Spatial distribution and mass transport of Perfluoroalkyl Substances (PFAS) in surface water: A statewide evaluation of PFAS occurrence and fate in Alabama.

Per- and polyfluoroalkyl substances (PFAS) have been previously detected near suspected sources in Alabama, but the overall extent of contamination across the state is unknown. This study evaluated the spatial distribution of 17 PFAS within the ten major river basins in Alabama and provided insights into their transport and fate through a mass flux analysis. Six PFAS were identified in 65 out of the 74 riverine samples, with mean ∑PFAS levels of 35.

Substrate properties as controlling parameters in attached algal cultivation.

There is growing interest in attached algae cultivation systems because they could provide a more cost- and energy-efficient alternative to planktonic (suspended algae) cultivation systems for many applications. However, attached growth systems have been far less studied than planktonic systems and have largely emphasized algae strains of most interest for biofuels. New algal biorefinery pathways have assessed the commercial potentials of algal biomass beyond biofuel production and placed more emphasis on value-added products from that biomass.

Analysis of very-high surface area 3D-printed media in a moving bed biofilm reactor for wastewater treatment.

Moving Bed Biofilm Reactors (MBBRs) can efficiently treat wastewater by incorporating suspended biocarriers that provide attachment surfaces for active microorganisms. The performance of MBBRs for wastewater treatment is, among other factors, contingent upon the characteristics of the surface area of the biocarriers. Thus, novel biocarrier topology designs can potentially increase MBBR performance in a significant manner.

Engineering of bio-mimetic substratum topographies for enhanced early colonization of filamentous algae.

This work reveals a set of surface topography parameters that are significant for algal attachment to natural rock substrata. Topography analysis of rock surfaces from a stream identifies three descriptive areal parameters (Smr, Sv, and Sa) that correlate with the presence of natural periphyton community. A method was developed and validated to reverse engineer and manufacture artificial substrata with topographic complexity defined by these parameters, using computational modeling and additive manufacturing.

Utilization of solid catfish manure waste as carbon and nutrient source for lactic acid production.

The aim of this work was to study the solid waste (manure) produced by catfish as a potential feedstock for the production of lactic acid (LA) via fermentation. The solid waste contains high levels of both carbohydrates and nutrients that are sufficient for LA bacteria. Simultaneous saccharification and co-fermentation (SSCF) was applied using enzyme and Lactobacillus pentosus, and different loadings of enzyme and solid waste were tested.

Dynamic modeling predicts continued bioaccumulation of polybrominated diphenyl ethers (PBDEs) in smallmouth bass (Micropterus dolomiu) post phase-out due to invasive prey and shifts in predation.

Unprecedented food chain links between benthic and pelagic organisms are often thought to disrupt traditional contaminant transport and uptake due to changes in predation and mobilization of otherwise sequestered pollutants. A bioaccumulation model for polybrominated diphenyl ethers (PBDEs) is developed to simulate increases in biotic congener loads based upon trophic transfer through diet and gill uptake for a Lake Erie food chain including two invasive species as a benthic-pelagic link. The model utilizes species-specific bioenergetic parameters in a four-level food chain including the green alga Scenedesmus quadricauda, zebra mussels (Dreissena polymorpha), round goby (Appollonia melanostoma), and the smallmouth bass (Micropterus dolomiu).