Influence of Surface Structure, Pigmentation and Particulate Matter on Plant Reflectance and Fluorescence.

Optical properties of plant leaves are relevant to evaluate their physiological state and stress effect. The main objective of this work was to study how variegation, pigment composition or reflective features modifies leaves' photophysical behavior. For this purpose, green leaves (Ficus benjamina), purple leaves (Tradescantia pallida), green leaves covered by white trichomes (Cineraria maritima) and variegated leaves (Codiaeum aucubifolium) were analyzed.

Photophysics at Unusually High Dye Concentrations.

The study of the interaction of light with systems at high dye concentrations implies a great challenge because several factors, such as emission reabsorption, dye aggregation, and energy trapping, hinder rationalization and interpretation of the involved photophysical processes. Space constraints induce dye interaction even in the absence of ground state stabilization of dimers and oligomers. At distances on the order of 1 nm, statistical energy traps are usually observed.

Photophysics of Xanthene Dyes at High Concentrations in Solid Environments: Charge Transfer Assisted Triplet Formation.

The photophysical behavior of two xanthene dyes, Eosin Y and Phloxine B, included in microcrystalline cellulose particles is studied in a wide concentration range, with emphasis on the effect of dye concentration on fluorescence and triplet quantum yields. Absolute fluorescence quantum yields in the solid-state were determined by means of diffuse reflectance and steady-state fluorescence measurements, whereas absolute triplet quantum yields were obtained by laser-induced optoacoustic spectroscopy and their dependence on dye concentration was confirmed by diffuse reflectance laser flash photolysis and time-resolved phosphorescence measurements. When both quantum yields are corrected for reabsorption and reemission of radiation, Φ values decrease strongly on increasing dye concentration, while a less pronounced decay is observed for Φ .

Rose bengal in poly(2-hydroxyethyl methacrylate) thin films: self-quenching by photoactive energy traps.

The effect of dye concentration on the fluorescence,Φ, and singlet molecular oxygen,Φ, quantum yields of rose bengal loaded poly(2-hydroxyethyl methacrylate) thin films (∼200 nm thick) was investigated, with the aim of understanding the effect of molecular interactions on the photophysical properties of dyes in crowded constrained environments. Films were characterized by absorption and fluorescence spectroscopy, singlet molecular oxygen (O) production was quantified using a chemical monitor, and the triplet decay was determined by laser flash-photolysis. For the monomeric dilute dye, Φ = 0.

Tuning the concentration of dye loaded polymer films for maximum photosensitization efficiency: phloxine B in poly(2-hydroxyethyl methacrylate).

Fluorescence and singlet molecular oxygen ((1)O2) quantum yields for phloxine B loaded poly(2-hydroxyethyl methacrylate) thin films are determined at dye concentrations from 0.015 to 22 wt%. Fluorescence self-quenching and the fall off of the (1)O2 quantum yield observed above 0.

Effect of concentration on the formation of rose bengal triplet state on microcrystalline cellulose: a combined laser-induced optoacoustic spectroscopy, diffuse reflectance flash photolysis, and luminescence study.

Laser-induced optoacoustic spectroscopy (LIOAS), diffuse reflectance laser flash photolysis (DRLFP), and laser-induced luminescence (LIL) have been applied in conjunction to the determination of triplet state quantum yields of Rose Bengal (RB) supported on microcrystalline cellulose, a strongly light-scattering solid. Among the three used methods, the only one capable of providing absolute triplet quantum yields is LIOAS, but DRLFP and LIL aid in demonstrating that the LIOAS signal arises in fact from the triplet state and confirm the trend found with RB concentration. The coherence found for the three techniques demonstrates the usefulness of the approach.

Fluorescence enhancement of a fluorescein derivative upon adsorption on cellulose.

9-[1-(2-Methyl-4-methoxyphenyl)]-6-hydroxy-3H-xanthen-3-one (2-Me-4-OMe TG) is a fluorescein derivative dye whose photophysical properties show a remarkable pH dependence. In aqueous solution the fluorescence quantum yield (Φf) of its anionic species is nearly a hundred times higher than that of its neutral species. Such a large difference in Φf makes 2-Me-4-OMe TG useful as an "on-off" pH indicator.

Evidence on dye clustering in the sensitization of TiO2 by aluminum phthalocyanine.

As previous studies have shown, the photocatalytic reduction of Cr(VI) to Cr(III) in the presence of 4-chlorophenol can be carried out efficiently under visible irradiation using TiO2 modified with hydroxoaluminum-tricarboxymonoamide phthalocyanine (AlTCPc) in spite of the high aggregation tendency of the dye. In the present work, photocurrent and absorption spectra of AlTCPc modified TiO2 films are studied together with absorption and fluorescence of the dye in solution as a function of the concentration of the dye to clarify (a) the role of aggregates and the nature of the species responsible for electron injection into the semiconductor and (b) the reasons why, as reported earlier, the photocatalytic activity is nearly independent of dye loading at constant TiO2 mass. Results are consistent with the presence of AlTCPc clusters with similar properties both on the TiO2 surface and in H2O-DMSO solution.

