Developing Specific Emission Factors for Natural Gas Driven Pneumatic Devices.

A measurement study was conducted in 2023 to derive operator-specific emission factors for natural gas driven pneumatic devices at onshore production facilities in the United States. A total of 369 intermittent bleed and 26 continuous low-bleed pneumatic devices were measured using a high-volume sampler. Considering all intermittent bleed devices, the emission factor from this study was statistically lower than the factor in the revised Greenhouse Gas Reporting Rule (GHGRP) issued May 6, 2024.

Point Sensor Networks Struggle to Detect and Quantify Short Controlled Releases at Oil and Gas Sites.

This study evaluated multiple commercially available continuous monitoring (CM) point sensor network (PSN) solutions under single-blind controlled release testing conducted at operational upstream and midstream oil and natural gas (O&G) sites. During releases, PSNs reported site-level emission rate estimates of 0 kg/h between 38 and 86% of the time. When non-zero site-level emission rate estimates were provided, no linear correlation between the release rate and the reported emission rate estimate was observed.

Performance of Continuous Emission Monitoring Solutions under a Single-Blind Controlled Testing Protocol.

Continuous emission monitoring (CM) solutions promise to detect large fugitive methane emissions in natural gas infrastructure sooner than traditional leak surveys, and quantification by CM solutions has been proposed as the foundation of measurement-based inventories. This study performed single-blind testing at a controlled release facility (release from 0.4 to 6400 g CH/h) replicating conditions that were challenging, but less complex than typical field conditions.

Investigating detection probability of mobile survey solutions for natural gas pipeline leaks under different atmospheric conditions.

The 2015 Paris agreement aims to cut greenhouse gas emissions and keep global temperature rise below 2 °C above pre-industrial levels. Reducing CH emissions from leaking pipelines presents a relatively achievable objective. While walking and driving surveys are commonly used to detect leaks, the detection probability (DP) is poorly characterized.

A Methane Emission Estimation Tool (MEET) for predictions of emissions from upstream oil and gas well sites with fine scale temporal and spatial resolution: Model structure and applications.

In comparing observation based methane emission estimates for oil and gas well sites to routine emissions reported in inventories, the time scale of the measurement should match the time scale over which the inventoried emissions are estimated. Since many measurements are of relatively short duration (seconds to hours), a tool is needed to estimate emissions over these time scales rather than the annual totals reported in most emission inventories. This work presents a tool for estimating routine emissions from oil and gas well sites at multiple time scales; emissions at well sites vary over time due to changes in oil and gas production rates, operating practices and operational modes at the sites.

Modeling air emissions from complex facilities at detailed temporal and spatial resolution: The Methane Emission Estimation Tool (MEET).

Recent attention to methane emissions from oil and gas infrastructure has increased interest in comparing measurements with inventory emission estimates. While measurement methods typically estimate emissions over a few periods that are seconds to hours in length, current inventory methods typically produce long-term average emission estimates. This temporal mis-alignment complicates comparisons and leads to underestimates in the uncertainty of measurement methods.

Detection Limits of Optical Gas Imaging for Natural Gas Leak Detection in Realistic Controlled Conditions.

Optical gas imaging (OGI) is a commonly utilized leak detection method in the upstream and midstream sectors of the U.S. natural gas industry.

Temporal variability largely explains top-down/bottom-up difference in methane emission estimates from a natural gas production region.

This study spatially and temporally aligns top-down and bottom-up methane emission estimates for a natural gas production basin, using multiscale emission measurements and detailed activity data reporting. We show that episodic venting from manual liquid unloadings, which occur at a small fraction of natural gas well pads, drives a factor-of-two temporal variation in the basin-scale emission rate of a US dry shale gas play. The midafternoon peak emission rate aligns with the sampling time of all regional aircraft emission studies, which target well-mixed boundary layer conditions present in the afternoon.

"Good versus Good Enough?" Empirical Tests of Methane Leak Detection Sensitivity of a Commercial Infrared Camera.

Methane, a key component of natural gas, is a potent greenhouse gas. A key feature of recent methane mitigation policies is the use of periodic leak detection surveys, typically done with optical gas imaging (OGI) technologies. The most common OGI technology is an infrared camera.

Variation in Methane Emission Rates from Well Pads in Four Oil and Gas Basins with Contrasting Production Volumes and Compositions.

Atmospheric methane emissions from active natural gas production sites in normal operation were quantified using an inverse Gaussian method (EPA's OTM 33a) in four major U.S. basins/plays: Upper Green River (UGR, Wyoming), Denver-Julesburg (DJ, Colorado), Uintah (Utah), and Fayetteville (FV, Arkansas).

Improved Mechanistic Understanding of Natural Gas Methane Emissions from Spatially Resolved Aircraft Measurements.

Divergence in recent oil and gas related methane emission estimates between aircraft studies (basin total for a midday window) and emissions inventories (annualized regional and national statistics) indicate the need for better understanding the experimental design, including temporal and spatial alignment and interpretation of results. Our aircraft-based methane emission estimates in a major U.S.