Short single-frequency self-pulsing Brillouin-Raman distributed feedback fiber laser.

We demonstrate that the stimulated Brillouin scattering of a 250 mm long distributed feedback Raman fiber laser can self-pulse with repetition rates up to 7 MHz, pulse widths of 25 ns, and peak powers of 1.2 W. While both CW and pulsed lasing are produced from a bespoke grating at 1119 nm this laser design could be constructed at almost any wavelength, as the Raman and Brillouin gain regions are relative to the pump wavelength.

Individual inscription of spectrally multiplexed Bragg gratings in optical multicore fibers using small spot direct UV writing.

We have demonstrated the inscription of Bragg gratings into five individual cores of a seven core fiber using small spot direct UV writing. With this technique, we defined spectrally multiplexed Bragg gratings consecutively in separate cores as well as spectrally multiplexed gratings at the same longitudinal location in different cores. The effect of bending on the optical spectrum was evaluated to allow the differentiation between cross-exposure and cross-talk, and an alignment process to reduce cross-exposure by 13 dB was found.

Highly-chirped Bragg gratings for integrated silica spectrometers.

A blazed chirped Bragg grating in a planar silica waveguide device was used to create an integrated diffractive element for a spectrometer. The grating diffracts light from a waveguide and creates a wavelength dependent focus in a manner similar to a bulk diffraction grating spectrometer. An external imaging system is used to analyse the light, later device iterations plan to integrate detectors to make a fully integrated spectrometer.

Integrated polarizer based on 45° tilted gratings.

We report the first integrated implementation of a polarizer based on the use of 45° tilted gratings in planar waveguides. The waveguides and gratings are fabricated by direct UV writing in a hydrogenated germanium-doped silica-on-silicon chip. We experimentally demonstrate a polarization extinction ratio per unit length of 0.

Thermal approach to classifying sequentially written fiber Bragg gratings.

We demonstrate thermal classification of sequentially written fiber Bragg gratings. This Letter presents a process to determine the type of fiber Bragg grating written in SMF28 and GF4A by introducing the gratings to thermal treatment. This technique can be applied to several approaches based on sequential writing, including the small spot direct ultraviolet writing technique.

High-birefringence direct UV-written waveguides for use as heralded single-photon sources at telecommunication wavelengths.

Direct UV-written waveguides are fabricated in silica-on-silicon with birefringence of (4.9 ± 0.2) × 10, much greater than previously reported in this platform.

Leaky mode integrated optical fibre refractometer.

A route to monitor external refractive indices greater than the core index of the waveguide is presented. Initial application utilizes an integrated optical fibre (IOF) platform due to its potential for use in harsh environment sensing. IOF is fabricated using a bespoke flame hydrolysis deposition process to fuse an optical fibre to a planar substrate achieving an optical quality, ruggedized glass layer between the fibre and substrate was fabricated.

Conclusive quantum steering with superconducting transition-edge sensors.

Quantum steering allows two parties to verify shared entanglement even if one measurement device is untrusted. A conclusive demonstration of steering through the violation of a steering inequality is of considerable fundamental interest and opens up applications in quantum communication. To date, all experimental tests with single-photon states have relied on post selection, allowing untrusted devices to cheat by hiding unfavourable events in losses.