Effect of concentration on the photophysics of dyes in light-scattering materials.

Photoactive materials based on dye molecules incorporated into thin films or bulk solids are useful for applications as photosensitization, photocatalysis, solar cell sensitization and fluorescent labeling, among others. In most cases, high concentrations of dyes are desirable to maximize light absorption. Under these circumstances, the proximity of dye molecules leads to the formation of aggregates and statistical traps, which dissipate the excitation energy and lower the population of excited states.

Exploiting electron storage in TiO2 nanoparticles for dark reduction of As(V) by accumulated electrons.

UV irradiation of an ethanolic sol of TiO2 nanoparticles produces a trapped Ti(III) centre and a noticeable Burstein shift. Direct evidence that the accumulated charges can drive the otherwise forbidden reduction of As(V) by conduction band electrons is presented.

Eosin Y triplet state as a probe of spatial heterogeneity in microcrystalline cellulose.

The photophysical behavior of eosin Y adsorbed onto microcrystalline cellulose was evaluated by reflectance spectroscopy, steady-state fluorescence spectroscopy and laser induced time-resolved luminescence. On increasing the concentration of the dye, small changes in absorption spectra, fluorescence redshifts and fluorescence quenching are observed. Changes in absorption spectra point to the occurrence of weak exciton interactions among close-lying dye molecules, whereas fluorescence is affected by reabsorption and excitation energy trapping.

Triplet quantum yields in light-scattering powder samples measured by laser-induced optoacoustic spectroscopy (LIOAS).

In recent years, different methods and techniques have been applied to study the primary photophysical processes occurring in dye-loaded light-scattering powdered samples. In spite of this, there are still no reliable methods for the determination of triplet quantum yields for this kind of systems. Laser-induced optoacoustic spectroscopy (LIOAS) has been extensively used for the determination of triplet quantum yields of dyes in solution.

Phloxine B as a probe for entrapment in microcrystalline cellulose.

The photophysical behaviour of phloxine B adsorbed onto microcrystalline cellulose was evaluated by reflectance spectroscopy and laser induced time-resolved luminescence in the picosecond-nanosecond and microsecond-millisecond ranges. Analysis of the absorption spectral changes with concentration points to a small tendency of the dye to aggregate in the range of concentrations under study. Prompt fluorescence, phosphorescence and delayed fluorescence spectral decays were measured at room temperature and 77 K, without the need of sample degassing because cellulose protects triplet states from oxygen quenching.

Dye-polyelectrolyte layer-by-layer self-assembled materials: molecular aggregation, structural stability, and singlet oxygen photogeneration.

The interaction of rose Bengal (RB) and fluorescein (FL) with poly[diallyldimethylammonium] chloride (PDDA) was studied in layer-by-layer self-assembled thin films and in solution. The spectroscopic behavior is explained in terms of dye-dye, dye-polyelectrolyte, and in solution, dye-solvent interactions. A correlation among dye hydrophobicity, aggregation tendency, polymer folding in solution, and the stability of self-assembled films is obtained.

Silicon nanoparticle photophysics and singlet oxygen generation.

The effect of molecular oxygen and water on the blue photoluminescence of silicon nanoparticles synthesized by anodic oxidation of silicon wafers and surface functionalized with 2-methyl 2-propenoic acid methyl ester is investigated. The particles of 3 +/- 1 nm diameter and a surface composition of Si(3)O(6)(C(5)O(2)H(8)) exhibit room-temperature luminescence in the wavelength range 300-600 nm upon excitation with 300-400 nm light. The luminescence shows vibronic resolution and high quantum yields in toluene suspensions, while a vibronically unresolved spectrum and lower emission quantum yields are observed in aqueous suspensions.

Trapping of Rhodamine 6G excitation energy on cellulose microparticles.

Rhodamine 6G (R6G) was adsorbed on cellulose microparticles and fluorescence quantum yields and decays were measured as a function of dye loading. Though no spectroscopic evidence of dye aggregation was found, a noticeable decrease of quantum yield--after correction for reabsorption and reemission of fluorescence--and shortening of decays were observed at the highest loadings. These effects were attributed to the dissipation of the excitation energy by traps constituted by R6G pairs, leading to static and dynamic quenching produced by direct absorption of traps and non-radiative energy transfer from monomers, respectively.

Photoreduction of Cr(VI) using hydroxoaluminiumtricarboxymonoamide phthalocyanine adsorbed on TiO2.

