Direct Measurements of DT Fuel Preheat from Hot Electrons in Direct-Drive Inertial Confinement Fusion.

Hot electrons generated by laser-plasma instabilities degrade the performance of laser-fusion implosions by preheating the DT fuel and reducing core compression. The hot-electron energy deposition in the DT fuel has been directly measured for the first time by comparing the hard x-ray signals between DT-layered and mass-equivalent ablator-only implosions. The electron energy deposition profile in the fuel is inferred through dedicated experiments using Cu-doped payloads of varying thickness.

Tripled yield in direct-drive laser fusion through statistical modelling.

Focusing laser light onto a very small target can produce the conditions for laboratory-scale nuclear fusion of hydrogen isotopes. The lack of accurate predictive models, which are essential for the design of high-performance laser-fusion experiments, is a major obstacle to achieving thermonuclear ignition. Here we report a statistical approach that was used to design and quantitatively predict the results of implosions of solid deuterium-tritium targets carried out with the 30-kilojoule OMEGA laser system, leading to tripling of the fusion yield to its highest value so far for direct-drive laser fusion.

Erratum: Measurement of Body-Centered-Cubic Aluminum at 475 GPa [Phys. Rev. Lett. 119, 175702 (2017)].

This corrects the article DOI: 10.1103/PhysRevLett.119.

Measurement of Body-Centered-Cubic Aluminum at 475 GPa.

Nanosecond in situ x-ray diffraction and simultaneous velocimetry measurements were used to determine the crystal structure and pressure, respectively, of ramp-compressed aluminum at stress states between 111 and 475 GPa. The solid-solid Al phase transformations, fcc-hcp and hcp-bcc, are observed at 216±9 and 321±12  GPa, respectively, with the bcc phase persisting to 475 GPa. The high-pressure crystallographic texture of the hcp and bcc phases suggests close-packed or nearly close-packed lattice planes remain parallel through both transformations.

Plasma characterization using ultraviolet Thomson scattering from ion-acoustic and electron plasma waves (invited).

Collective Thomson scattering is a technique for measuring the plasma conditions in laser-plasma experiments. Simultaneous measurements of ion-acoustic and electron plasma-wave spectra were obtained using a 263.25-nm Thomson-scattering probe beam.

Publisher's Note: Demonstration of Fuel Hot-Spot Pressure in Excess of 50 Gbar for Direct-Drive, Layered Deuterium-Tritium Implosions on OMEGA [Phys. Rev. Lett. 117, 025001 (2016)].

This corrects the article DOI: 10.1103/PhysRevLett.117.

Demonstration of Fuel Hot-Spot Pressure in Excess of 50 Gbar for Direct-Drive, Layered Deuterium-Tritium Implosions on OMEGA.

A record fuel hot-spot pressure P_{hs}=56±7  Gbar was inferred from x-ray and nuclear diagnostics for direct-drive inertial confinement fusion cryogenic, layered deuterium-tritium implosions on the 60-beam, 30-kJ, 351-nm OMEGA Laser System. When hydrodynamically scaled to the energy of the National Ignition Facility, these implosions achieved a Lawson parameter ∼60% of the value required for ignition [A. Bose et al.

Two-Plasmon Decay Mitigation in Direct-Drive Inertial-Confinement-Fusion Experiments Using Multilayer Targets.

Multilayer direct-drive inertial-confinement-fusion targets are shown to significantly reduce two-plasmon decay (TPD) driven hot-electron production while maintaining high hydrodynamic efficiency. Implosion experiments on the OMEGA laser used targets with silicon layered between an inner beryllium and outer silicon-doped plastic ablator. A factor-of-5 reduction in hot-electron generation (>50  keV) was observed in the multilayer targets relative to pure CH targets.

Gigabar spherical shock generation on the OMEGA laser.

This Letter presents the first experimental demonstration of the capability to launch shocks of several-hundred Mbar in spherical targets--a milestone for shock ignition [R. Betti et al., Phys.

Ion thermal decoupling and species separation in shock-driven implosions.

Anomalous reduction of the fusion yields by 50% and anomalous scaling of the burn-averaged ion temperatures with the ion-species fraction has been observed for the first time in D^{3}He-filled shock-driven inertial confinement fusion implosions. Two ion kinetic mechanisms are used to explain the anomalous observations: thermal decoupling of the D and ^{3}He populations and diffusive species separation. The observed insensitivity of ion temperature to a varying deuterium fraction is shown to be a signature of ion thermal decoupling in shock-heated plasmas.

Exploration of the transition from the hydrodynamiclike to the strongly kinetic regime in shock-driven implosions.

Clear evidence of the transition from hydrodynamiclike to strongly kinetic shock-driven implosions is, for the first time, revealed and quantitatively assessed. Implosions with a range of initial equimolar D3He gas densities show that as the density is decreased, hydrodynamic simulations strongly diverge from and increasingly overpredict the observed nuclear yields, from a factor of ∼2 at 3.1  mg/cm3 to a factor of 100 at 0.

First observations of nonhydrodynamic mix at the fuel-shell interface in shock-driven inertial confinement implosions.

A strong nonhydrodynamic mechanism generating atomic fuel-shell mix has been observed in strongly shocked inertial confinement fusion implosions of thin deuterated-plastic shells filled with 3He gas. These implosions were found to produce D3He-proton shock yields comparable to implosions of identical shells filled with a hydroequivalent 50∶50 D3He gas mixture. Standard hydrodynamic mixing cannot explain this observation, as hydrodynamic modeling including mix predicts a yield an order of magnitude lower than was observed.

