A coded aperture microscope for X-ray fluorescence full-field imaging.

The design and construction of an instrument for full-field imaging of the X-ray fluorescence emitted by a fully illuminated sample are presented. The aim is to produce an X-ray microscope with a few micrometers spatial resolution, which does not need to scan the sample. Since the fluorescence from a spatially inhomogeneous sample may contain many fluorescence lines, the optic which will provide the magnification of the emissions must be achromatic, i.

Fast X-ray microfluorescence imaging with submicrometer-resolution integrating a Maia detector at beamline P06 at PETRA III.

The high brilliance of third-generation synchrotron sources increases the demand for faster detectors to utilize the available flux. The Maia detector is an advanced imaging scheme for energy-dispersive detection realising dwell times per image-pixel as low as 50 µs and count rates higher than 10 × 10 s. In this article the integration of such a Maia detector in the Microprobe setup of beamline P06 at the storage ring PETRA III at the Deutsches Elektronen-Synchrotron (DESY) in Hamburg, Germany, is described.

First experimental feasibility study of VIPIC: a custom-made detector for X-ray speckle measurements.

The Vertically Integrated Photon Imaging Chip (VIPIC) was custom-designed for X-ray photon correlation spectroscopy, an application in which occupancy per pixel is low but high time resolution is needed. VIPIC operates in a sparsified streaming mode in which each detected photon is immediately read out as a time- and position-stamped event. This event stream can be fed directly to an autocorrelation engine or accumulated to form a conventional image.

Multicavity x-ray Fabry-Perot resonance with ultrahigh resolution and contrast.

Realization of x-ray Fabry-Perot (FP) resonance in back-Bragg-reflection crystal cavities has been proposed and explored for many years, but to date no satisfactory performance has been achieved. Here we show that single-cavity crystal resonators intrinsically have limited finesse and efficiency. To break this limit, we demonstrate that monolithic multicavity resonators with equal-width cavities and specific plate thickness ratios can generate ultrahigh-resolution FP resonance with high efficiency, steep peak tails, and ultrahigh contrast simultaneously.

A bi-prism interferometer for hard X-ray photons.

Micro-fabricated bi-prisms have been used to create an interference pattern from an incident hard X-ray beam, and the intensity of the pattern probed with fluorescence from a 30 nm-thick metal film. Maximum fringe visibility exceeded 0.9 owing to the nano-sized probe and the choice of single-crystal prism material.

Simultaneous XAFS measurements of multiple samples.

A four-channel ionization chamber has been designed, constructed and tested. This ionization chamber allows X-ray absorption spectra to be collected in transmission from up to four samples simultaneously. This results in spectra that are free of systematic uncertainty in relative energy alignment introduced by scan-to-scan stability of the monochromator or of numerical uncertainty associated with a post-processing alignment algorithm, allowing, in a single shot, an absolute measure of edge shift between four samples of different valence.

X-ray diffuse scattering measurements of nucleation dynamics at femtosecond resolution.

Femtosecond time-resolved small and wide angle x-ray diffuse scattering techniques are applied to investigate the ultrafast nucleation processes that occur during the ablation process in semiconducting materials. Following intense optical excitation, a transient liquid state of high compressibility characterized by large-amplitude density fluctuations is observed and the buildup of these fluctuations is measured in real time. Small-angle scattering measurements reveal snapshots of the spontaneous nucleation of nanoscale voids within a metastable liquid and support theoretical predictions of the ablation process.

Carrier-density-dependent lattice stability in InSb.

The ultrafast decay of the x-ray diffraction intensity following laser excitation of an InSb crystal has been utilized to observe carrier dependent changes in the potential energy surface. For the first time, an abrupt carrier dependent onset for potential energy surface softening and the appearance of accelerated atomic disordering for a very high average carrier density have been observed. Inertial dynamics dominate the early stages of crystal disordering for a wide range of carrier densities between the onset of crystal softening and the appearance of accelerated atomic disordering.

Ultrafast bond softening in bismuth: mapping a solid's interatomic potential with X-rays.

Intense femtosecond laser excitation can produce transient states of matter that would otherwise be inaccessible to laboratory investigation. At high excitation densities, the interatomic forces that bind solids and determine many of their properties can be substantially altered. Here, we present the detailed mapping of the carrier density-dependent interatomic potential of bismuth approaching a solid-solid phase transition.

Observation of the second harmonic in Thomson scattering from relativistic electrons.

A free relativistic electron in an electromagnetic field is a pure case of a light-matter interaction. In the laboratory environment, this interaction can be realized by colliding laser pulses with electron beams produced from particle accelerators. The process of single photon absorption and reemission by the electron, so-called linear Thomson scattering, results in radiation that is Doppler shifted into the x-ray and gamma-ray regions.

Observation of structural anisotropy and the onset of liquidlike motion during the nonthermal melting of InSb.

The melting dynamics of laser excited InSb have been studied with femtosecond x-ray diffraction. These measurements observe the delayed onset of diffusive atomic motion, signaling the appearance of liquidlike dynamics. They also demonstrate that the root-mean-squared displacement in the [111] direction increases faster than in the [110] direction after the first 500 fs.