Hydroxoaluminiumtricarboxymonoamide phthalocyanine (AlTCPc) adsorbed at different loadings on TiO(2) Degussa P-25 was tested for Cr(vi) photocatalytic reduction under visible irradiation in the presence of 4-chlorophenol (4-CP) as sacrificial donor. A rapid reaction takes place in spite of the presumable aggregation of the dye on the TiO(2) surface. The removal of Cr(vi) is fairly negligible under visible-light irradiation, either without photocatalyst or in the presence of bare TiO(2).

Validation of fluorescence quantum yields for light-scattering powdered samples by laser-induced optoacoustic spectroscopy.

Determination of quantum yields for various processes (such as fluorescence and triplet formation) in dye-loaded light-scattering powdered samples is an open issue. Here, we report the testing of laser-induced optoacoustic spectroscopy (LIOAS) for the determination of fluorescence quantum yields of Rhodamine 101 and Rhodamine 6G adsorbed at various loadings on microgranular cellulose powder. The results of the LIOAS experiments are consistent with those from the method developed in one of our laboratories based on the measurement of apparent reflectance using an integrating sphere [Mirenda, M.

Pitfalls and limitations in the practical use of Förster's theory of resonance energy transfer.

Disparate presentations in the literature of the basic equations of Förster's theory of resonance energy transfer are clarified and the limitations of these equations are discussed.

Effect of molecular interactions on the photophysics of Rose Bengal in polyelectrolyte solutions and self-assembled thin films.

Solutions and layer-by-layer self-assembled thin films containing Rose Bengal and poly(diallyldimethylammonium chloride) are studied with the aim of understanding the interactions controlling their structures and the photophysics of the dye in both media. A detailed spectroscopic and theoretical analysis shows that hydrophobic interactions among dye molecules contribute to the coiling of the polyelectrolyte chain in solution at low polyelectrolyte/dye ( P/ D) ratios, whereas extensive aggregation of the dye takes place even at ratios as high as 10(4) (expressed in monomeric units). A polyelectrolyte elongated form prevails in self-assembled thin films, providing an environment that reduces hydrophobic interactions and lowers the aggregation tendency.

Excitation energy transfer and trapping in dye-loaded solid particles.

The photophysics of several systems composed of a single dye or pairs of dyes attached to solid particles has been studied in the dry solid state at high dye concentrations taking into account light scattering and inner filter effects. Interaction among dye molecules and singlet-singlet energy transfer are relevant in these conditions, as has been demonstrated for pairs of dyes with suitable spectral overlap. For single dyes, after correction for radiative energy transfer, fluorescence quenching is observed as the surface concentration increases.

Energy transfer from chemically attached rhodamine 101 to adsorbed methylene blue on microcrystalline cellulose particles.

Rhodamine 101 (R101) was chemically attached onto microcrystalline cellulose and methylene blue (MB) was adsorbed to a sample bearing nearby 6 x 10(-7) mol R101 (g cellulose)(-1). The system was studied by reflectance and emission spectroscopy in the solid state. R101 shows no aggregation in these conditions and, while pure MB builds up dimers on cellulose even at 2 x 10(-8) mol g(-1), in the presence of R101 no evidence on selfaggregation or heteroaggregation is found up to around 10(-6) mol g(-1).

Energy transfer among dyes on particulate solids.

Absorption and fluorescence properties of methylene blue (MB), a well-known singlet molecular oxygen photosensitizer, and its mixtures with pheophorbide-a (Pheo) sorbed on microgranular cellulose are studied, with emphasis on radiative and nonradiative energy transfer from Pheo to MB. Although pure MB builds up dimeric species on cellulose even at 2 x 10(-8) mol g(-1), addition of 2.05 x 10(-7) mol g(-1) Pheo largely inhibits aggregation up to nearly 10(-6) mol g(-1) MB.

Photophysics on surfaces: determination of absolute fluorescence quantum yields from reflectance spectra.

A method for the calculation of absolute fluorescence quantum yields for dyes attached to solid particles based on reflectance measurements is reported. The same procedure allows calculation of true reflectance spectra (free of fluorescence) for highly fluorescent materials as well. Samples ofcresyl violet were immobilized by adsorption on microgranular cellulose in the concentration range 4.

Rose Bengal adsorbed on microgranular cellulose: evidence on fluorescent dimers.

Rose Bengal adsorbed on microgranular cellulose was studied in the solid phase by total and diffuse reflectance and steady-state emission spectroscopy. A simple monomer-dimer equilibrium fitted reflectance data up to dye loadings of 4 x 10(-7) mol (g cellulose)(-1) and allowed calculation of monomer and dimer spectra. Further increase of dye loading resulted in the formation of higher aggregates.