The influence of salinity on the chronic toxicity of shale gas flowback wastewater to freshwater organisms.

The potential environmental risk associated with flowback waters generated during hydraulic fracturing of target shale gas formations needs to be assessed to enable management decisions and actions that prevent adverse impacts on aquatic ecosystems. Using direct toxicity assessment (DTA), we determined that the shale gas flowback wastewater (FWW) from two exploration wells (Tanumbirini-1 and Kyalla 117 N2) in the Beetaloo Sub-basin, Northern Territory, Australia were chronically toxic to eight freshwater biota. Salinity in the respective FWWs contributed 16% and 55% of the chronic toxicity at the 50% effect level.

Probabilistic risk assessment of mine-derived copper in the Ok Tedi/Fly River, Papua New Guinea.

The Ok Tedi mine discharges waste rock and tailings into the Ok Tedi River in Papua New Guinea. This has resulted in elevated copper concentrations throughout the Ok Tedi/Fly River system, which can potentially impact aquatic biota. Ten years of measured copper and toxicity monitoring data were used to assess the risk of chronic effects from the mine-derived copper.

Remediation criteria for gasworks-impacted sediments: Assessing the effects of legacy hydrocarbons and more recent metal contamination.

Historical contamination of sediments from industries that commenced before environmental regulations were commonplace is prevalent in many large cities. This contamination is frequently overlain and mixed with more recent urban contamination. The remediation of contaminated sites is often a very expensive exercise and the final remediation criteria often reflect a trade-off between protecting human and ecological health and the finances of those deemed responsible for the site clean-up.

Improved prediction of sediment toxicity using a combination of sediment and overlying water contaminant exposures.

The choice of sediment quality assessment methodologies can strongly influence assessment outcomes and management decisions for contaminated sites. While in situ (field) methods may potentially provide greater realism, high costs and/or complex logistics often prevent their use and assessment must rely on laboratory-based methods. In this study, we utilised static-renewal and flow-through ecotoxicology tests in parallel on sediments with a wide range of properties and varying types and concentrations of contaminants.

Bioavailability and Chronic Toxicity of Metal Sulfide Minerals to Benthic Marine Invertebrates: Implications for Deep Sea Exploration, Mining and Tailings Disposal.

The exploration and proposed mining of sulfide massive deposits in deep-sea environments and increased use deep-sea tailings placement (DSTP) in coastal zones has highlighted the need to better understand the fate and effects of mine-derived materials in marine environments. Metal sulfide ores contain high concentrations of metal(loid)s, of which a large portion exist in highly mineralized or sulfidised forms and are predicted to exhibit low bioavailability. In this study, sediments were spiked with a range of natural sulfide minerals (including chalcopyrite, chalcocite, galena, sphalerite) to assess the bioavailability and toxicity to benthic invertebrates (bivalve survival and amphipod survival and reproduction).

Assessing the Effects of Bioturbation on Metal Bioavailability in Contaminated Sediments by Diffusive Gradients in Thin Films (DGT).

The burrowing and feeding activities of benthic organisms can alter metal speciation in sediments and affect an organisms' exposure to metals. Recently, the performance of the in situ technique of diffusive gradients in thin films (DGT) for predicting metal bioavailability has been investigated in response to the increasing demand of considering contaminant bioavailability in sediment quality assessments. In this study, we test the ability of the DGT technique for predicting the metal bioavailability in clean and contaminated sediments that are being subjected to varying degrees of sediments disturbance: low bioturbation (bivalve Tellina deltoidalis alone) and high bioturbation (bivalve and actively burrowing amphipod, Victoriopisa australiensis).

The impact of sediment bioturbation by secondary organisms on metal bioavailability, bioaccumulation and toxicity to target organisms in benthic bioassays: Implications for sediment quality assessment.

Bioturbation alters the properties of sediments and modifies contaminant bioavailability to benthic organisms. These naturally occurring disturbances are seldom considered during the assessment of sediment quality. We investigated how the presence (High bioturbation) and absence (Low bioturbation) of a strongly bioturbating amphipod within three different sediments influenced metal bioavailability, survival and bioaccumulation of metals to the bivalve Tellina deltoidalis.

The mismatch between bioaccumulation in field and laboratory environments: Interpreting the differences for metals in benthic bivalves.

Laboratory-based bioaccumulation and toxicity bioassays are frequently used to predict the ecological risk of contaminated sediments in the field. This study investigates the bioassay conditions most relevant to achieving environmentally relevant field exposures. An identical series of metal-contaminated marine sediments were deployed in the field and laboratory over 31 days.

Challenges for using quantitative PCR test batteries as a TIE-type approach to identify metal exposure in benthic invertebrates.

The epibenthic amphipod Melita plumulosa shows unique gene expression profiles when exposed to different contaminants. We hypothesized that specific changes in transcript abundance could be used in a battery of quantitative polymerase chain reaction (qPCR) assays as a toxicity identification evaluation (TIE)-like approach to identify the most relevant stressor in field-contaminated sediments. To test this hypothesis, seven candidate transcriptomic markers were selected, and their specificity following metal exposure was confirmed.

