Conidial mass production of entomopathogenic fungi and tolerance of their mass-produced conidia to UV-B radiation and heat.

We investigated conidial mass production of eight isolates of six entomopathogenic fungi (EPF), Aphanocladium album (ARSEF 1329), Beauveria bassiana (ARSEF 252 and 3462), Lecanicillium aphanocladii (ARSEF 6433), Metarhizium anisopliae sensu lato (ARSEF 2341), Metarhizium pingshaense (ARSEF 1545), and Simplicillium lanosoniveum (ARSEF 6430 and 6651) on white or brown rice at four moisture conditions (75-100%). The tolerance of mass-produced conidia of the eight fungal isolates to UV-B radiation and heat (45 °C) were also evaluated. For each moisture content compared, a 20-g sample of rice in a polypropylene bag was inoculated with each fungal isolate in three replicates and incubated at 28 ± 1 °C for 14 days.

Asphyxiation of Metarhizium robertsii during mycelial growth produces conidia with increased stress tolerance via increased expression of stress-related genes.

Little is known about the impact of hypoxia and anoxia during mycelial growth on tolerance to different stress conditions of developing fungal conidia. Conidia of the insect-pathogenic fungus Metarhizium robertsii were produced on potato dextrose agar (PDA) medium under normoxia (control = normal oxygen concentrations), continuous hypoxia, and transient anoxia, as well as minimal medium under normoxia. The tolerance of the conidia produced under these different conditions was evaluated in relation to wet heat (heat stress), menadione (oxidative stress), potassium chloride (osmotic stress), UV radiation, and 4-nitroquinoline-1-oxide (=4-NQO genotoxic stress).

Low- or high-white light irradiance induces similar conidial stress tolerance in Metarhizium robertsii.

White light during mycelial growth influences high conidial stress tolerance of the insect-pathogenic fungus Metarhizium robertsii, but little is known if low- or high-white light irradiances induce different stress tolerances. The fungus was grown either in the dark using two culture media: on minimal medium (Czapek medium without sucrose = MM) or on potato dextrose agar (PDA) or PDA medium under five different continuous white light irradiances. The stress tolerances of conidia produced on all treatments were evaluated by conidial germination on PDA supplemented with KCl for osmotic stress or on PDA supplemented with menadione for oxidative stress.

Virulence of the insect-pathogenic fungi spp. to Mormon crickets, (Orthoptera: Tettigoniidae).

The Mormon cricket (MC), Anabrus simplex Haldeman, 1852 (Orthoptera: Tettigoniidae), has a long and negative history with agriculture in Utah and other western states of the USA. Most A. simplex populations migrate in large groups, and their feeding can cause significant damage to forage plants and cultivated crops.

A framework for automated and streamlined kV cone beam computed tomography image quality assurance: a multi-institutional study.

The purpose of this study was to develop and evaluate a framework to support automated standardized testing and analysis of Cone Beam Computed Tomography (CBCT) image quality QA across multiple institutions. A survey was conducted among the participating institutions to understand the variability of the CBCT QA practices. A commercial, automated software platform was validated by seven institutions participating in a consortium dedicated to automated quality assurance.

UV-B tolerances of conidia, blastospores, and microsclerotia of Metarhizium spp. entomopathogenic fungi.

The aim of the present study was to analyze ten native Metarhizium spp. isolates as to their UV-B tolerances. Comparisons included: different fungal propagules (conidia, blastospores, or microsclerotia [MS]); conidia in aqueous suspensions or in 10% mineral oil-in-water emulsions; and conidia mixed with different types of soil.

Possible source of the high UV-B and heat tolerance of Metarhizium acridum (isolate ARSEF 324).

The isolate ARSEF 324 of Metarhizium acridum is very tolerant to UV-B radiation and heat, but the intrinsic traits behind the extreme tolerance of this isolate to both stress conditions have not been elucidated. Because trehalose and mannitol are documented stress reducers in fungi, we investigated the accumulation of these compounds in conidia of ARSEF 324 compared with the accumulation of these two compounds in conidia of M. robertsii (ARSEF 23 and ARSEF 2575), which are considerably more susceptible to UV-B radiation and heat than ARSEF 324.

Species of the Metarhizium anisopliae complex with diverse ecological niches display different susceptibilities to antifungal agents.

Species of the Metarhizium anisopliae complex are globally ubiquitous soil-inhabiting and predominantly insect-pathogenic fungi. The Metarhizium genus contains species ranging from specialists, such as Metarhizium acridum that only infects acridids, to generalists, such as M. anisopliae, Metarhizium brunneum, and Metarhizium robertsii that infect a broad range of insects and can also colonize plant roots.

Revisiting fetal dose during radiation therapy: evaluating treatment techniques and a custom shield.

To create a comprehensive dataset of peripheral dose (PD) measurements from a new generation of linear accelerators with and without the presence of a newly designed fetal shield, PD measurements were performed to evaluate the effects of depth, field size, distance from the field edge, collimator angle, and beam modi-fiers for common treatment protocols and modalities. A custom fetal lead shield was designed and made for our department that allows external beam treatments from multiple angles while minimizing the need to adjust the shield during patient treatments. PD measurements were acquired for a comprehensive series of static fields on a stack of Solid Water.

