A study of Type B uncertainties associated with the photoelectric effect in low-energy Monte Carlo simulations.

To estimate Type B uncertainties in absorbed-dose calculations arising from the different implementations in current state-of-the-art Monte Carlo (MC) codes of low-energy photon cross-sections (<200 keV).MC simulations are carried out using three codes widely used in the low-energy domain: PENELOPE-2018, EGSnrc, and MCNP. Three dosimetry-relevant quantities are considered: mass energy-absorption coefficients for water, air, graphite, and their respective ratios; absorbed dose; and photon-fluence spectra.

On the impact of ICRU report 90 recommendations on k factors for high-energy photon beams.

Purpose: To assess the impact of the ICRU report 90 recommendations on the beam-quality conversion factor, k , used for clinical reference dosimetry of megavoltage linac photon beams.

Methods: The absorbed dose to water and the absorbed dose to the air in ionization chambers representative of those typically used for linac photon reference dosimetry are calculated at the reference depth in a water phantom using Monte Carlo simulations. Depth-dose calculations in water are also performed to investigate changes in beam quality specifiers.

Validating Fricke dosimetry for the measurement of absorbed dose to water for HDR Ir brachytherapy: a comparison between primary standards of the LCR, Brazil, and the NRC, Canada.

Two Fricke-based absorbed dose to water standards for HDR Ir-192 dosimetry, developed independently by the LCR in Brazil and the NRC in Canada have been compared. The agreement in the determination of the dose rate from a HDR Ir-192 source at 1 cm in a water phantom was found to be within the k  =  1 combined measurement uncertainties of the two standards: D /D   =  1.011, standard uncertainty  =  2.

Hounsfield unit recovery in clinical cone beam CT images of the thorax acquired for image guided radiation therapy.

A comprehensive artefact correction method for clinical cone beam CT (CBCT) images acquired for image guided radiation therapy (IGRT) on a commercial system is presented. The method is demonstrated to reduce artefacts and recover CT-like Hounsfield units (HU) in reconstructed CBCT images of five lung cancer patients. Projection image based artefact corrections of image lag, detector scatter, body scatter and beam hardening are described and applied to CBCT images of five lung cancer patients.

Monte Carlo reference data sets for imaging research: Executive summary of the report of AAPM Research Committee Task Group 195.

The use of Monte Carlo simulations in diagnostic medical imaging research is widespread due to its flexibility and ability to estimate quantities that are challenging to measure empirically. However, any new Monte Carlo simulation code needs to be validated before it can be used reliably. The type and degree of validation required depends on the goals of the research project, but, typically, such validation involves either comparison of simulation results to physical measurements or to previously published results obtained with established Monte Carlo codes.

Implementation of an efficient Monte Carlo calculation for CBCT scatter correction: phantom study.

Cone-beam computed tomography (CBCT) images suffer from poor image quality, in a large part due to contamination from scattered X-rays. In this work, a Monte Carlo (MC)-based iterative scatter correction algorithm was implemented on measured phantom data acquired from a clinical on-board CBCT scanner. An efficient EGSnrc user code (egs_cbct) was used to transport photons through an uncorrected CBCT scan of a Catphan 600 phantom.

Comparison between EGSnrc, Geant4, MCNP5 and Penelope for mono-energetic electron beams.

A simple geometry is chosen to highlight similarities and differences of current electron transport algorithms implemented in four Monte Carlo codes commonly used in radiation physics. Energy deposited in a water-filled sphere by mono-energetic electron beams was calculated using EGSnrc, Geant4, MCNP5 and Penelope as the radius of the sphere varied from 0.25 cm to 4.

The Fricke dosimeter as an absorbed dose to water primary standard for Ir-192 brachytherapy.

The aim of this project was to develop an absorbed dose to water primary standard for Ir-192 brachytherapy based on the Fricke dosimeter. To achieve this within the framework of the existing TG-43 protocol, a determination of the absorbed dose to water at the reference position, D(r0,θ0), was undertaken. Prior to this investigation, the radiation chemical yield of the ferric ions (G-value) at the Ir-192 equivalent photon energy (0.

