Accuracy of Complete-Arch Implant Digital Scans: Effect of Scanning Protocol, Number of Implants, and Scan Body Splinting.

Purpose: To determine the effect of scanning protocol, number of implants, and implant splinting on the accuracy of digital scanning in the edentulous arch.

Materials And Methods: A resin-based model of an edentulous mandible with six implants was scanned with a coordinate measurement machine as a reference and then with two intraoral scanner (IOS) systems (Trios 3 and Primescan). Ten scans were taken per IOS for three experiments, and each scan was compared to the reference data to evaluate trueness and precision.

Severe periodontitis and orthodontics: evaluation of long-term results.

Unlabelled: Clinical manifestations of severe periodontitis are very often associated with tooth migration. The aim of this retrospective study is to evaluate dental bone support before orthodontic-periodontal treatment, at immediate postoperative, and long-term postoperative and to compare these results with those obtained from periodontal treatment alone. Fifteen patients (11 women and four men), all with severe periodontitis, mean age 42.

Compatibility of five self-etching adhesive systems with two resin luting cements.

Purpose: The aim of this study was to evaluate the compatibility between five self-etching bonding systems (SEBSs) and two resin luting cements (RLCs) assessed by use of an in vitro dentin shear bond test.

Materials And Methods: The selected RLCs were: Variolink II in a dual-cure mode and Multilink in a self-cure mode. The SEBSs combined with the RLCs were: two one-step SEBSs (One Up Bond F and Xeno III) and three two-step SEBSs (Clearfil SE Bond, Unifil Bond, and Xeno III primer coupled with Clearfil SE Bond bonding resin as an experimental combination).

Influence of self-etching primer preapplication on the dentin-titanium shear bond strength mediated by a resin-modified glass-lonomer cement.

Purpose: The aims of this study were to evaluate the in vitro shear bond strength of the dentin-titanium interface mediated by Fuji Plus, a resin-modified glass-ionomer cement, applied in combination with several self-etching bonding systems, and to compare the values obtained with those of SuperBond, chosen as a reference luting agent.

Materials And Methods: The self-etching bonding systems used in combination with Fuji Plus were AdheSE, Xeno III, Clearfil SEBond, Unifil Bond, and an experimental self-etching bonding system comprising the sequential application of Xeno III and the bonding component of SE Bond. Two control groups were also tested: a negative control with Fuji Plus along with its conditioner (10% ferric chloride, 2% citric acid solution); and a positive control with the resin cement SuperBond.

In vitro evaluation of different techniques of enamel preparation for pit and fissure sealing.

Purpose: To compare the penetration and the imperviousness of two pit and fissure sealants according to surface treatments involving different cleaning procedures with or without subsequent acid etching.

Materials And Methods: Two sealants were used: a resin-based sealant (Concise White Sealant) and a compomer-based material (Dyract Seal) coupled with an enamel-dentin bonding agent (Dyract Seal and Prime&Bond NT). Extracted molars (n = 120) were randomly divided into 12 groups: 4 control and 8 experimental groups that received different surface treatments.