The Comparative Dermal Stimulation Potential of Constant-Volume and Constant-Amount Diluted Calcium Hydroxylapatite Injections Versus the Concentrated Form.

Introduction: Biostimulation properties of diluted and hyperdiluted calcium hydroxylapatite (CaHA) injections have become increasingly popular. However, the existing data are insufficient to certify a particular dose-response pattern.

Objective: To assess and compare the dermal stimulation potentials of different concentrations of CaHA injections.

Water Drop Evaporation on Slippery Liquid-Infused Porous Surfaces (SLIPS): Effect of Lubricant Thickness, Viscosity, Ridge Height, and Pattern Geometry.

Sessile drop evaporation and condensation on slippery liquid-infused porous surfaces (SLIPS) is crucial for many applications. However, its modeling is complex since the infused lubricant forms a wetting ridge around the drop close to the contact line, which partially blocks the free surface area and decreases the drop evaporation rate. Although a good model was available after 2015, the effects of initial lubricant heights () above the pattern, and the corresponding initial ridge heights (), lubricant viscosity, and solid pattern type were not well studied.

Wetting of Superhydrophobic Polylactic Acid Micropillared Patterns.

Superhydrophobic (SH) polylactic acid (PLA) surfaces were previously produced by various methods and used especially in biomedical applications and oil/water separation processes after 2008. However, the wettability of SH-PLA patterns containing micropillars has not been investigated before. In this study, PLA patterns having regular microstructured pillars with 12 different pillar diameters and pillar-to-pillar distances were prepared by hot pressing pre-flattened PLA sheets onto preformed polydimethylsiloxane (PDMS) soft molds having micro-sized pits.

Comparison of fractional erbium:YAG laser-assisted tranexamic acid delivery alone and in combination with oral tranexamic acid in melasma.

Tranexamic acid (TA) emerged as a promising agent for melasma. However, due to its hydrophilic structure, topical TA should be combined with a penetration-enhancing strategy to augment efficacy. To evaluate the efficacy of fractional erbium:YAG laser-assisted delivery (LAD) of topical TA 5% either with or without oral TA treatment in recalcitrant melasma patients.

Comparing the effects and safety of dorzolamide hydrochloride + timolol maleate versus brimonidine after neodymium-doped yttrium aluminium garnet laser capsulotomy posterior capsule opacification.

Aim: Posterior capsular opacification is treated using neodymium-doped yttrium aluminium garnet laser capsulotomy that leads to increased intraocular pressure. Here, we compare the effects of dorzolamide hydrochloride + timolol maleate versus brimonidine on intraocular pressure. We also investigate their side effects after neodymium-doped yttrium aluminium garnet laser capsulotomy.

Polysiloxane Nanofilaments Infused with Silicone Oil Prevent Bacterial Adhesion and Suppress Thrombosis on Intranasal Splints.

Like all biofluid-contacting medical devices, intranasal splints are highly prone to bacterial adhesion and clot formation. Despite their widespread use and the numerous complications associated with infected splints, limited success has been achieved in advancing their safety and surface biocompatibility, and, to date, no surface-coating strategy has been proposed to simultaneously enhance the antithrombogenicity and bacterial repellency of intranasal splints. Herein, we report an efficient, highly stable lubricant-infused coating for intranasal splints to render their surfaces antithrombogenic and repellent toward bacterial cells.

Bioactivity of abobotulinum toxin is preserved till 2 weeks upon storage at room temperature: Half body comparative study on rabbit model.

Background: Breakages of the cold chain of botulinum neurotoxin A (BONT-A) preparations is not a rare event and occurs due to several unexpected and unintentional reasons during daily practice and intervention schedules could not be proposed due to the lack of data.

Objective: To investigate the heat stability of abobotulinum toxin A (AboBONT-A) in terms of efficacy and duration of action upon storage at room temperature (25°C) for 2, 4, and 8 weeks.

Methods And Materials: Twenty rabbits were divided into four groups and received an injection of ideally stored AboBONT-A (Group 1) and stored AboBONT-A for 2 (Group 2), 4 (Group 3), and 8 weeks (Group 4) at room temperature into the anterior auricular muscle.

Medical and socioeconomic challenges of private dermatocosmetology clinics during COVID-19 pandemic: A survey from Turkey.

