[Comparative evaluation of trabecular bone density in Hounsfield units in the lumbar native CT cross-section for osteoporosis diagnosis and fracture risk determination by different examiners].

Background: An increasing loss of bone mineral density (BMD) in the axial skeleton leads to osteoporosis and fractures, with an increase found in the thoracic and thoracolumbar regions.

Research Question: The extent to which an examiner-independent assessment of the extent of osteoporosis and fracture risk determination is possible by determining the trabecular density in Hounsfield units (HU) in the spine should be examined. The next question was whether quantitative BMD values can be calculated from the HU values.

Interobserver variability in the determination of bone mineral density in Hounsfield units from differently configured fields of measurement in the cancellous bone of vertebral bodies from elderly body donors.

Background: Due to the absence of suitable diagnostic procedures, osteoporosis (OP) is frequently detected late or not at all. Many elderly persons undergo computed tomographies (CT). The routine determination of Hounsfield units (HU) in bone as a part of these examinations could close a gap here.

[Insufficiency fractures of the spine in relation to cancellous bone density : An in vitro study].

Background: The risk of osteoporotic insufficiency fractures (Fx) at the axial skeleton increases with decreasing bone density, with an accumulation in the thoracic and thoracolumbar regions. To better understand the differential distribution of Fx along the spine, morphological and osteodensitometric studies were performed by computed tomography (CT) in the various spine sections. In addition, we aimed to clarify whether Hounsfield units (HU) found on CT examinations from other indications correlate with bone density and could be grounds for osteologic diagnosis.

Breaking strength and bone microarchitecture in osteoporosis: a biomechanical approximation based on load tests in 104 human vertebrae from the cervical, thoracic, and lumbar spines of 13 body donors.

Background: The purpose of the study was to investigate associations between biomechanical resilience (failure load, failure strength) and the microarchitecture of cancellous bone in the vertebrae of human cadavers with low bone density with or without vertebral fractures (VFx).

Methods: Spines were removed from 13 body donors (approval no. A 2017-0072) and analyzed in regard to bone mineral density (BMD), Hounsfield units (HU), and fracture count (Fx) with the aid of high-resolution CT images.

Why Insufficiency Fractures are Rarely Found in the Cervical Spine, Even with Osteoporosis.

Introduction: The human bone structure changes with an increase in age. Both material and structural properties affect bone strength. Despite the ageing of society, however, hardly any data are available on these parameters for elderly individuals.

A comparison, using X-ray micro-computed tomography, of the architecture of cancellous bone from the cervical, thoracic and lumbar spine using 240 vertebral bodies from 10 body donors.

The vertebral trabecular bone has a complex three-dimensional microstructure with an inhomogeneous morphology. Correct identification and assessment of the weakest segments of the cancellous bone may lead to better prediction of fracture risk. The aim of this study was to compare cancellous bone from 240 vertebrae of the cervical, thoracic and lumbar spine of ten body donors with osteoporosis in regard to bone volume fraction (BVF), trabecular thickness, separation, trabecular number and degree of anisotropy, to ascertain why cervical vertebrae rarely fracture, even with severe osteoporosis.