Effect of hydroxyl group position and system parameters on the features of hydroxystearic Acid monolayers.

The characteristic features of hydroxystearic acid monolayers OH-substituted in the mid position of the alkyl chain deviate considerably from those of the usual nonsubstituted stearic acid. The phase behavior, domain morphology, and two-dimensional lattice structure of 9-, 11-, and 12-hydroxystearic acids are studied, using pi-A isotherms, Brewster angle microscopy (BAM), and grazing incidence X-ray diffraction (GIXD), to obtain detailed information on the effect of the exact position of the OH-substitution. The pi-A isotherms of all three hydroxyoctadecanoic acids have an extended flat plateau region, the extension of which only slightly decreases with the increase of temperature.

Model membrane/substrate interactions: ethanol and procaine interactions.

The ability of ethanol to lower the surface tension of water plays a major role in its ability to affect membrane lipids. Typical lipids will show little expansion on exposure to ethanol substrates and may even show condensations. At the same time, the overall stability of the lipid phase is significantly reduced.

Surface Reactivity of Iron Oxide Pigmentary Powders toward Atmospheric Components: XPS, FESEM, and Gravimetry of CO and CO2 Adsorption.

The adsorption of carbon monoxide and carbon dioxide (CO and CO2) on a number of specially prepared alpha-Fe2O3 samples was measured gravimetrically at 25°C. The samples were prepared from a steel-pickling waste (97 wt% FeSO4·7H2O) by roasting the original material at 700°C for 5 h in air, oxygen, and nitrogen. Estimated surface coverages by the adsorbed CO and CO2 were made on the basis of nitrogen-adsorption-based surface areas, while the nature of the sample surfaces was investigated by both X-ray photoelectron spectroscopy (XPS) and field emission SEM (FESEM) techniques.

Surface Reactivity of Iron Oxide Pigmentary Powders toward Atmospheric Components: XPS and Gravimetry of Oxygen and Water Vapor Adsorption.

The adsorption of oxygen and water vapor on a number of specially prepared alpha-Fe2O3 samples was measured gravimetrically at 25°C. The samples themselves were prepared from a steel-pickling chemical waste (97 wt% FeSO4·7H2O) by roasting the original material at 700°C for 5 h in air, oxygen, and nitrogen. Estimated surface coverages by the adsorbed oxygen and water vapor were made on the basis of nitrogen-adsorption-based surface areas, while the nature of the sample surfaces was investigated by both X-ray photoelectron spectroscopy (XPS) and field emission SEM (FESEM) techniques.