Protocrystallinity of Monodispersed Ultra-Small Templated Mesoporous Silica Nanoparticles.

Monodisperse and semi-faceted ultra-small templated mesoporous silica nanoparticles (US-MSNs) of 20-25 nm were synthesized using short-time hydrolysis of tetraethoxysilane (TEOS) at room temperature, followed by a dilution for nucleation quenching. According to dynamic light scattering (DLS), a two-step pH adjustment was necessary for growth termination and colloidal stabilization. The pore size was controlled by cetyltrimethylammonium bromide (CTAB), and a tiny amount of neutral surfactant F127 was added to minimize the coalescence between US-MSNs and to favor the transition towards internal ordering.

Operando analysis of a solid oxide fuel cell by environmental transmission electron microscopy.

Correlating the microstructure of an energy conversion device to its performance is often a complex exercise, notably in solid oxide fuel cell research. Solid oxide fuel cells combine multiple materials and interfaces that evolve in time due to high operating temperatures and reactive atmospheres. We demonstrate here that operando environmental transmission electron microscopy can identify structure-property links in such devices.

Deciphering strontium sulfate precipitation via Ostwald's rule of stages: From prenucleation clusters to solution-mediated phase tranformation.

Multiple-step nucleation pathways have been observed during mineral formation in both inorganic and biomineral systems. These pathways can involve precursor aqueous species, amorphous intermediates, or metastable phases. Despite the widespread occurrence of these processes, elucidating the precise nucleation steps and the transformation mechanisms between each step remains a challenging task.

Deep learning detection of nanoparticles and multiple object tracking of their dynamic evolution during in situ ETEM studies.

In situ transmission electron microscopy (TEM) studies of dynamic events produce large quantities of data especially under the form of images. In the important case of heterogeneous catalysis, environmental TEM (ETEM) under gas and temperature allows to follow a large population of supported nanoparticles (NPs) evolving under reactive conditions. Interpreting properly large image sequences gives precious information on the catalytic properties of the active phase by identifying causes for its deactivation.

Accurate post-mortem alignment for Focused Ion Beam and Scanning Electron Microscopy (FIB-SEM) tomography.

Drifts in the three directions (X, Y, Z) during the FIB-SEM slice-and-view tomography is an important issue in 3D-FIB experiments which may induce significant inaccuracies in the subsequent volume reconstruction and further quantification of morphological volume parameters of the sample microstructure. Cross-correlation is frequently applied directly to the cross-section image series for aligning FIB sliced images. This solution is hazardous and can be flawed as it has been easily demonstrated by a dedicated test experiment.

Electron Tomography of Plasmonic Au Nanoparticles Dispersed in a TiO Dielectric Matrix.

Plasmonic Au nanoparticles (AuNPs) embedded into a TiO dielectric matrix were analyzed by combining two-dimensional and three-dimensional electron microscopy techniques. The preparation method was reactive magnetron sputtering, followed by thermal annealing treatments at 400 and 600 °C. The goal was to assess the nanostructural characteristics and correlate them with the optical properties of the AuNPs, particularly the localized surface plasmon resonance (LSPR) behavior.

Contribution of Local Analysis Techniques for the Characterization of Iron and Alloying Elements in Nitrides: Consequences on the Precipitation Process in Fe⁻Si and Fe⁻Cr Nitrided Alloys.

Atom Probe Tomography (APT), Transmission Electron Microscopy (TEM), and 3D mechanical calculations in complex geometry and anisotropic strain fields were employed to study the role of minor elements in the precipitation process of silicon and chromium nitrides in nitrided Fe⁻Si and Fe⁻Cr alloys, respectively. In nitrided Fe⁻Si alloys, an original sequence of Si₃N₄ precipitation was highlighted. Al⁻N clusters form first and act as nucleation sites for amorphous Si₃N₄ nitrides.

Evaluation of noise and blur effects with SIRT-FISTA-TV reconstruction algorithm: Application to fast environmental transmission electron tomography.

