C NMR as an analytical tool for the detection of carbonic acid and pK determination.

NMR spectroscopy has become a standard technique in studies both on carbon capture and storage. C NMR allows the detection of two peaks for carbonated aqueous samples: one for CO and another one for the species H CO , HCO , and CO -herein collectively named H CO . The chemical shift of this second peak depends on the molar fraction of the three species in equilibrium and has been used to assess the equilibrium between HCO and CO .

Improving hydrodynamic injection in capillary electrophoresis by using the integral of pressure.

A careful analysis of the typical devices and conditions used during hydrodynamic injection in capillary electrophoresis shows that the Hagen-Poiseuille model for the laminar flow is valid, even during the transitions of pressure. Therefore, the monitoring of pressure becomes a reliable approach to evaluate the effective injected volume, because the volume is proportional to the integral of pressure (IoP) over time. A piezoresistive sensor was used to monitor the air pressure at headspace of the sample vial.

Qualitative and quantitative aspects of time-, charge-, and mobility-based electropherograms.

The migration process in capillary electrophoresis is obtained by using a high-voltage power supply, and the basic idea is to keep the control on the migration velocity of the analytes by controlling either the applied voltage or current. The effectiveness of this control has impact on the resulting electropherogram and, thus, in the identification and quantification of the analytes. Although the usual electropherogram is the record of the detector signal as a function of time, other two domains should be considered: charge and mobility.

A Pencil-Lead Immunosensor for the Rapid Electrochemical Measurement of Anti-Diphtheria Toxin Antibodies.

Diphtheria is a vaccine-preventable disease, yet immunization can wane over time to non-protective levels. We have developed a low-cost, miniaturized electroanalytical biosensor to quantify anti-diphtheria toxin (DTx) immunoglobulin G (anti-DTx IgG) antibody to minimize the risk for localized outbreaks. Two epitopes specific to DTx and recognized by antibodies generated post-vaccination were selected to create a bi-epitope peptide, biEP, by synthesizing the epitopes in tandem.

Determination of topiramate by capillary electrophoresis with capacitively-coupled contactless conductivity detection: A powerful tool for therapeutic monitoring in epileptic patients.

Topiramate (TPM) is the main antiepileptic drug used for the control of partial and generalized seizures in both adults and children. In association with clinical observations, the analysis of plasmatic concentration of TPM is of utmost importance for the individual adjustment of the administered dose to the patient. In the present work, a bioanalytical method was developed and validated for TPM analysis in plasma samples by capillary electrophoresis with capacitively-coupled contactless conductivity detection (CE-C D).

Analysis of Methanol in the Presence of Ethanol, Using a Hybrid Capillary Electrophoresis Device with Electrochemical Derivatization and Conductivity Detection.

Concurrently with ethanol, many other compounds can be formed during the fermentation of grains and fruits. Among those, methanol is particularly important (because of its toxicity) and is typically formed at concentrations much lower than ethanol, presenting a particular challenge that demands the implementation of separation techniques. Aiming to provide an alternative to traditional chromatographic approaches, a hybrid electrophoresis device with electrochemical preprocessing and contactless conductivity detection (hybrid EC-CE-CD) is herein described.

Fast production of microfluidic devices by CO2 laser engraving of wax-coated glass slides.

Glass is one of the most convenient materials for the development of microfluidic devices. However, most fabrication protocols require long processing times and expensive facilities. As a convenient alternative, polymeric materials have been extensively used due their lower cost and versatility.

Getting started with open-hardware: development and control of microfluidic devices.

Understanding basic concepts of electronics and computer programming allows researchers to get the most out of the equipment found in their laboratories. Although a number of platforms have been specifically designed for the general public and are supported by a vast array of on-line tutorials, this subject is not normally included in university chemistry curricula. Aiming to provide the basic concepts of hardware and software, this article is focused on the design and use of a simple module to control a series of PDMS-based valves.

Miniaturized flow system based on enzyme modified PMMA microreactor for amperometric determination of glucose.

This paper describes the development of a microfluidic system having as main component an enzymatic reactor constituted by a microchannel assembled in poly(methyl methacrylate) (PMMA) substrate connected to an amperometric detector. A CO2 laser engraving machine was used to make the channels, which in sequence were thermally sealed. The internal surfaces of the microchannels were chemically modified with polyethyleneimine (PEI), which showed good effectiveness for the immobilization of the glucose oxidase enzyme using glutaraldehyde as crosslinking agent, producing a very effective microreactor for the detection of glucose.

Unmanned platform for long-range remote analysis of volatile compounds in air samples.

This paper describes a long-range remotely controlled CE system built on an all-terrain vehicle. A four-stroke engine and a set of 12-V batteries were used to provide power to a series of subsystems that include drivers, communication, computers, and a capillary electrophoresis module. This dedicated instrument allows air sampling using a polypropylene porous tube, coupled to a flow system that transports the sample to the inlet of a fused-silica capillary.

On the formation of carbonate adducts of fatty alcohols, sterols, and sugars in biological conditions.

The formation and properties of carbonate adducts of some organic hydroxy compounds in aqueous medium were investigated. Fatty alcohols and sugars were chosen as representative classes of biological interest, and the medium was carbonated aqueous solution with pH ranging from 3.0 to 8.