Multimodal noncontact atomic force microscopy and Kelvin probe force microscopy investigations of organolead tribromide perovskite single crystals.

In this work, methylammonium lead tribromide (MAPbBr) single crystals are studied by noncontact atomic force microscopy (nc-AFM) and Kelvin probe force microscopy (KPFM). We demonstrate that the surface photovoltage and crystal photostriction can be simultaneously investigated by implementing a specific protocol based on the acquisition of the tip height and surface potential during illumination sequences. The obtained data confirm the existence of lattice expansion under illumination in MAPbBr and that negative photocarriers accumulate near the crystal surface due to band bending effects.

Anticorrelation between Local Photoluminescence and Photocurrent Suggests Variability in Contact to Active Layer in Perovskite Solar Cells.

We use high-resolution, spatially resolved, laser beam induced current, confocal photoluminescence, and photoconductive atomic force microscopy (pcAFM) measurements to correlate local solar cell performance with spatially heterogeneous local material properties in methylammonium lead triiodide (CHNHPbI) perovskite solar cells. We find that, for this material and device architecture, the photocurrent heterogeneity measured via pcAFM on devices missing a top selective contact with traditional Au-coated tips is significantly larger than the photocurrent heterogeneity observed in full devices with both electron- and hole-selective extraction layers, indicating that extraction barriers at the Au/perovskite interface are ameliorated by deposition of the organic charge extraction layer. Nevertheless, in completed, efficient device structures (PCE ≈ 16%) with state-of-the-art nickel oxide and [6,6]-phenyl-C61-butyric acid (PCBM) methyl ester contacts, we observe that the local photoluminescence (PL) is weakly anticorrelated with local photocurrent at both short-circuit and open-circuit conditions.

Synthesis of TiO2-poly(3-hexylthiophene) hybrid particles through surface-initiated Kumada catalyst-transfer polycondensation.

TiO2/conjugated polymers are promising materials in solar energy conversion where efficient photoinduced charge transfers are required. Here, a "grafting-from" approach for the synthesis of TiO2 nanoparticles supported with conjugated polymer brushes is presented. Poly(3-hexylthiophene) (P3HT), a benchmark material for organic electronics, was selectively grown from TiO2 nanoparticles by surface-initiated Kumada catalyst-transfer polycondensation.