Cartilage-on-cartilage versus metal-on-cartilage impact characteristics and responses.

A common in vitro model for studying acute mechanical damage in cartilage is to impact an isolated osteochondral or cartilage specimen with a metallic impactor. The mechanics of a cartilage-on-cartilage (COC) impact, as encountered in vivo, are likely different than those of a metal-on-cartilage (MOC) impact. The hypothesis of this study was that impacted in vitro COC and MOC specimens would differ in their impact behavior, mechanical properties, chondrocyte viability, cell metabolism, and histologic structural damage.

Apparent transverse compressive material properties of the digital flexor tendons and the median nerve in the carpal tunnel.

Carpal tunnel syndrome is a frequently encountered peripheral nerve disorder caused by mechanical insult to the median nerve, which may in part be a result of impingement by the adjacent digital flexor tendons. Realistic finite element (FE) analysis to determine contact stresses between the flexor tendons and median nerve depends upon the use of physiologically accurate material properties. To assess the transverse compressive properties of the digital flexor tendons and median nerve, these tissues from ten cadaveric forearm specimens were compressed transversely while under axial load.

Preferential superior surface motion in wear simulations of the Charité total disc replacement.

Laboratory wear simulations of the dual-bearing surface Charité total disc replacement (TDR) are complicated by the non-specificity of the device's center of rotation (CoR). Previous studies have suggested that articulation of the Charité preferentially occurs at the superior-bearing surface, although it is not clear how sensitive this phenomenon is to lubrication conditions or CoR location. In this study, a computational wear model is used to study the articulation kinematics and wear of the Charité TDR.

Cross-shear implementation in sliding-distance-coupled finite element analysis of wear in metal-on-polyethylene total joint arthroplasty: intervertebral total disc replacement as an illustrative application.

Computational simulations of wear of orthopaedic total joint replacement implants have proven to valuably complement laboratory physical simulators, for pre-clinical estimation of abrasive/adhesive wear propensity. This class of numerical formulations has primarily involved implementation of the Archard/Lancaster relationship, with local wear computed as the product of (finite element) contact stress, sliding speed, and a bearing-couple-dependent wear factor. The present study introduces an augmentation, whereby the influence of interface cross-shearing motion transverse to the prevailing molecular orientation of the polyethylene articular surface is taken into account in assigning the instantaneous local wear factor.

Compliance-dependent load allocation between sensing versus non-sensing portions of a sheet-array contact stress sensor.

Piezoresistive array pressure sensors are widely used in orthopaedic research to determine contact stress distributions across articular joint surfaces. Experience with such sensors has shown there can be inaccuracies in how the sensor perceives applied load, depending on the material stiffnesses between which it is compressed experimentally, versus in calibration. A study was undertaken to quantify the relationship between load perception of one such sensor design (Tekscan) and the stiffness of the materials between which it is compressed.

A finite element exploration of cartilage stress near an articular incongruity during unstable motion.

Both instability and residual articular incongruity are implicated in the development of post-traumatic osteoarthritis (OA) following intra-articular fracture, but currently no information exists regarding cartilage stresses for unstable residual incongruities. In this study, a transversely isotropic poroelastic cartilage finite element model was implemented and validated within physiologically relevant loading ranges. This material model was then used to simulate the loading of cartilage during stable and unstable motion accompanying a step-off incongruity residual from intra-articular fracture, using load data from previous cadaver tests of ankle instability.