Regeneration of Exhausted Palladium-Based Membranes: Recycling Process and Economics.

The aim of the present work is the recycling treatment of tubular α-AlO-supported ceramic membranes with a Pd/Ag selective layer, employed in hydrogen production with integrated CO capture. A nitric acid leaching treatment was investigated, and recovered ceramic supports were characterized, demonstrating their suitability for the production of novel efficient membranes. The main objective was the metal dissolution that preserved the support integrity in order to allow the recovered membrane to be suitable for a new deposition of the selective layer.

Solvent versus thermal treatment for glass recovery from end of life photovoltaic panels: Environmental and economic assessment.

End of life photovoltaic panels of different technologies (poly crystalline Si, amorphous Si, and CdTe) were treated mechanically in pilot scale by single shaft shredder minimizing the production of fine fractions below 0.4 mm (<18% weight). Grounded material was sieved giving: an intermediate fraction (0.

Leaching of electrodic powders from lithium ion batteries: Optimization of operating conditions and effect of physical pretreatment for waste fraction retrieval.

Experimental results of leaching tests using waste fractions obtained by mechanical pretreatment of lithium ion batteries (LIB) were reported. Two physical pretreatments were performed at pilot scale in order to recover electrodic powders: the first including crushing, milling, and sieving and the second granulation, and sieving. Recovery yield of electrodic powder was significantly influenced by the type of pretreatment.

Physical and chemical treatment of end of life panels: An integrated automatic approach viable for different photovoltaic technologies.

Different kinds of panels (Si-based panels and CdTe panels) were treated according to a common process route made up of two main steps: a physical treatment (triple crushing and thermal treatment) and a chemical treatment. After triple crushing three fractions were obtained: an intermediate fraction (0.4-1mm) of directly recoverable glass (17%); a coarse fraction (>1mm) requiring further thermal treatment in order to separate EVA-glued layers in glass fragments; a fine fraction (<0.

Cobalt products from real waste fractions of end of life lithium ion batteries.

An innovative process was optimized to recover Co from portable Lithium Ion Batteries (LIB). Pilot scale physical pretreatment was performed to recover electrodic powder from LIB. Co was extracted from electrodic powder by a hydrometallurgical process including the following main stages: leaching (by acid reducing conditions), primary purification (by precipitation of metal impurities), solvent extraction with D2EPHA (for removal of metal impurities), solvent extraction with Cyanex 272 (for separation of cobalt from nickel), cobalt recovery (by precipitation of cobalt carbonate).

Automobile shredded residue valorisation by hydrometallurgical metal recovery.

The aim of this work was developing a hydrometallurgical process to recover metals from automobile shredded residue (or car fluff). Automobile shredded residue (ASR) was characterised by particle size distribution, total metal content and metal speciation in order to guide the choice of target metals and the operating conditions of leaching. Characterisation results showed that Fe is the most abundant metal in the waste, while Zn was the second abundant metal in the fraction with diameter lower than 500 μm.

Non-electrostatic surface complexation models for protons and lead(II) sorption onto single minerals and their mixture.

Potentiometric titrations and lead sorption tests were conducted using muscovite, clinochlore, hematite, goethite, quartz, and a mixture of these same minerals. Mechanistic models were developed to represent and interpret these data. The aim was isolating the specific contribution of each mineral in proton and lead binding.