Bimetallic CuNi Nanoparticle Formation: Solution Combustion Synthesis and Molecular Dynamic Approaches.

Nanomaterials are vital in catalysis, sensing, energy storage, and biomedicine and now incorporate multiprincipal element materials to meet evolving technological demands. However, achieving a uniform distribution of multiple elements in these nanomaterials poses significant challenges. In this study, various Cu-Ni compositions were used as a model system to investigate the formation of bimetallic nanoparticles by employing computer simulation molecular dynamics methods and comparing the results with observations from solution-combustion-synthesized materials of the same compositions.

Torsional behavior of Ni-rich NiTi alloys obtained by powder metallurgy and hot deformation.

The effects of severe plastic deformation on NiTi alloys' structure and properties have been extensively studied over the past decades. However, there is a notable lack of systematic data regarding the impact of industrial hot deformation techniques on these alloys. This gap arises from challenges in manufacturing processes related to the unevenness of ingots produced by casting technologies.

Enhanced microstructure and mechanical properties of ZrN-reinforced AlSi10Mg aluminum matrix composite.

Aluminum matrix composites (AMCs), incorporating Zirconium Nitride (ZrN) as reinforcing additives, demonstrate immense promise for applications in aerospace, automotive, and power generation due to their unique combination of low density, superior mechanical properties, and excellent thermal/electrical conductivity. This study explores the influence of ZrN reinforcement on the microstructure and mechanical properties of AlSi10Mg metal-matrix composites. Utilizing high-energy ball milling (HEBM) and spark-plasma sintering (SPS), ZrN/AlSi10Mg composites were synthesized, achieving nearly full density with uniform ZrN distribution, while phase and chemical transformations were not observed in the bulk composites.

High-strength gypsum binder with improved water-resistance coefficient derived from industrial wastes.

The article presents the possibility of increasing the water resistance of gypsum binders (GBs) obtained based on synthetic gypsum by introducing additives derived from industrial wastes. Regularities were obtained for the influence of the type and amount of additives on the water/gypsum ratio (W/G), strength indicators and water resistance of high-strength GB. The introduction of a single-component additive to improve water resistance does not have a significant effect.

Selective laser melting of low-alloyed titanium based alloy with a large solidification range.

In this work, thermodynamic calculations for α + β Type Ti-Fe-Cu-Sn alloy were carried out by the Thermo-Calc software. Powders from this alloy were obtained by plasma sputtering and used for subsequent 3D printing of experimental samples. The effect of various selective laser melting (SLM) parameters on porosity and hot cracking susceptibility as well as the electrochemical characteristics of the alloy have been studied.