Whole-body vibration associated with underground coal mining equipment in Australia.

Environmental and logistical difficulties associated with obtaining whole-body vibration measurements from mobile equipment during operation in underground coal mines have hampered attempts to assess the potential vibration exposures associated with the use of such equipment. An alternative measurement technique was used to gather data from mobile equipment during normal operation at three low-methane coal mines and to estimate the possible magnitude of benefit of three control measures. 188 long duration measurements were obtained from shuttle cars (N = 142, median measurement duration = 3.

Whole-Body Vibration Associated with Dozer Operation at an Australian Surface Coal Mine.

Bulldozers are used extensively on surface mine sites and have been previously identified as being associated with high amplitude whole-body vibration exposures. Previous investigations of this equipment have involved either a very small number of measurements, or measurements of very short duration (or both); or the data obtained were incompletely reported. This research reports 69 measurements (median duration 440 min) obtained from 15 different dozers during operation at a surface coal mine.

Long duration measurements of whole-body vibration exposures associated with surface coal mining equipment compared to previous short-duration measurements.

Previous measurements of whole-body vibration associated with earth-moving equipment at surface coal mines have highlighted the significance of the hazard. Considerable variability in measurement amplitudes, even within the same equipment type operated at the same site, has been noted. However, the measurements have previously been undertaken for relatively short durations.