Dissolved and particulate copper exposure induces differing gene expression profiles and mechanisms of toxicity in the deposit feeding amphipod Melita plumulosa.

Uptake of metals via ingestion is an important route of exposure for many invertebrates, and it has been suggested that the toxic response to metals accumulated via food differs from that of metals accumulated via the dissolved phase. To test this hypothesis, the deposit-feeding epibenthic amphipod Melita plumulosa was exposed to nontoxic or reproductively toxic concentrations of copper via the overlying water, via ingestion of sediment, or via a combination of the two. Rates of copper uptake from the two exposure routes were predicted using a biokinetic model.

454 pyrosequencing-based analysis of gene expression profiles in the amphipod Melita plumulosa: transcriptome assembly and toxicant induced changes.

Next generation sequencing using Roche's 454 pyrosequencing platform can be used to generate genomic information for non-model organisms, although there are bioinformatic challenges associated with these studies. These challenges are compounded by a lack of a standardized protocol to either assemble data or to evaluate the quality of a de novo transcriptome. This study presents an assembly of the control and toxicant responsive transcriptome of Melita plumulosa, an Australian amphipod commonly used in ecotoxicological studies.

Assessing mechanisms of toxicant response in the amphipod Melita plumulosa through transcriptomic profiling.

This study describes the function of transcripts with altered abundance in the epibenthic amphipod, Melita plumulosa, following whole-sediment exposure to a series of common environmental contaminants. M. plumulosa were exposed for 48 h to sediments spiked and equilibrated with the following contaminants at concentrations predicted to cause sublethal effects to reproduction: porewater ammonia 30 mg L(-1); bifenthrin at 100 μg kg(-1); fipronil at 50 μg kg(-1); 0.

Incorporating bioavailability into management limits for copper in sediments contaminated by antifouling paint used in aquaculture.

Although now well embedded within many risk-based sediment quality guideline (SQG) frameworks, contaminant bioavailability is still often overlooked in assessment and management of contaminated sediments. To optimise management limits for metal contaminated sediments, we assess the appropriateness of a range methods for modifying SQGs based on bioavailability considerations. The impairment of reproduction of the amphipod, Melita plumulosa, and harpacticoid copepod, Nitocra spinipes, was assessed for sediments contaminated with copper from antifouling paint, located below aquaculture cages.

Sub-lethal effects of copper to benthic invertebrates explained by sediment properties and dietary exposure.

The next generation of sediment quality guidelines (SQGs) requires better established causal links between the chronic exposure and effects of metals from both dissolved and dietary sources. The potential for dietary exposure from sediment metals to cause toxic effects to benthic invertebrates is strongly influenced by the metal-binding properties of the sediments. For relatively oxidized sediments, sublethal effects of copper to the epibenthic deposit-feeding amphipod, Melita plumulosa, and the benthic harpacticoid copepod, Nitocra spinipes, were investigated.

Guidelines for copper in sediments with varying properties.

A major weakness of sediment quality guidelines (SQGs) is their poor ability to predict how toxicity thresholds change for different sediment types. Using species sensitivity distributions (SSDs) of copper effects data, new guidelines were derived for copper in non-sulfidic marine sediments in which organic carbon (OC) and particle size strongly influence copper bioavailability. The derived SQGs varied in a predictable manner with changes in sediment particle size and organic carbon (OC), and were shown to offer a significant improvement on the existing 'single value' SQG.

Performance and sensitivity of rapid sublethal sediment toxicity tests with the amphipod Melita plumulosa and copepod Nitocra spinipes.

Sublethal whole-sediment toxicity tests are an important tool for assessing the potential effects of contaminated sediments. However, the longer duration required for evaluating potential chronic effects may increase endpoint variability and test costs compared to survival endpoints. In the present study we compare the performance and sensitivity to contaminants of 10-d sublethal sediment toxicity tests with the amphipod Melita plumulosa and harpacticoid copepod Nitocra spinipes.

An assessment of three harpacticoid copepod species for use in ecotoxicological testing.

The relatively short life cycles of harpacticoid copepods makes them appropriate animals for use in tests that rapidly assess the acute, sublethal, or chronic effects of sediment contaminants. In this study, four harpacticoid copepod species (Nitocra spinipes, Tisbe tenuimana, Robertgurneya hopkinsi, and Halectinosoma sp.) were isolated from clean marine sediments, and procedures for laboratory culturing were developed.

Development and application of a rapid amphipod reproduction test for sediment-quality assessment.

Melita plumulosa is an epibenthic, detritivorous amphipod native to eastern Australia that has been adopted as a test organism for toxicity evaluations of contaminated estuarine sediments. In the present study, a 13-d amphipod reproduction test was developed that encompasses gametogenesis, fertilization, and embryo development before hatching. The primary endpoints for the test are fecundity (measured as the number of embryos per individual surviving female) and a fecundity index (fecundity multiplied by the stage of embryo development).