Improvement of H2S sensing properties of SnO2-based thick film gas sensors promoted with MoO3 and NiO.

The effects of the SnO2 pore size and metal oxide promoters on the sensing properties of SnO2-based thick film gas sensors were investigated to improve the detection of very low H2S concentrations (<1 ppm). SnO2 sensors and SnO2-based thick-film gas sensors promoted with NiO, ZnO, MoO3, CuO or Fe2O3 were prepared, and their sensing properties were examined in a flow system. The SnO2 materials were prepared by calcining SnO2 at 600, 800, 1,000 and 1,200 °C to give materials identified as SnO2(600), SnO2(800), SnO2(1000), and SnO2(1200), respectively.

ZnO nanorods, nanotubes and nanorings: controlled synthesis and structural properties.

Controlled synthesis of ZnO nanorods (ZNRDs), nanotubes (ZNTs) and nanorings (ZNRs) has been carried out by a two-step sonochemical/chemical process at room temperature without any catalyst, template or seed layer. The crystallinity, structure and morphology of ZNRDs, ZNRs and ZNTs were examined by X-ray diffraction (XRD) analysis, scanning electron micrographs (SEM), high resolution transmission electron microscope (HR-TEM) and selected area electron diffraction (SAED). The as-prepared ZnO nanostructures were single crystalline with hexagonal cross-section and uniform size.

Effects of textural properties on the response of a SnO2-based gas sensor for the detection of chemical warfare agents.

The sensing behavior of SnO(2)-based thick film gas sensors in a flow system in the presence of a very low concentration (ppb level) of chemical agent simulants such as acetonitrile, dipropylene glycol methyl ether (DPGME), dimethyl methylphosphonate (DMMP), and dichloromethane (DCM) was investigated. Commercial SnO(2) [SnO(2)(C)] and nano-SnO(2) prepared by the precipitation method [SnO(2)(P)] were used to prepare the SnO(2) sensor in this study. In the case of DCM and acetonitrile, the SnO(2)(P) sensor showed higher sensor response as compared with the SnO(2)(C) sensors.