Background: Coronavirus 2019 (COVID-19) disease has rapidly spread worldwide with a multitude effects on daily life. Since the transmission risk increases with close contact, some cosmetic procedures are considered high risk and majority of them had to be postponed or canceled in private dermatocosmetology clinics especially during the heavy period of the outbreak.

Aims: We aimed to document the medical and socioeconomic problems emerged in dermatocosmetology clinics in Turkey caused by COVID-19 pandemic and to discuss the management strategies taken by dermatologists.

The perspective of dermatology residents on cosmetology training: A survey.

Background: Cosmetology training is an under-fulfilled component of dermatology residency training.

Aims: To determine the availability of cosmetic training for dermatology residents in Turkey, their satisfaction by their cosmetic training and their self-confidence in cosmetic procedures.

Patients/methods: An online survey of 33 questions was performed between February and March 2019.

Management of nail psoriasis with a single injection of abobotulinum toxin.

Nail psoriasis is challenging; as topical agents generally fail and systemic therapies are doubted especially when the involvement of the skin is rather localized. The response of chronic plaque-type psoriasis to botulinum toxin injections is reported in case series that is essentially explained through the modulation of neurogenic inflammation. Herein, we report the successful treatment results of two cases demonstrating different features of nail psoriasis treated by abobotulinum toxin.

Two multinational, observational surveys investigating perceptions of beauty and attitudes and experiences relating to aesthetic medical procedures.

Background: Data on opinions and experiences of aesthetic medical procedures outside the United States and Western Europe are scarce.

Aims: This study aimed to survey users and non-users of aesthetic procedures in countries where this information is less readily available, to understand attitudes and perceptions relating to beauty.

Patients/methods: Two independent internet-based observational surveys were conducted.

Practical Applications of Superhydrophobic Materials and Coatings: Problems and Perspectives.

Synthetic superhydrophobic (SH) surfaces were developed after 1990s, and the number of publications in this field is around 13 500 at present. However, the industrial production of SH coatings is very unsatisfying after the intensive research activity in the last two decades. The main reason is the loss of the water repellence properties when SH surfaces are exposed to outdoor conditions due to their weak mechanical properties and contamination from the medium which removes the initial SH properties.

Simple Model for Diffusion-Limited Drop Evaporation of Binary Liquids from Physical Properties of the Components: Ethanol-Water Example.

The understanding of the evaporation process of drops consisting of binary mixtures, in particular ethanol-water drops, is important in many industries such as ink-jet printing, cooling of microelectronics, and alcohol-added pesticide spray applications. The theory of the diffusion-limited drop evaporation process for pure liquids has been investigated thoroughly, and linear (d/d) slopes were obtained for most of the cases. However, the evaporation of binary liquid drops was found to be much more complicated than that of the pure liquids due to the change of the composition of the drop by time and there is a need for the development of a new model.

Wet-spun graphene filaments: effect of temperature of coagulation bath and type of reducing agents on mechanical & electrical properties.

Although many factors are considered to improve the properties of graphene filaments, there is no report in the existing literature on the effect of the temperature of the coagulation bath to the mechanical properties of graphene oxide filaments obtained in the wet-spinning process and also to the mechanical and electrical properties of the resulting graphene filaments after reduction. In this study, the effect of the temperature of the isopropanol coagulation bath during wet-spinning of graphene filaments on their final properties after formation was investigated and it was found that the decrease of the coagulation bath temperature resulted in more compact filaments having better mechanical properties for both graphene oxide and corresponding reduced graphene filaments. The best tensile strength and Young's modulus values were obtained in isopropanol coagulation bath which was kept at 15 °C.

Improved Icephobic Properties on Surfaces with a Hydrophilic Lubricating Liquid.

Slippery liquid-infused porous surfaces were developed recently for icephobic surface applications. Perfluorinated liquids, silicone oil, hydrocarbon, and water were used as lubricating liquids to form a continuous layer on a suitable substrate to prevent icing. However, ice accretion performances of these surfaces have not been reported previously depending on the type of the lubricant.

Control of stain geometry by drop evaporation of surfactant containing dispersions.

Control of stain geometry by drop evaporation of surfactant containing dispersions is an important topic of interest because it plays a crucial role in many applications such as forming templates on solid surfaces, in ink-jet printing, spraying of pesticides, micro/nano material fabrication, thin film coatings, biochemical assays, deposition of DNA/RNA micro-arrays, and manufacture of novel optical and electronic materials. This paper presents a review of the published articles on the diffusive drop evaporation of pure liquids (water), the surfactant stains obtained from evaporating drops that do not contain dispersed particles and deposits obtained from drops containing polymer colloids and carbon based particles such as carbon nanotubes, graphite and fullerenes. Experimental results of specific systems and modeling attempts are discussed.

