Effect of experimental heat treatment on mechanical properties of resin composites.

The aim of this study was to verify the influence of an experimental heat treatment (170 masculineC/10 min) using a casting furnace on the mechanical properties (hardness and flexural strength) of 2 commercial direct resin composites (TPH Spectrum and Filtek P60) compared to a commercial indirect resin system (BelleGlass). Heat treatment temperature was determined after thermal characterization by thermogravimetry (TG) and differential scanning calorimetry (DSC). Data was analyzed by ANOVA and Tukey's test at 5% significance level.

Does adhesive thickness affect resin-dentin bond strength after thermal/load cycling?

This study evaluated the influence of adhesive layer thickness (ADL) on the resin-dentin bond strength of two adhesive systems (AS) after thermal and mechanical loading (TML). A flat superficial dentin surface was exposed with 600-grit SiC paper on 40 molars. After primer application, the adhesive layer of Scotchbond Multipurpose (SBMP) or Clearfil SE Bond (CSEB) was applied in one or two layers to a delimited area (52 mm2) and resin blocks (Filtek Z250) were built incrementally.

Expansion of high flow mixtures of gypsum-bonded investments in contact with absorbent liners.

Objectives: To evaluate the expansion of high flow mixtures of gypsum-bonded investments in contact with two dry absorbent liners since early setting.

Methods: Cristobalite-Dentsply and Cristobalite-Polidental gypsum-bonded investments were tested under 10 setting conditions (n=4): Normal and Hygroscopic (controls); four conditions of 'Dry-Lining' (set in contact with 3 different amounts of dry cellulose liner: 0.2, 0.