Effect of heat stress and oil formulation on conidial germination of Metarhizium anisopliae s.s. on tick cuticle and artificial medium.

The effect of heat stress (45°C) versus non-heat stress (27°C) on germination of Metarhizium anisopliae sensu stricto (s.s.) isolate IP 119 was examined with conidia formulated (suspended) in pure mineral oil or in water (Tween 80, 0.

Combination esthetic treatment of anterior teeth affected by idiopathic enamel hypoplasia: a case report.

The esthetic management of enamel dysplasia presents an opportunity for the practitioner to integrate expertise in diagnosis, biomaterials, and technique. In addition to considerations of appearance, careful attention must be paid to occlusal function and restorative material properties. This case report highlights a combined approach of conservative lithium disilicate indirect restorations and composite resin direct veneers to electively restore the anterior teeth of a patient diagnosed with idiopathic enamel hypoplasia.

Development of a brachytherapy audit checklist tool.

Purpose: To develop a brachytherapy audit checklist that could be used to prepare for Nuclear Regulatory Commission or agreement state inspections, to aid in readiness for a practice accreditation visit, or to be used as an annual internal audit tool.

Methods And Materials: Six board-certified medical physicists and one radiation oncologist conducted a thorough review of brachytherapy-related literature and practice guidelines published by professional organizations and federal regulations. The team members worked at two facilities that are part of a large, academic health care center.

Tolerance of entomopathogenic fungi to ultraviolet radiation: a review on screening of strains and their formulation.

Ultraviolet radiation from sunlight is probably the most detrimental environmental factor affecting the viability of entomopathogenic fungi applied to solar-exposed sites (e.g., leaves) for pest control.

Dosimetric measurements of an n-butyl cyanoacrylate embolization material for arteriovenous malformations.

Purpose: The therapeutic regimen for cranial arteriovenous malformations often involves both stereotactic radiosurgery and endovascular embolization. Embolization agents may contain tantalum or other contrast agents to assist the neurointerventionalists, leading to concerns regarding the dosimetric effects of these agents. This study investigated dosimetric properties of n-butyl cyanoacrylate (n-BCA) plus lipiodol with and without tantalum powder.

Molecular and physiological effects of environmental UV radiation on fungal conidia.

Conidia are specialized structures produced at the end of the asexual life cycle of most filamentous fungi. They are responsible for fungal dispersal and environmental persistence. In pathogenic species, they are also involved in host recognition and infection.

Stress tolerance and virulence of insect-pathogenic fungi are determined by environmental conditions during conidial formation.

The virulence to insects and tolerance to heat and UV-B radiation of conidia of entomopathogenic fungi are greatly influenced by physical, chemical, and nutritional conditions during mycelial growth. This is evidenced, for example, by the stress phenotypes of Metarhizium robertsii produced on various substrates. Conidia from minimal medium (Czapek's medium without sucrose), complex medium, and insect (Lepidoptera and Coleoptera) cadavers had high, moderate, and poor tolerance to UV-B radiation, respectively.

The influence of conidial Pr1 protease on pathogenicity potential of Metarhizium anisopliae senso latu to ticks.

Pr1 is a subtilisin-like protease produced by Metarhizium spp. entomopathogenic fungi, and it is recognized as heavily involved in the initial steps of the fungal invasion of arthropod-host cuticles. In the current study, correlation was sought between mortality of tick larvae and conidial Pr1 levels of one Metarhizium anisopliae senso latu (s.

Selective patellar resurfacing in total knee arthroplasty: a prospective, randomized, double-blind study.

350 knees were evaluated in a prospective, randomized, double-blinded study of selective patellar resurfacing in primary total knee arthroplasty. Knees with exposed bone on the patellar articular surface were excluded. 327 knees were evaluated at a mean follow-up of 7.

Production of destruxins from Metarhizium spp. fungi in artificial medium and in endophytically colonized cowpea plants.

Destruxins (DTXs) are cyclic depsipeptides produced by many Metarhizium isolates that have long been assumed to contribute to virulence of these entomopathogenic fungi. We evaluated the virulence of 20 Metarhizium isolates against insect larvae and measured the concentration of DTXs A, B, and E produced by these same isolates in submerged (shaken) cultures. Eight of the isolates (ARSEF 324, 724, 760, 1448, 1882, 1883, 3479, and 3918) did not produce DTXs A, B, or E during the five days of submerged culture.

Heat-induced post-stress growth delay: a biological trait of many Metarhizium isolates reducing biocontrol efficacy?

The habitats of many pest insects have fluctuating climatic conditions. To function effectively, the pathogens of these pests must be capable of infecting and developing disease at a wide range of temperatures. The current study examines ten Metarhizium spp.

Response to: Bouwman, H. et al. Hallogenated pollutants in terrestrial and aquatic bird eggs: converging patterns of pollutant profiles, and impacts and risks from higher levels Environ. Res. (2013) http://dx.doi.org/10.1016/j.envres.2013.06.003.

Bouwman and coauthors present data and analyses of DDT and other halogenated pollutants in environmental samples and based on their data and analyses thereof, argue against the use of DDT for malaria control. Regrettably, the analyses, presentations, and interpretations of data presented by Bouwman and coauthors are biased and erroneous.