Osteoselection supported by phase separated polymer blend films.

The instability of implants after placement inside the body is one of the main obstacles to clinically succeed in periodontal and orthopedic applications. Adherence of fibroblasts instead of osteoblasts to implant surfaces usually results in formation of scar tissue and loss of the implant. Thus, selective bioadhesivity of osteoblasts is a desired characteristic for implant materials.

Selective adsorption of L1210 leukemia cells/human leukocytes on micropatterned surfaces prepared from polystyrene/polypropylene-polyethylene blends.

The objective of this study is to prepare polymeric surfaces which will adsorb L1210 leukemia cells selectively more than that of healthy human leukocytes in order to develop new treatment options for people with leukemia. Chemically heterogeneous and micropatterned surfaces were formed on round glass slides by dip coating with accompanying phase-separation process where only commercial polymers were used. Surface properties were determined by using optical microscopy, 3D profilometry, SEM and measuring contact angles.

Chloroquine and hydroxychloroquine retinopathy-related risk factors in a Turkish cohort.

To evaluate the role of previously reported risk factors on developing retinopathy in patients treated with chloroquine (CQ) and hydroxychloroquine (HCQ). Ophthalmologic examination, visual field testing, and spectral domain-optical coherence tomography were performed in 31 patients treated with CQ and HCQ. Toxicity diagnosis was proven by electrophysiological assessment.

HIV-related eye disease in patients presenting to a tertiary care government hospital in Turkey.

Aim: To document the ocular involvement in HIV-infected individuals in Turkey and to compare the findings with those from other centers throughout the world.

Methods: In this cross-sectional study, patients with HIV infection being monitored in a tertiary hospital in Istanbul were enrolled. Ocular examination was performed, and the prevalence of ocular manifestations determined.

Evaporation of pure liquid sessile and spherical suspended drops: a review.

A sessile drop is an isolated drop which has been deposited on a solid substrate where the wetted area is limited by a contact line and characterized by contact angle, contact radius and drop height. Diffusion-controlled evaporation of a sessile drop in an ambient gas is an important topic of interest because it plays a crucial role in many scientific applications such as controlling the deposition of particles on solid surfaces, in ink-jet printing, spraying of pesticides, micro/nano material fabrication, thin film coatings, biochemical assays, drop wise cooling, deposition of DNA/RNA micro-arrays, and manufacture of novel optical and electronic materials in the last decades. This paper presents a review of the published articles for a period of approximately 120 years related to the evaporation of both sessile drops and nearly spherical droplets suspended from thin fibers.

The relationship between optical coherence tomography patterns, angiographic parameters and visual acuity in age-related macular degeneration.

To assess the relationships between visual acuity (VA), fluorescein angiographic parameters and optical coherence tomography (OCT) patterns in exudative age-related macular degeneration (AMD). Fifty eyes with confirmed diagnosis of new exudative AMD who underwent fluorescein angiography (FA) and OCT evaluation were reviewed retrospectively. The greatest linear diameter of lesion (GLD) by FA and central foveal thickness (CFT) by OCT were measured.

Diffusion-controlled evaporation of sodium dodecyl sulfate solution drops placed on a hydrophobic substrate.

In this work, the effect of SDS anionic surfactant on the diffusion-controlled evaporation rate of aqueous solution drops placed on TEFLON-FEP substrate was investigated with 11 different SDS concentrations. Drop evaporation was monitored in a closed chamber having a constant RH of 54-57% by a video camera. The initial contact angle, θ(i) decreased from 104±2° down to 68±1° due to the adsorption of SDS both at the water-air and the solid-water interfaces.

Deep sclerectomy augmented with combination of absorbable biosynthetic sodium hyaluronate scleral implant and mitomycin C or with mitomycin C versus trabeculectomy: long-term results.

Background: To evaluate the long-term results following deep sclerectomy with mitomycin C-SKgel implant (DSMMC-SKgel), mitomycin C (DSMMC) and trabeculectomy.

Design: Comparative case series, Goztepe Training and Educational Hospital.

Participants: Ninety-one open-angle glaucoma patients.