Soft x-ray backlighting of direct-drive implosions using a spherical crystal imager on OMEGA.

Using a spherically bent quartz crystal for the Si He(α) line at ~1.865 keV, a narrowband x-ray imager has been deployed at the Omega Laser Facility to record backlit images of direct-drive laser implosions. The crystal was cut along the 1011 planes for a 2d spacing of 0.

Evidence for stratification of deuterium-tritium fuel in inertial confinement fusion implosions.

Measurements of the D(d,p)T (dd) and T(t,2n)(4)He (tt) reaction yields have been compared with those of the D(t,n)(4)He (dt) reaction yield, using deuterium-tritium gas-filled inertial confinement fusion capsule implosions. In these experiments, carried out on the OMEGA laser, absolute spectral measurements of dd protons and tt neutrons were obtained. From these measurements, it was concluded that the dd yield is anomalously low and the tt yield is anomalously high relative to the dt yield, an observation that we conjecture to be caused by a stratification of the fuel in the implosion core.

Measurements of core and compressed-shell temperature and density conditions in thick-wall target implosions at the OMEGA laser facility.

A spectroscopic method is discussed to measure core and compressed-shell conditions in thick-wall plastic-shell implosions filled with deuterium and a tracer amount of argon. Simultaneous observation over a broad photon energy range of the argon line emission and the attenuation and self-emission effects of the compressed shell confining the core yields enough information to extract average temperature and density conditions in both core and compressed shell. The spectroscopic analysis also provides an estimate of the target areal density which is an important characteristic of inertial confinement fusion implosions.

Scaling hot-electron generation to high-power, kilojoule-class laser-solid interactions.

Thin-foil targets were irradiated with high-power (1 ≤ P(L) ≤ 210 TW), 10-ps pulses focused to intensities of I>10(18) W/cm(2) and studied with K-photon spectroscopy. Comparing the energy emitted in K photons to target-heating calculations shows a laser-energy-coupling efficiency to hot electrons of η(L-e) = 20 ± 10%. Time-resolved x-ray emission measurements suggest that laser energy is coupled to hot electrons over the entire duration of the incident laser drive.

Spectroscopic modeling of an argon-doped shock-ignition implosion.

We present results from the spectral postprocessing of a one-dimensional hydrodynamic simulation of an argon-doped, warm-shell shock-ignition implosion with a detailed atomic and radiation physics model. The argon tracer is added to the deuterium filling in the core for diagnostic purposes. Spectral features in the emergent intensity distribution in the photon energy range of the argon K-shell spectrum that have potential for diagnostic application are discussed.

Implosion experiments using glass ablators for direct-drive inertial confinement fusion.

Direct-drive implosions with 20-microm-thick glass shells were conducted on the Omega Laser Facility to test the performance of high-Z glass ablators for direct-drive, inertial confinement fusion. The x-ray signal caused by hot electrons generated by two-plasmon-decay instability was reduced by more than approximately 40x and hot-electron temperature by approximately 2x in the glass compared to plastic ablators at ignition-relevant drive intensities of approximately 1x10(15) W/cm2, suggesting reduced target preheat. The measured absorption and compression were close to 1D predictions.

Rayleigh-Taylor growth measurements in the acceleration phase of spherical implosions on OMEGA.

The Rayleigh-Taylor (RT) growth of 3D broadband nonuniformities was measured using x-ray radiography in spherical plastic shells accelerated by laser light at an intensity of approximately 2 x 10(14) W/cm(2). The 20- and 24-microm-thick spherical shells were imploded with 54 beams on the OMEGA laser system. The shells contained diagnostic openings for backlighter x rays used to image shell modulations.

Optimizing electron-positron pair production on kilojoule-class high-intensity lasers for the purpose of pair-plasma creation.

Expressions for the yield of electron-positron pairs, their energy spectra, and production rates have been obtained in the interaction of multi-kJ pulses of high-intensity laser light interacting with solid targets. The Bethe-Heitler conversion of hard x-ray bremsstrahlung [D. A.

Plasma-density determination from x-ray radiography of laser-driven spherical implosions.

The fuel layer density of an imploding laser-driven spherical shell is inferred from framed x-ray radiographs. The density distribution is determined by using Abel inversion to compute the radial distribution of the opacity kappa from the observed optical depth tau. With the additional assumption of the mass of the remaining fuel, the absolute density distribution is determined.

Comparison of genetic-algorithm and emissivity-ratio analyses of image data from OMEGA implosion cores.

Detailed analysis of x-ray narrow-band images from argon-doped deuterium-filled inertial confinement fusion implosion experiments yields information about the temperature spatial structure in the core at the collapse of the implosion. We discuss the analysis of direct-drive implosion experiments at OMEGA, in which multiple narrow-band images were recorded with a multimonochromatic x-ray imaging instrument. The temperature spatial structure is investigated by using the sensitivity of the Ly beta/He beta line emissivity ratio to the temperature.

Analysis of time-resolved argon line spectra from OMEGA direct-drive implosions.

We discuss the observation and data analysis of argon K-shell line spectra from argon-doped deuterium-filled OMEGA direct-drive implosion cores based on data recorded with two streaked crystal spectrometers. The targets were 870 microm in diameter, 27 microm wall thickness plastic shells filled with 20 atm of deuterium gas, and a tracer amount of argon for diagnostic purposes. The argon K-shell line spectrum is primarily emitted at the collapse of the implosion and its analysis provides a spectroscopic diagnostic of the core implosion conditions.