Multifunctional Applications Enabled by Fluorination of Hexagonal Boron Nitride.

2D materials exhibit exceptional properties as compared to their macroscopic counterparts, with promising applications in nearly every area of science and technology. To unlock further functionality, the chemical functionalization of 2D structures is a powerful technique that enables tunability and new properties within these materials. Here, the successful effort to chemically functionalize hexagonal boron nitride (hBN), a chemically inert 2D ceramic with weak interlayer forces, using a gas-phase fluorination process is exploited.

Fatigue of graphene.

Materials can suffer mechanical fatigue when subjected to cyclic loading at stress levels much lower than the ultimate tensile strength, and understanding this behaviour is critical to evaluating long-term dynamic reliability. The fatigue life and damage mechanisms of two-dimensional (2D) materials, of interest for mechanical and electronic applications, are currently unknown. Here, we present a fatigue study of freestanding 2D materials, specifically graphene and graphene oxide (GO).

An Insight into the Phase Transformation of WS upon Fluorination.

The transformation from semiconducting to metallic phase, accompanied by a structural transition in 2D transition metal dichalcogenides has attracted the attention of the researchers worldwide. The unconventional structural transformation of fluorinated WS (FWS ) into the 1T phase is described. The energy difference between the two phases debugs this transition, as fluorination enhances the stability of 1T FWS and makes it energetically favorable at higher F concentration.

Effect of Humidity and Water Intercalation on the Tribological Behavior of Graphene and Graphene Oxide.

In this work, the effect of humidity and water intercalation on the friction and wear behavior of few-layers of graphene and graphene oxide (GO) was studied using friction force microscopy. Thickness measurements demonstrated significant water intercalation within GO affecting its surface topography (roughness and protrusions), whereas negligible water intercalation of graphene was observed. It was found that water intercalation in GO contributed to wearing of layers at a relative humidity as low as ∼30%.

Tribochemical Competition within a MoS/Ti Dry Lubricated Macroscale Contact in Ultrahigh Vacuum: A Time-of-Flight Secondary Ion Mass Spectrometry Investigation.

Controlling and predicting the tribological behavior of dry lubricants is a necessity to ensure low friction, long life, and low particle generation. Understanding the tribochemistry of the materials as a function of the environment is of primary interest as synergistic effects exist between the mechanics, the physicochemistry, and the thermodynamics within a contact. However, in most studies the role of the coating internal contaminants in the process is often discarded to the benefit of a more common approach in which the performances of the materials are compared as a function of different atmospheric pressure environments.

Surface and Mechanical Characterization of Dental Yttria-Stabilized Tetragonal Zirconia Polycrystals (3Y-TZP) After Different Aging Processes.

Yttria-stabilized tetragonal zirconia polycrystals (3Y-TZP) is a ceramic material used in indirect dental restorations. However, phase transformation at body temperature may compromise the material's mechanical properties, affecting the clinical performance of the restoration. The effect of mastication on 3Y-TZP aging has not been investigated.

Ultrafast, sensitive and large-volume on-chip real-time PCR for the molecular diagnosis of bacterial and viral infections.

To control future infectious disease outbreaks, like the 2014 Ebola epidemic, it is necessary to develop ultrafast molecular assays enabling rapid and sensitive diagnoses. To that end, several ultrafast real-time PCR systems have been previously developed, but they present issues that hinder their wide adoption, notably regarding their sensitivity and detection volume. An ultrafast, sensitive and large-volume real-time PCR system based on microfluidic thermalization is presented herein.

New family of fluorinated polymer chips for droplet and organic solvent microfluidics.

We present a new family of microfluidic chips hot embossed from a commercial fluorinated thermoplastic polymer (Dyneon THV). This material shares most of the properties of fluoro polymers (very low surface energy and resistance to chemicals), but is easier to process due to its relatively low melting point. Finally, as an elastic material it also allows easy world to chip connections.

L-alanyl-L-glutamine dipeptide-supplemented total parenteral nutrition reduces infectious complications and glucose intolerance in critically ill patients: the French controlled, randomized, double-blind, multicenter study.

Objective: Glutamine (Gln)-supplemented total parenteral nutrition (TPN) improves clinical outcome after planned surgery, but the benefits of Gln-TPN for critically ill (intensive care unit; ICU) patients are still debated.

Design: Prospective, double-blind, controlled, randomized trial.

Setting: ICUs in 16 hospitals in France.

Optical manipulation of microparticles and cells on silicon nitride waveguides.

We demonstrate the optical manipulation of cells and dielectric particles on the surface of silicon nitride waveguides. Glass particles with 2microm diameter are propelled at velocities of 15microm/s with a guided power of 20mW. This is approximately 20 times more efficient than previously reported, and permits to use this device on low refractive index objects such as cells.

The xenotransplantation of goat and human hematopoietic cells to sheep fetuses.

Hematopoietic xenografts were carried out in three experiments using goat fetal liver (44-48 days, experiments I and II) or purified human CD 34+ cells (experiment III) as the donor cells. Recipients were sheep fetuses at 41-47 days of gestation. Goat fetal liver cells were either injected without any pretreatment or stimulated by preincubation in a culturing in goat phytohemagglutinin-stimulated lymphocyte supernatant.