Fast tomography in Environmental Transmission Electron Microscopy (ETEM) is of a great interest for in situ experiments where it allows to observe 3D real-time evolution of nanomaterials under operating conditions. In this context, we are working on speeding up the acquisition step to a few seconds mainly with applications on nanocatalysts. In order to accomplish such rapid acquisitions of the required tilt series of projections, a modern 4K high-speed camera is used, that can capture up to 100 images per second in a 2K binning mode.

Mechanical characterization of diesel soot nanoparticles: in situ compression in a transmission electron microscope and simulations.

Incomplete fuel burning inside an internal combustion engine results in the creation of soot in the form of nanoparticles. Some of these soot nanoparticles (SNP) become adsorbed into the lubricating oil film present on the cylinder walls, which adversely affects the tribological performance of the lubricant. In order to better understand the mechanisms underlying the wear caused by SNPs, it is important to understand the behavior of SNPs and to characterize potential changes in their mechanical properties (e.

Direct Visualization and Control of Atomic Mobility at {100} Surfaces of Ceria in the Environmental Transmission Electron Microscope.

Ceria is one of the world's most prominent material for applications in heterogeneous catalysis, as catalyst support or catalyst itself. Despite an exhaustive literature on the structure of reactive facets of CeO in line with its catalytic mechanisms, the temporal evolution of the atomic surface structure exposed to realistic redox conditions remains elusive. Here, we provide a direct visualization of the atomic mobility of cerium atoms on {100} surfaces of CeO nanocubes at room temperature in high vacuum, O, and CO atmospheres in an environmental transmission electron microscope.

Investigation of the in-plane and out-of-plane electrical properties of metallic nanoparticles in dielectric matrix thin films elaborated by atomic layer deposition.

Pt nanoparticles in a AlO dielectric matrix thin films are elaborated by means of atomic layer deposition. These nanostructured thin films are integrated in vertical and planar test structures in order to assess both their in-plane and out-of-plane electrical properties. A shadow edge evaporation process is used to develop planar devices with electrode separation distances in the range of 30 nm.

Tracking the restructuring of oxidized silver-indium nanoparticles under a reducing atmosphere by environmental HRTEM.

Multimetallic nano-alloys display a structure and consequently physicochemical properties evolving in a reactive environment. Following and understanding this evolution is therefore crucial for future applications in gas sensing and heterogeneous catalysis. In view hereof, the structural evolution of oxidized AgIn bimetallic nanoparticles under varying H partial pressures (P) and substrate temperatures (T) has been investigated in real-time through environmental transmission microscopy (E-TEM) while maintaining the atomic resolution.

Tuning the Structure of Platinum Particles on Ceria In Situ for Enhancing the Catalytic Performance of Exhaust Gas Catalysts.

A dynamic structural behavior of Pt nanoparticles on the ceria surface under reducing/oxidizing conditions was found at moderate temperatures (<500 °C) and exploited to enhance the catalytic activity of Pt/CeO -based exhaust gas catalysts. Redispersion of platinum in an oxidizing atmosphere already occurred at 400 °C. A protocol with reducing pulses at 250-400 °C was applied in a subsequent step for controlled Pt-particle formation.

Three-Dimensional Self-Organization in Nanocomposite Layered Systems by Ultrafast Laser Pulses.

Controlling plasmonic systems with nanometer resolution in transparent films and their colors over large nonplanar areas is a key issue for spreading their use in various industrial fields. Using light to direct self-organization mechanisms provides high-speed and flexible processes to meet this challenge. Here, we describe a route for the laser-induced self-organization of metallic nanostructures in 3D.

Fast 'Operando' electron nanotomography.

Electron tomography in transmission electron microscopy provides valuable three-dimensional structural, morphological and chemical information of condensed matter at nanoscale. Current image acquisitions require at least tens of minutes, which prohibits the analysis of nano-objects evolving rapidly such as under dynamic environmental conditions. Reducing the acquisition duration to tens of seconds or less permits to follow in 3D the same object during its evolution under varying temperatures and pressures.

HAADF-STEM characterization and simulation of nanoparticle distributions in an inhomogeneous matrix.

