Publications by authors named "DE Prober"

We report the first calorimetric detection of individual excimers within a bath of superfluid . The detector used in this work is a single superconducting titanium transition edge sensor (TES) with an energy resolution of , immersed directly in the helium bath. excimers are produced in the surrounding bath using an external gamma-ray source.

View Article and Find Full Text PDF

Luttinger liquid theory predicts that collective electron excitations due to strong electron-electron interactions in a one-dimensional (1D) system will result in a modification of the collective charge-propagation velocity. By utilizing a circuit model for an individual metallic single-walled carbon nanotube as a nanotransmission line, it has been shown that the frequency-dependent terahertz impedance of a carbon nanotube can probe this expected 1D Luttinger liquid behavior. We excite terahertz standing-wave resonances on individual antenna-coupled metallic single-walled carbon nanotubes.

View Article and Find Full Text PDF

We describe the properties of ultrasensitive graphene photon detectors for use in the far-infrared/terahertz spectral region and present theoretical predictions for their power detection sensitivity. These predictions are based on two graphene contacting schemes with superconducting contacts: contacts with a thin insulating barrier, and direct superconducting contacts. To quantitatively assess these predictions, we perform thermal measurements of graphene at low temperatures and analyse them to extract information on electron-phonon cooling in graphene.

View Article and Find Full Text PDF

The extremely small size of plasmonic antennas has made it difficult to integrate them with nanoscale detectors that require electrical leads, as the leads tend to degrade the resonant properties of the antenna. We present a design for integrating a plasmonic antenna with a nanoscale superconducting transition-edge sensor (TES) with electrical leads. Numerical simulations demonstrate high-efficiency coupling of 1550 nm incident photons into the sub-wavelength TES.

View Article and Find Full Text PDF

We characterize the energy loss of the nonequilibrium electron system in individual metallic single-walled carbon nanotubes at low temperature. Using Johnson noise thermometry, we demonstrate that, for a nanotube with Ohmic contacts, the dc resistance at finite bias current directly reflects the average electron temperature. This enables a straightforward determination of the thermal conductance associated with cooling of the nanotube electron system.

View Article and Find Full Text PDF

We characterize inductors fabricated from ultra-thin, approximately 100 nm wide strips of niobium (Nb) and niobium nitride (NbN). These nanowires have a large kinetic inductance in the superconducting state. The kinetic inductance scales linearly with the nanowire length, with a typical value of 1 nH µm(-1) for NbN and 44 pH µm(-1) for Nb at a temperature of 2.

View Article and Find Full Text PDF

Recent progress in solid-state quantum information processing has stimulated the search for amplifiers and frequency converters with quantum-limited performance in the microwave range. Depending on the gain applied to the quadratures of a single spatial and temporal mode of the electromagnetic field, linear amplifiers can be classified into two categories (phase sensitive and phase preserving) with fundamentally different noise properties. Phase-sensitive amplifiers use squeezing to reduce the quantum noise, but are useful only in cases in which a reference phase is attached to the signal, such as in homodyne detection.

View Article and Find Full Text PDF

We report the performance of a niobium hot-electron bolometer designed for laboratory terahertz spectroscopy. The antenna-coupled detector can operate above 4.2 K and has fast (subnanosecond) response.

View Article and Find Full Text PDF

The current noise density S2 of a conductor in equilibrium, the Johnson noise, is determined by its temperature T: S2 = 4k(B)TG, with G the conductance. The sample's noise temperature T(N) = S2/(4k(B)G) generalizes T for a system out of equilibrium. We introduce the "noise thermal impedance" of a sample as the ratio deltaT(N)omega/deltaP(J)omega of the amplitude deltaT(N)omega of the oscillation of T(N) when heated by an oscillating power deltaP(J)omega at frequency omega.

View Article and Find Full Text PDF

We present the first measurements of the third moment of the voltage fluctuations in a conductor. This technique can provide new and complementary information on the electronic transport in conducting systems. The measurement was performed on nonsuperconducting tunnel junctions as a function of voltage bias, for various temperatures and bandwidths up to 1 GHz.

View Article and Find Full Text PDF

We investigate nonequilibrium noise in a diffusive Andreev interferometer, in which currents emerging from two normal metal/superconductor (N-S) interfaces can interfere. We observe a modulation of the shot noise when the phase difference between the two N-S interfaces is varied by a magnetic flux. This is the signature of phase-sensitive fluctuations in the normal metal.

View Article and Find Full Text PDF

We report on time-resolved measurements of thermodynamic fluctuations in the number of particles in a nondegenerate Fermi gas. The gas is comprised of thermal quasiparticles, confined in a superconducting Al box by large-gap Ta leads. The average number of quasiparticles is about 10(5).

View Article and Find Full Text PDF

We report measurements of nonequilibrium noise in a diffusive normal metal-superconductor (N-S) junction in the presence of both dc bias and high-frequency ac excitation. We find that the shot noise of a diffusive N-S junction is doubled compared to a normal diffusive conductor. Under ac excitation of frequency nu the shot noise develops features at bias voltages |V| = hnu/(2e), which bear all the hallmarks of a photon-assisted process.

View Article and Find Full Text PDF

A new type of electrometer is described that uses a single-electron transistor (SET) and that allows large operating speeds and extremely high charge sensitivity. The SET readout was accomplished by measuring the damping of a 1.7-gigahertz resonant circuit in which the device is embedded, and in some ways is the electrostatic "dual" of the well-known radio-frequency superconducting quantum interference device.

View Article and Find Full Text PDF