acids.

Facile Synthesis toward the Optimal Structure-Conductivity Characteristics of the Argyrodite LiPSCl Solid-State Electrolyte.

The high Li-ion conductivity of the argyrodite LiPSCl makes it a promising solid electrolyte candidate for all-solid-state Li-ion batteries. For future application, it is essential to identify facile synthesis procedures and to relate the synthesis conditions to the solid electrolyte material performance. Here, a simple optimized synthesis route is investigated that avoids intensive ball milling by direct annealing of the mixed precursors at 550 °C for 10 h, resulting in argyrodite LiPSCl with a high Li-ion conductivity of up to 4.

Probing Interactions between Electron Donors and the Support in MgCl-Supported Ziegler-Natta Catalysts.

Olefin polymerization using Ziegler-Natta catalysts (ZNCs) is an important industrial process. Despite this, fundamental insight into the inner working mechanisms of these catalysts remains scarce. Here, we focus on the low-γ nuclei Mg and Cl for an in-depth solid-state NMR and density functional theory (DFT) study of the catalyst's MgCl support in binary adducts prepared by ball-milling.

Structural Characterization of Electron Donors in Ziegler-Natta Catalysts.

Ziegler-Natta catalysis is a very important industrial process for the production of polyolefins. However, the catalysts are not well-understood at the molecular level. Yet, atomic-scale structural information is of pivotal importance for rational catalyst development.

The coordinative state of aluminium alkyls in Ziegler-Natta catalysts.

The most commonly used cocatalyst species in Ziegler-Natta catalysts are aluminium alkyls. In this study we aim to find the interaction between aluminium centres of these activators and other components in the ZNC system. Initially we look at binary systems of Al-alkyl/MgCl and ternary systems of Al-alkyl/MgCl/TiCl, followed by donor containing systems.

Influence of Levulinic Acid Hydrogenation on Aluminum Coordination in Zeolite-Supported Ruthenium Catalysts: A Al 3QMAS Nuclear Magnetic Resonance Study.

The influence of a highly oxygenated, polar protic reaction medium, that is, levulinic acid in 2-ethylhexanoic acid, on the dealumination of two zeolite-supported ruthenium catalysts, namely Ru/H-β and Ru/H-ZSM-5, has been investigated by Al triple-quantum magic-angle spinning nuclear magnetic resonance spectroscopy (3QMAS NMR). Upon use of these catalysts in the hydrogenation of levulinic acid, the heterogeneity in aluminum speciation is found to increase for both Ru/H-ZSM-5 and Ru/H-β. For Ru/H-ZSM-5, the symmetric, tetrahedral framework aluminum species (FAL) were found to be mainly converted into distorted tetrahedral FAL species, with limited loss of aluminum to the solution by leaching.

Unravelling Li-Ion Transport from Picoseconds to Seconds: Bulk versus Interfaces in an Argyrodite Li6PS5Cl-Li2S All-Solid-State Li-Ion Battery.

One of the main challenges of all-solid-state Li-ion batteries is the restricted power density due to the poor Li-ion transport between the electrodes via the electrolyte. However, to establish what diffusional process is the bottleneck for Li-ion transport requires the ability to distinguish the various processes. The present work investigates the Li-ion diffusion in argyrodite Li6PS5Cl, a promising electrolyte based on its high Li-ion conductivity, using a combination of (7)Li NMR experiments and DFT based molecular dynamics simulations.

A fast and activatable cross-linking strategy for hydrogel formation.

Strain-promoted oxidation-controlled cyclo-octyne-1,2-quinone cycloaddition (SPOCQ) is a fast and activatable cross-linking strategy for hydrogel formation. Gelation is induced by oxidation, which is performed both chemically using sodium periodate and enzymatically using mushroom tyrosinase. Due to the fast reaction kinetics, SPOCQ-formed hydrogels can be functionalized in one-pot with an azido-containing moiety using SPAAC cross-linking.

Base-free, one-pot chemocatalytic conversion of glycerol to methyl lactate using supported gold catalysts.

We report an efficient one-pot conversion of glycerol (GLY) to methyl lactate (MLACT) in methanol in good yields (73 % at 95 % GLY conversion) by using Au nanoparticles on commercially available ultra-stable zeolite-Y (USY) as the catalyst (160 °C, air, 47 bar pressure, 0.25 M GLY, GLY-to-Au mol ratio of 1407, 10 h). The best results were obtained with zeolite USY-600, a catalyst that has both Lewis and Brønsted sites.

On the "tertiary structure" of poly-carbenes; self-assembly of sp3-carbon-based polymers into liquid-crystalline aggregates.

The self-assembly of poly(ethylidene acetate) (st-PEA) into van der Waals-stabilized liquid-crystalline (LC) aggregates is reported. The LC behavior of these materials is unexpected, and unusual for flexible sp(3)-carbon backbone polymers. Although the dense packing of polar ester functionalities along the carbon backbone of st-PEA could perhaps be expected to lead directly to rigid-rod behavior, molecular modeling reveals that individual st-PEA chains are actually highly flexible and should not reveal rigid-rod induced LC behavior.

Formation, molecular structure, and morphology of humins in biomass conversion: influence of feedstock and processing conditions.

Neither the routes through which humin byproducts are formed, nor their molecular structure have yet been unequivocally established. A better understanding of the formation and physicochemical properties of humins, however, would aid in making biomass conversion processes more efficient. Here, an extensive multiple-technique-based study of the formation, molecular structure, and morphology of humins is presented as a function of sugar feed, the presence of additives (e.

EASY-GOING deconvolution: Automated MQMAS NMR spectrum analysis based on a model with analytical crystallite excitation efficiencies.

The EASY-GOING deconvolution (EGdeconv) program is extended to enable fast and automated fitting of multiple quantum magic angle spinning (MQMAS) spectra guided by evolutionary algorithms. We implemented an analytical crystallite excitation model for spectrum simulation. Currently these efficiencies are limited to two-pulse and z-filtered 3QMAS spectra of spin 3/2 and 5/2 nuclei, whereas for higher spin-quantum numbers ideal excitation is assumed.