Measuring with a high accuracy the size distribution of small metallic nanoparticles loaded in a mesoporous metal oxide matrix is of particular interest for many studies related to new generations of interesting metamaterials. Transmission electron microscopy (TEM) is a powerful tool to determine the nature and morphology of very small particles, but their reliable and automatic identification in an inhomogeneous environment where the nanoparticle/background contrast locally varies is not straightforward. Here, we present how a quantitative analysis of high-angle annular dark field scanning TEM (HAADF STEM) images, accounting for the chemical sensitivity of the technique, can improve the accuracy of semiautomatic segmentation methods based on morphological processing to calculate size histograms.

Growth of single gold nanofilaments at the apex of conductive atomic force microscope tips.

This paper describes a fast and one-step technique to grow single gold filaments at the apex of commercial conductive AFM tips. It is implemented with an atomic force microscope in air with a high relative humidity at room temperature and is based on a bias-assisted electro-reduction of gold ions directly at the tip apex. The technique requires only ad hoc substrates made of a mesoporous silica layer loaded with gold salt deposited on a conductive electrode.

Crystal orientation mapping via ion channeling: An alternative to EBSD.

A new method, which we name ion CHanneling ORientation Determination (iCHORD), is proposed to obtain orientation maps on polycrystals via ion channeling. The iChord method exploits the dependence between grain orientation and ion beam induced secondary electron image contrast. At each position of the region of interest, intensity profiles are obtained from a series of images acquired with different orientations with respect to the ion beam.

Multi-L1(0) domain CoPt and FePt nanoparticles revealed by electron microscopy.

The atomic structure of CoPt and FePt nanoparticles (with a diameter between 2 and 5 nm) has been studied by transmission electron microscopy. The particles have been produced by a laser vaporization cluster source and annealed under vacuum in order to promote chemical ordering. For both alloys, we observe a coexistence of crystalline and multiply twinned particles with decahedral or icosahedral shapes.

Chemical 3D tomography of 28nm high K metal gate transistor: STEM XEDS experimental method and results.

A new STEM XEDS tomography technique is proposed thanks to the implementation of multi EDX SDD detectors in analytical TEMs. The technique flow is presented and the first results obtained on a 28nm FDSOI transistor are detailed. The latter are compared with 2D XEDS analysis to demonstrate the interest of the slice extraction in all directions from a large analyzed volume without any 3D overlap effect issues.

Internalization pathways into cancer cells of gadolinium-based radiosensitizing nanoparticles.

Over the last few decades, nanoparticles have been studied in theranostic field with the objective of exhibiting a long circulation time through the body coupled to major accumulation in tumor tissues, rapid elimination, therapeutic potential and contrast properties. In this context, we developed sub-5 nm gadolinium-based nanoparticles that possess in vitro efficient radiosensitizing effects at moderate concentration when incubated with head and neck squamous cell carcinoma cells (SQ20B). Two main cellular internalization mechanisms were evidenced and quantified: passive diffusion and macropinocytosis.

Toward an image-guided microbeam radiation therapy using gadolinium-based nanoparticles.

Ultrasmall gadolinium-based nanoparticles (GBNs) induce both a positive contrast for magnetic resonance imaging and a radiosentizing effect. The exploitation of these characteristics leads to a greater increase in lifespan of rats bearing brain tumors since the radiosensitizing effect of GBNs can be activated by X-ray microbeams when the gadolinium content is, at the same time, sufficiently high in the tumor and low in the surrounding healthy tissue. GBNs exhibit therefore an interesting potential for image-guided radiotherapy.

Quantitative MAS NMR characterization of the LiMn(1/2)Ni(1/2)O(2) electrode/electrolyte interphase.

The conditions in which degradation processes at the positive electrode/electrolyte interface occur are still incompletely understood and traditional surface analytical techniques struggle to characterize and depict accurately interfacial films. In the present work, information on the growth and evolution of the interphases upon storage and cycling as well as their electrochemical consequences are gathered in the case of LiNi(1/2)Mn(1/2)O(2) with commonly used LiPF(6) (1M in EC/DMC) electrolyte. The use of (7)Li, (19)F and (31)P MAS NMR, made quantitative through the implementation of empirical calibration, is combined with transmission electron microscopy (TEM) and electron energy loss spectroscopy (EELS) to probe the elements involved in surface species and to unravel the inhomogenous architecture of the interphase.