Robotic-assisted total hip arthroplasty utilizing a fluoroscopy-guided system produced similar cup accuracy and precision relative to a computerized tomography-based robotic platform.

Robotic assistance for total hip arthroplasty (THA) has been demonstrated to improve accuracy of acetabular cup placement relative to manual, unassisted technique. The purpose of this investigation was to compare the accuracy and precision between a fluoroscopy-based robotic total hip arthroplasty platform (FL-RTHA) and a computerized tomography-based (CT-RTHA) platform. The study included 98 consecutive FL-RTHA and 159 CT-RTHA procedures performed via direct anterior approach (DAA).

Proximal femoral defect classifications in revision total hip arthroplasty from X-rays imaging to advanced 3D imaging: a narrative review.

Background And Objective: Femoral bone defect in hip arthroplasty revision surgery represents a complex problem, and the treatment is a challenge for orthopedic surgeons called to assess the residual bone stock in an altered anatomy and obtain stability for the new implant. Classification systems available are mostly based on X-rays two-dimensional images and lack of accuracy and reproducibility and comprehensive therapeutic algorithms. However, there is no record of any classification based on computed tomography (CT)-scan images or three-dimensional (3D) modeling modern techniques.

Periprosthetic joint infections in patients with rheumatoid arthritis are associated with higher complication and mortality rates.

Introduction: Periprosthetic joint infection (PJI) remains the most devasting complication after total joint arthroplasty (TJA). There has been a significant focus on this topic in recently-published medical literature. However, relatively little has been published about PJI in patients with rheumatoid arthritis (RA), which are often physiologically frail and immunocompromised.

A comparison of joint line height after revision total knee replacement using a rotating hinge versus a condylar revision knee system.

Purpose: This retrospective study aimed to assess the effects of two differing revision total knee implants designs (condylar and rotating hinge) on joint line height.

Method: The use of distal augmentation and pre and post revision radiographic joint line heights were compared in 19 condylar type knee replacements (Zimmer NexGen Legacy Constrained Condylar Knee - LCCK) and 40 LINK-Endo-rotating hinge knee replacements. Joint line and patellar heights were determined for each implant using four validated methods.