Role of Crystallization in the Morphology of Polymer:Non-fullerene Acceptor Bulk Heterojunctions.

Many high efficiency organic photovoltaics use fullerene-based acceptors despite their high production cost, weak optical absorption in the visible range, and limited synthetic variability of electronic and optical properties. To circumvent this deficiency, non-fullerene small-molecule acceptors have been developed that have good synthetic flexibility, allowing for precise tuning of optoelectronic properties, leading to enhanced absorption of the solar spectrum and increased open-circuit voltages (V). We examined the detailed morphology of bulk heterojunctions of poly(3-hexylthiophene) and the small-molecule acceptor HPI-BT to reveal structural changes that lead to improvements in the fill factor of solar cells upon thermal annealing.

Correlation of morphology with photocurrent generation in a polymer blend photovoltaic device.

Morphological effects on photovoltaic (PV) properties are studied through scanning photocurrent (PC) and photoluminescence (PL) microscopy of a solution processed, polymer blend PV device composed of PFB [poly(9,9'-dioctylfluorene-co-bis-N,N-(4-butylphenyl)-bis-N,N-phenyl-1,4-phenylenediamine] and F8BT [poly(9,9'-dioctylfluorene-co-benzothiadiazole]. As PFB and F8BT have unique absorbance bands, it is possible to selectively excite only F8BT (488 nm) or both PFB and F8BT (408 nm). Local voltage-dependent photocurrent (LVPC) measurements from particular regions of interest in the PV show that the diode characteristics between different morphologies are essentially the same, except in regard to the magnitude of PC generated.

Copper indium gallium selenide (CIGS) photovoltaic devices made using multistep selenization of nanocrystal films.

The power conversion efficiency of photovoltaic devices made with ink-deposited Cu(InxGa1-x)Se2 (CIGS) nanocrystal layers can be enhanced by sintering the nanocrystals with a high temperature selenization process. This process, however, can be challenging to control. Here, we report that ink deposition followed by annealing under inert gas and then selenization can provide better control over CIGS nanocrystal sintering and yield generally improved device efficiency.

Influence of composition on the performance of sintered Cu(In,Ga)Se2 nanocrystal thin-film photovoltaic devices.

Thin-film photovoltaic devices (PVs) were prepared by selenization using oleylamine-capped Cu(In,Ga)Se2 (CIGS) nanocrystals sintered at a high temperature (>500 °C) under Se vapor. The device performance varied significantly with [Ga]/[In+Ga] content in the nanocrystals. The highest power conversion efficiency (PCE) observed in the devices studied was 5.

The effects of aggregation on electronic and optical properties of oligothiophene particles.

Solution processing of oligothiophene molecules is shown to produce a range of particles with distinct morphologies. Once isolated on a substrate, the optical and electronic properties of individual particles were studied. From polarized scanning confocal microscopy experiments, distinct particles that are identifiable by shape were shown to have similar emission spectra except in regard to the 0-0 vibronic band intensity.