Surface chemistry of grafted expanded poly(tetrafluoroethylene) membranes modifies the in vitro proinflammatory response in macrophages.

A series of surface-modified expanded poly(tetrafluoroethylene) membranes showed varied levels of in vitro macrophage proinflammatory response. Membranes containing a mixture of phosphate and hydroxyl groups (as determined by X-ray photoelectron spectroscopy analysis) stimulate greater macrophage activation than samples containing a mixture of phosphate and carboxylic acid segments. The types of proteins that adsorbed irreversibly from serum onto the two samples with the highest and lowest cellular response were investigated using surface-matrix-assisted laser desorption ionisation time-of-flight mass spectrometry.

Comprehensive characterization of grafted expanded poly(tetrafluoroethylene) for medical applications.

Successful implantation of any biomaterial depends on its mechanical, architectural, and surface properties. Materials with good bulk properties seldom possess the appropriate surface characteristics required for good biointegration. The present study investigates the results of surface modification of a highly porous, fully fluorinated polymeric substrate, expanded poly(tetrafluoroethylene) (ePTFE), with a view to improving the surface bioactivity and hence ultimately its biointegration.

Novel phosphate-grafted ePTFE copolymers for optimum in vitro mineralization.

Surface modification via graft copolymerization is an attractive method for optimizing polymers used in biomedical applications. We developed a novel method using a mixed solvent system (either water and dichloromethane (DCM) or water, methanol and DCM) consisting of two solvent phases for grafting 2-(methacryloyloxy)ethyl phosphate onto expanded polytetrafluoroethylene (ePTFE). This new method resulted in the fabrication of grafted membranes with greater grafting extents (GEs) (as evaluated from x-ray photoelectron spectroscopy (XPS)) in the organic phase than those obtained when grafting was carried out in a single phase.

Time-of-flight secondary ion mass spectrometry study of the orientation of a bifunctional diblock copolymer attached to a solid substrate.

A block copolymer consisting of a phosphate-containing moiety (poly[2-(methacryloyloxy)ethyl phosphate], PMOEP) and a keto-containing moiety (poly[2-(acetoacetoxy)ethyl methacrylate], PAAEMA) showed good stability after attachment to an APS amine-modified glass slide, as did both of the respective homopolymers. The PAAEMA homopolymer can attach to the APS amine groups via covalent linkages, while the PMOEP homopolymer most likely attaches through electrostatic interactions involving deprotonated phosphate and protonated amine groups. To elucidate the conformation of the block copolymer after attachment, particularly with respect to the PMOEP segment orientation, principal component analysis (PCA) of time-of-flight secondary ion mass spectrometry (ToF-SIMS) spectra of the surface-attached polymer layers was performed.

Adsorption of well-defined fluorine-containing polymers onto poly(tetrafluoroethylene).

Adsorption of well-defined fluorinated polymers onto clinically relevant poly(tetrafluoroethylene) (PTFE) substrates offers an attractive method for modifying the surface properties of chemically inert PTFE. Reversible addition-fragmentation chain transfer (RAFT) was successfully used for synthesis of the polymers in this study: the homopolymers poly(2,3,4,5,6-pentafluorostyrene) (PFS), poly(2,2,3,3-tetrafluoropropyl acrylate) (PTFPA), and poly(2,2,3,3-tetrafluoropropyl methacrylate) (PTFPMA) as well as their block copolymers with tert-butyl acrylate ( (t)BA). Water-soluble blocks were synthesized through the hydrolysis of the t-butyl side groups of P( (t)BA) to the corresponding carboxylic acid.

Influence of a diene impurity on the molecular structure of phosphate-containing polymers with medical applications.

We have demonstrated that the unacknowledged presence of almost 30% diene impurity in some commercial phosphate monomers had not only a significant effect on the molecular structure (topology) of a series of synthesized polymers but the instability of the ester functionalities during these polymerizations resulted in unexpectedly complex co-polymer chemistry.

FT-IR spectroscopy of fluoro-substituted hydroxyapatite: strengths and limitations.

Fluoro substituted hydroxyapatite (FHAp) samples were prepared by a cyclic pH method. Both calcined and uncalcined samples were subjected to elemental analysis (F, Ca, P) and X-ray diffraction (XRD) analysis to verify composition and phase purity. Good correlation between a-axis parameters and fluoride ion content was found for calcined samples, however, for uncalcined samples the fluoride ion content was higher than estimated from the a-axis values.

Synthesis of soluble phosphate polymers by RAFT and their in vitro mineralization.

Soluble linear (non-cross-linked) poly(monoacryloxyethyl phosphate) (PMAEP) and poly(2-(methacryloyloxy)ethyl phosphate) (PMOEP) were successfully synthesized through reversible addition-fragmentation chain transfer (RAFT)-mediated polymerization and by keeping the molecular weight below 20 K. Above this molecular weight, insoluble (cross-linked) polymers were observed, postulated to be due to residual diene (cross-linkable) monomers formed during purification of the monomers, MOEP and MAEP. Block copolymers consisting of PMAEP or PMOEP and poly(2-(acetoacetoxy)ethyl methacrylate) (PAAEMA) were successfully prepared and were immobilized on aminated slides.

In vitro bioactivity of MOEP grafted ePTFE membranes for craniofacial applications.

The bioactivity of three methacryloyloxyethyl phosphate (MOEP) grafted expanded polytetrafluoroethylene (ePTFE) membranes with varying surface coverage as well as unmodified ePTFE was investigated through a series of in vitro tests: calcium phosphate (CaP) growth in simulated body fluid (SBF), serum protein adsorption, and a morphology and attachment study of human osteoblast-like SaOS-2 cells. The graft copolymers were prepared by means of gamma irradiation induced grafting and displayed various surface morphologies and wettabilities depending on the grafting conditions used. Unmodified ePTFE did not induce nucleation of CaP minerals, whereas all the grafted membranes revealed the growth of CaP minerals after 7 days immersion in SBF.

Calcium phosphate nucleation on surface-modified PTFE membranes.

Highly porous PTFE membranes are currently being used in facial reconstructive surgery. The present study aims at improving this biomaterial through creating a more bioactive surface by introducing ionic groups onto the surface. The unmodified PTFE membrane does not induce inorganic growth after immersion in simulated body fluid (SBF) for up to 4 weeks.

Investigation into the diffusion of water into HEMA-co-MOEP hydrogels.

Cross-linked homopolymers and copolymers of 2-hydroxyethyl methacrylate, HEMA, and ethylene glycol methacrylate phosphate, MOEP, have been synthesized, and the diffusion of water into these systems has been investigated. Only polymers with 0-20 mol % MOEP exhibited ideal swelling behavior as extensive fracturing occurred in the systems with greater than 20 mol % MOEP as the polymers began to swell during water sorption. Gravimetric studies were used in conjunction with magnetic resonance imaging of the diffusion front to elucidate the diffusion mechanism for these systems.