Thin and thick layers of resin-based sealer cement bonded to root dentine compared: Adhesive behaviour.

This study aims to evaluate tensile and shear bond strengths of one epoxy (AH) and two methacrylate resin-based sealers (EZ and RS) in thin and thick layers bonded to root dentine. An alignment device was prepared for accurate positioning of 20 root dentine cylinders in a predefined gap of 0.1 or 1 mm.

Critical evaluation of the push-out test for root canal filling materials.

Introduction: The push-out test has been widely used in experimental endodontics but has been criticized on technical grounds particularly because the soft-core material undergoes plastic deformation under load. This study systematically evaluated the technique by comparing push-out strength and load profiles in relation to core material stiffness, canal diameter, punch diameter, sample orientation, and mode of failure.

Methods: Straight palatal roots of 90 maxillary molars were obturated with an epoxy resin-based sealer alone (10 roots) or gutta-percha (70) or epoxy resin (10) cores with a thin layer of sealer cement.

Behavior of resin-based endodontic sealer cements in thin and thick films.

Objectives: For root canal fillings, a thin layer of sealer cement is generally recommended. However, with resin-based sealers, lower bond strength to dentin has been shown in thin layers compared to thick, contrary to typical behavior of adhesive layers between two adherents. The aim of this study was to evaluate tensile and shear bond strength of thin and thick films of three resin-based sealers (one epoxy-based and two methacrylate-based) materials and to investigate corner effects of one methacrylate-based resin sealer.