Clocking femtosecond X rays.

Linear-accelerator-based sources will revolutionize ultrafast x-ray science due to their unprecedented brightness and short pulse duration. However, time-resolved studies at the resolution of the x-ray pulse duration are hampered by the inability to precisely synchronize an external laser to the accelerator. At the Sub-Picosecond Pulse Source at the Stanford Linear-Accelerator Center we solved this problem by measuring the arrival time of each high energy electron bunch with electro-optic sampling.

Atomic-scale visualization of inertial dynamics.

The motion of atoms on interatomic potential energy surfaces is fundamental to the dynamics of liquids and solids. An accelerator-based source of femtosecond x-ray pulses allowed us to follow directly atomic displacements on an optically modified energy landscape, leading eventually to the transition from crystalline solid to disordered liquid. We show that, to first order in time, the dynamics are inertial, and we place constraints on the shape and curvature of the transition-state potential energy surface.

X-ray topography of tetragonal lysozyme grown by the temperature-controlled technique.

Growth-induced defects in lysozyme crystals were observed by white-beam and monochromatic X-ray topography at the National Synchrotron Light Source (NSLS) at the Brookhaven National Laboratory (BNL). The topographic methods were non-destructive to the extent that traditional diffraction data collection could be performed to high resolution after topography. It was found that changes in growth parameters, defect concentration as detected by X-ray topography, and the diffraction quality obtainable from the crystals were all strongly correlated.

Transmission-type X-ray linear polarizer with perfect crystals.

Even though conventional X-ray polarizers with multiple-reflection channel-cut structures perform well, they suffer from the disadvantage that the polarized beam is non-stationary as the energy is scanned. In this paper the possibility of using a thin Bragg reflector as a polarizing filter is investigated, so that the transmitted beam (rather than the Bragg-reflected beam) is used. Consequently, the position and direction of the transmitted beam are unchanged as the energy is changed, or even when the polarization direction to be filtered out is changed.

Microcontroller-based servo for two-crystal X-ray monochromators.

Microcontrollers have become increasingly easy to incorporate into instruments as the architectures and support tools have developed. The PIC series is particularly easy to use, and this paper describes a controller used to stabilize the output of a two-crystal X-ray monochromator at a given offset from its peak intensity position, as such monochromators are generally used.

A lamellar model for the X-ray rocking curves of sagittally bent Laue crystals.

The use of sagittally bent asymmetric Laue crystals in horizontally focusing monochromators for high-energy synchrotron X-rays necessitates simulation of the X-ray reflectivity by such crystals. Based on the theory of the lattice distortion in the diffraction plane of sagittally bent Laue crystals, a lamellar model was developed to predict their rocking curves. The model was experimentally verified by rocking-curve measurements from various reflections on silicon crystals of four representative orientations, sagittally bent to various radii, using X-rays of 67 keV energy.

New pressure flow cell to monitor BaSO4 precipitation using synchrotron in situ angle-dispersive X-ray diffraction.

A flow cell has been commissioned to monitor in situ precipitation reactions under non-ambient conditions. The majority of high-pressure systems use anvils and presses to obtain high pressures around a small reaction area; however, this prototype is unique in that solutions may be examined as they flow through the cell under pressure. The cell is made of single-crystal silicon, which is capable of withstanding the high pressures created by liquid flow within the cell.

Rocking-curve width of sagittally bent Laue crystals.

The use of bent asymmetric Laue crystals to sagittally focus high-energy synchrotron X-rays calls for an understanding of the mechanisms affecting X-ray diffraction by such crystals. The rocking-curve width, a measurable quantity directly related to the distortion of the lattice planes, is the necessary first step towards such an understanding. A model is formulated for assessing the rocking-curve widths of sagittally bent Laue crystals, considering the elastic anisotropy.

Synchrotron X-ray reciprocal-space mapping, topography and diffraction resolution studies of macromolecular crystal quality.

A comprehensive study of microgravity and ground-grown chicken egg-white lysozyme crystals is presented using synchrotron X-ray reciprocal-space mapping, topography techniques and diffraction resolution. Microgravity crystals displayed reduced intrinsic mosaicities on average, but no differences in terms of strain over their ground-grown counterparts. Topographic analysis revealed that in the microgravity case the majority of the crystal was contributing to the peak of the reflection at the appropriate Bragg angle.

Tunable X-ray polarization reflector with perfect crystals.

The possibility of a transmission-type X-ray linear polarizer is investigated using a thin Bragg reflector as a polarizing filter. In this device, the transmitted beam (rather than the Bragg-reflected beam) is the useful output of the device. Consequently, the position and the direction of the transmitted beam are unchanged as the energy is changed, or even when the polarization direction to be filtered out is changed.

Silicon Detector System for High Rate EXAFS Applications.

A multichannel silicon pad detector for EXAFS (Extended X-ray Absorption Fine Structure) applications has been designed and built. The X-ray spectroscopic measurements demonstrate that an adequate energy resolution of 230 eV FWHM (corresponding to 27 rms electrons in silicon) can be achieved reliably at -35 °C. A resolution of 190 eV FWHM (corresponding to 22 rms electrons) has been obtained from individual pads at -35 °C.