Publications by authors named "Dorlot J"

Six pairs of alumina components of Ceraver-Ostéal total hip prostheses, which were implanted from nine to 12 years, were studied. In the load-bearing areas, the wear takes the form of relief polishing. The depth of wear, after a running-in period, is less than 0.

View Article and Find Full Text PDF

The wear behavior of hip prostheses alumina components was studied on 20 retrieved implants removed for socket loosening. The observed wear takes two forms: a running-in of the mating surfaces and a gross disruption of the surfaces. The running-in is very shallow, in the order of 0.

View Article and Find Full Text PDF

The purpose of this article was to review the laboratory and clinical performances since 1970 of a total hip prosthesis using alumina-alumina combination. The chemical and physical properties of dense alumina ceramic were studied in relation to biocompatibility, mechanical strength, and surface properties. Through the examination of 35 retrieved implants, it was found that the long-term success of alumina-alumina total hip replacement depends on both the ceramic microstructure (small grain size with uniform distribution, minimum porosity, absence of inclusions) and implant geometry (sphericity deviation +/- 1 micron, radius tolerance between components 7-10 microns).

View Article and Find Full Text PDF

In order to evaluate the contribution of both anterior (ACL) and posterior cruciate ligaments (PCL) in antero-posterior knee laxity, mechanical tests were performed on 31 fresh-cadaver-knees ranging from 20 to 68 years old. The joints flexed at 90 degrees in a mounting apparatus were placed in a testing machine with the tibia fixed in neutral rotation. The load-displacement curves were then analyzed.

View Article and Find Full Text PDF

This paper describes the results of an investigation on the mechanical properties of canine anterior cruciate ligaments. A total of 38 ligaments were tested. It is shown that the completely reversible (elastic) range of strain is limited to 14 percent elongation, corresponding to an applied load of 200 N.

View Article and Find Full Text PDF