Sustainable development of concrete through treated and untreated plastic waste aggregates.

This study focused on sustainable and novel development of concrete through treated and untreated plastic waste aggregates. In this study, the surface of Elec-waste coarse aggregates was treated with sulfuric acid, marble dust coating, silica fume coating, and alkaline bleach. Elec-waste aggregates were used in concrete by replacing natural coarse aggregates in amounts of 10%, 20%, and 30%.

Axial stress versus strain responses of CFRP confined concrete containing electronic waste aggregates.

This research work investigates the axial stress versus strain responses of un-strengthened and carbon fiber reinforced polymer (CFRP) composites strengthened concrete specimens made with electronic waste coarse aggregates. For this purpose, 36 circular and non-circular 300 mm high concrete specimens constrained with CFRP sheets and partially replaced with E-waste coarse aggregates were prepared. The effect of cross-sectional geometry, 20% partial substitution of natural coarse aggregates with E-waste aggregates, corner effect of non-circular concrete specimens, confinement of specimens with CFRP sheets, and effect of the number of confinement sheets were also studied.

Use of Natural and Synthetic Fiber-Reinforced Composites for Punching Shear of Flat Slabs: A Comparative Study.

Over the last two decades, considerable attention has been devoted to the strengthening of sub-standard flat-slab constructions. With the evolution of composite materials and an increasing emphasis on the economical and sustainable use of natural fibers, many researchers have utilized them in the strengthening of flat flabs mitigating punching failures. This study aims at investigating and comparing the behavior of flat slabs strengthened with post-installed composite and natural reinforcements.

Remediation of Punching Shear Failure Using Glass Fiber Reinforced Polymer (GFRP) Rods.

The results of an experimental program on shear-strengthening of flat slabs using Glass Fiber Reinforced Polymer (GFRP) rods are presented. A total of seven specimens were tested under an upward concentric monotonic loading until failure. One specimen served as a control and was tested without any modification.