Echocardiographic predictors of surgical outcomes in pulmonary atresia with intact ventricular septum and development of a discriminatory calculator: an Australian tertiary institution experience.

Introduction: Pulmonary atresia with intact ventricular septum is a rare congenital cardiac lesion with significant anatomical heterogeneity. Surgical planning of borderline cases remains challenging and is primarily based on echocardiography. The aim was to identify echocardiographic parameters that correlate with surgical outcome and to develop a discriminatory calculator.

Properties of hot-melt extruded tablet formulations for the colonic delivery of 5-aminosalicylic acid.

Hot-melt extruded tablets were prepared using Eudragit S 100 as the polymeric carrier to target delivery of 5-aminosalicylic acid (5-ASA) to the colon. Scanning electron microscopy, modulated differential scanning calorimetry and X-ray diffraction analysis of the hot-melt tablet extrudates demonstrated that 5-ASA remained crystalline and was homogeneously dispersed throughout the polymer matrix. A pre-plasticization step was necessary when incorporating triethyl citrate (TEC) into the formulation in order to achieve uniform mixing of the polymer and plasticizer, effectively reduce the polymer glass transition temperature (T(g)), and to lower the processing temperatures.

The influence of polymeric subcoats and pellet formulation on the release of chlorpheniramine maleate from enteric coated pellets.

The influences of aqueous polymeric subcoats and pellet composition on the release properties of a highly water-soluble drug, chlorpheniramine maleate (CPM), from enteric coated pellets were investigated. Three different aqueous polymeric subcoats, Eudragit RD 100, Eudragit RS 30D, and Opadry AMB, were applied to 10% w/w CPM-loaded pellets that were then enteric coated with Eudragit L 30D-55. Observed drug release from the coated pellets in acidic media correlated with water vapor transmission rates derived for the subcoat films.

Properties of enteric coated sodium valproate pellets.

The influence of subcoat application and micro-environmental pH on the dissolution properties of enteric coated sodium valproate pellets was investigated. The pellets were prepared by solution-layering or wet-mass extrusion-spheronization methods. In order to pass the USP enteric test, the solution-layered and wet-mass extruded pellets required 35 and 25% weight gain of Eudragit L 30D-55, respectively.