Colour stability and opacity of resin cements and flowable composites for ceramic veneer luting after accelerated ageing.

Objectives: Colour changes of the luting material can become clinically visible affecting the aesthetic appearance of thin ceramic laminates. The aim of this in vitro study was to evaluate the colour stability and opacity of light- and dual-cured resin cements and flowable composites after accelerated ageing.

Methods: The luting agents were bonded (0.

Reaction kinetics of sodium ascorbate and dental bleaching gel.

Objective: The aim of this study was to establish the reaction kinetics of 35% hydrogen peroxide and sodium ascorbate and to determine the mass of antioxidant required to neutralize the bleaching gel.

Methods: The method used to quantify sodium ascorbate was based on the United States Pharmacopeia (1995)(26). Oxidation-reduction titration was used to confirm the concentration of hydrogen peroxide and sodium ascorbate and to determine the reaction kinetics between them.

Impact of refrigeration on the surface hardness of hybrid and microfilled composite resins.

This in vitro study evaluated the Knoop hardness of the composite resins Charisma (C) and Durafill VS (D) polymerized in 3 different conditions: at room temperature (A) (23 +/- 1 degrees C); refrigerated at 4 +/- 1 degrees C and immediately photo-activated after removal from the refrigerator (0); and, refrigerated at 4 +/- 1 degrees C and photo-activated after a bench time of 15 min at room temperature (15). One hundred and twenty specimens (4 mm diameter and 2 mm depth) were made using a stainless steel mold and following manufacturer's instructions. All specimens were tested immediately after polymerization (I) and after 7 days of water storage in the dark at room temperature (7d).

Influence of curing tip distance on resin composite Knoop hardness number, using three different light curing units.

This in vitro study evaluated the influence of curing tip distance on the Knoop Hardness Number (KHN) of a resin composite when using three different light curing units: (1) a halogen light (XL 1500 curing unit-3M), (2) a "softstart-polymerization" (Elipar Trilight curing in an exponential mode-ESPE) and (3) a PAC (Apolo 95E curing unit-DMD). The resin composite, Filtek Z250 (3M), was cured by these curing units at three light-tip distances from the resin composite: 0 mm, 6 mm and 12 mm. The resin composite specimens were flattened to their middle portion and submitted to 18 KHN measurements perspecimen.