Optimizing cone beam CT scatter estimation in egs_cbct for a clinical and virtual chest phantom.

Purpose: Cone beam computed tomography (CBCT) image quality suffers from contamination from scattered photons in the projection images. Monte Carlo simulations are a powerful tool to investigate the properties of scattered photons.egs_cbct, a recent EGSnrc user code, provides the ability of performing fast scatter calculations in CBCT projection images.

Patient-specific scatter correction in clinical cone beam computed tomography imaging made possible by the combination of Monte Carlo simulations and a ray tracing algorithm.

Purpose: Cone beam computed tomography (CBCT) image quality is limited by scattered photons. Monte Carlo (MC) simulations provide the ability of predicting the patient-specific scatter contamination in clinical CBCT imaging. Lengthy simulations prevent MC-based scatter correction from being fully implemented in a clinical setting.

Variance reduction techniques for fast Monte Carlo CBCT scatter correction calculations.

Several variance reduction techniques improving the efficiency of the Monte Carlo estimation of the scatter contribution to a cone beam computed tomography (CBCT) scan were implemented in egs_ctct, an EGSnrc-based application for CBCT-related calculations. The largest impact on the efficiency comes from the splitting + Russian Roulette techniques which are described in detail. The fixed splitting technique is outperformed by both the position-dependent importance splitting (PDIS) and the region-dependent importance splitting (RDIS).

Novel approach for the Monte Carlo calculation of free-air chamber correction factors.

A self-consistent approach for the Monte Carlo calculation of free-air chamber (FAC) correction factors needed to convert the chamber reading into the quantity air-kerma at the point of measurement is introduced, and its implementation in the new EGSnrc user code egs_fac is discussed. To validate the method, comparisons between computed and measured FAC correction factors for attenuation Ax, scatter (Ascat), and electron loss (Aeloss) are performed in the medium energy range where the experimental determination is believed to be accurate. The Monte Carlo calculations utilize a full simulation of the x-ray tube with BEAMnrc and a detailed model of the parallel-plate FAC.

On the accuracy of techniques for obtaining the calibration coefficient N(K) of 192Ir HDR brachytherapy sources.

The accuracy of interpolation or averaging procedures for obtaining the calibration coefficient N(K) for 192Ir high-dose-rate brachytherapy sources has been investigated using the EGSnrc Monte Carlo simulation system. It is shown that the widely used two-point averaging procedure of Goetsch et al. [Med.

Efficient x-ray tube simulations.

This article describes an efficiency study of directional bremsstrahlung splitting (DBS) for x-ray tube modeling. DBS is shown to be up to five or six orders of magnitude more efficient at 50 or 135 kV tube potential than a simulation without splitting, and 60 times more efficient compared to uniform bremsstrahlung splitting. A methodology is presented to determine the optimum splitting number for a given situation using a second degree polynomial expression derived from theoretical considerations.

Calculation of photon energy deposition kernels and electron dose point kernels in water.

Effects of changes in the physics of EGSnrc compared to EGS4/PRESTA on energy deposition kernels for monoenergetic photons and on dose point kernels for beta sources in water are investigated. In the diagnostic energy range, Compton binding corrections were found to increase the primary energy fraction up to 4.5% at 30 keV with a corresponding reduction of the scatter component of the kernels.

Calculations for plane-parallel ion chambers in 60Co beams using the EGSnrc Monte Carlo code.

The EGSnrc Monte Carlo simulation system is used to obtain, for 10 plane-parallel ionization chambers in 60Co beams, the correction factors Kcomp and Pwall that account for the nonequivalence of the chamber wall material to the buildup cap and the phantom material, respectively. A more robust calculation method has been used compared to that used in previous works. A minor conceptual error related to the axial nonuniformity correction factor, Kan, has been identified and shown to have an effect of about 0.