Improvement of flow cytometry analysis and sorting of bull spermatozoa by optical monitoring of cell orientation as evaluated by DNA specific probing.

Flow cytometry is a potential method for the separation of X and Y bearing spermatozoa, on the basis of their relative DNA content evaluated by the fluorescence emission intensity due to specific fluorochrome DNA staining. However, spermatozoa DNA is highly condensed and nuclei exhibit flat non spherical shape, which can produce artefacts impeding accurate analysis. In order to avoid these limitations, decondensation of DNA performed by enzymatic treatment and a modification of the flow cytometer that orients the spermatozoa relative to the laser beam are generally used.

[Father-male offspring transmission of seasonal variations in testicular diameter and percentage of abnormal sperm in the Ile-de-France ram. 1. Male offspring born in February].

An experiment was conducted on the Ile-de-France (IF) breed to determine if the more or less important sensitivity of the ram to photoperiodism came under genetic control. Five base breed unrelated rams (greater than or equal to 4 yr old), were chosen for this study: 2 good (I and II), 2 bad (III and IV), and an intermediate sire (V). Ram I, which died a few years before the experiment began, was selected on both the low amplitude of its sperm production during a 6-month period of artificial lighting and the very high fertilizing capacity of its sperm in spring.

Photoperiodic and melatonin treatments for the control of seasonal reproduction in sheep and goats.

The control of seasonal reproductive activity in sheep and goats in open sheds, needs extra-light (E) during the photosensitive phase (equivalent to long days, LD), followed by treatment with melatonin (equivalent to short days, SD). In autumn-born Ile-de-France or Lacaune ram lambs, 2 months of E followed by decreasing daylength for 90 days, advanced onset of the first breeding season by allowing males to reach their maximum testis volume and sperm production earlier than for untreated ram lambs. Substitution of decreasing daylength with melatonin implants allowed a transient increase in testis volume.

[Early prediction of the magnitude of seasonal variations in testicular diameter and percentage of abnormal spermatozoa in Ile-de-France rams. 1. Animals born in February].

The aim of this study, conducted in spring born animals, was to analyse if within a group of males of the same age, there is any relationship between the testis diameters (TD) or between the percentages of morphologically abnormal spermatozoa (AS) recorded in the same animal at two periods of its life (be it at two different spring periods or at two stages of its age: ram lamb and adult). Eighteen Ile-de-France ram lambs born in February 1980 and issued from five adult rams whose seasonal variations in TD and AS had been followed for two consecutive years were used in this study. Semen was collected (artificial vagina, 1 ej/male/wk) from October 1980 until December 1983 (slaughter of the animals) every semester during "Periods" (n = 7).

Lamb production using superovulation, embryo bisection, and transfer.

In this study, 39 embryos from donor ewes superovulated with follicle stimulating hormone-pituitary (FSH-P) were bisected to produce pairs of monozygotic twin lambs for experimentation. Each pair obtained by bisecting 8-, 9- or 10-day-old embryos was immediately transferred surgically into a recipient ewe at the same physiological stage. Of the 39 recipients which received a pair of half-embryos by transfer into the uterine horn ipsilateral to the corpus luteum, 28 (72%) lambed.

Transfer of superovulated sheep embryos obtained with different FSH-P.

Embryo transfer is one way of accelerating genetic improvement in sheep. One of the main obstacles has been the production of good-quality embryos. The use of progestagens and the stimulation of ovulation with follicle stimulating hormone pituitary extract (FSH-P) has permitted the superovulation of donor and recipient ewes and the synchronization of their cycles.

[Seasonal variation in the testis diameter and sperm morphology in the Vendean ram and Texel ram].

Nineteen Vendean (V) rams (7 yearlings about 15 months old and 12 adults of greater than 2 years) and 13 Texel (T) adult (greater than 2 years) rams were controlled for body weight (BW), testis diameter (TD) and sperm morphology for two consecutive years (1982 and 1983) from February to June (T) or July (V) and from September to November the first year, from February to June and from September to October the second year. BW was recorded every month. TD was measured once weekly using a caliper.

[Influence of the photoperiod on the production and fecundity of spermatozoa in the adult Ile-de-France ram].

Two groups, A and B, of 5 adult Ile-de-France rams each of the same age were exposed for 52 weeks (October 1975 to October 1976) to an artificial light regime reproducing natural variations of daylength (DL). In group A, DL increased from 8 to 16 h during the first 26 weeks and then decreased. In group B, DL varied in an opposite manner.

[The first cleavage of tubal sheep eggs after fertilization with epididymal or ejaculated spermatozoa].

Prealpes ewes (N = 40) were inseminated with mature (ejaculated or epididymal cauda) or immature (epididymal corpus) spermatozoa deposited in the uterine cavity at the time of an induced ovulation (61 hrs. after PMSG injection). Intratubal eggs, recovered and examined either 38 or 48 hrs.

[Seasonal variations of sperm quality in adult Ile-de-France rams. II. Fertilizing ability and its relation to qualitative criteria in vitro].

Six adult Ile-de-France rams of different origins, registered in a Flock book, were used in AI for three consecutive years on the same flock (IF) in March-April and in September. The animals (males and females) were always kept in a sheep-fold (natural daylight conditions). They received the same feed throughout the whole experiment.